brake AUDI A4 1996 B5 / 1.G 01A Transmission Final Drive Flange Housing Remove Workshop Manual
[x] Cancel search | Manufacturer: AUDI, Model Year: 1996, Model line: A4, Model: AUDI A4 1996 B5 / 1.GPages: 21, PDF Size: 0.49 MB
Page 3 of 21
39-87
- Remove heat shield above driveshaft.
- Remove heat shield next to rear differential.
- Check for factory color marking on driveshaft. If not, mark position of
driveshaft flange -A- to drive flange in rear differential -B- with color
marking.
- Remove mounting bolts from driveshaft flange.
Note:
If driveshaft cannot be pushed upward past flange, tie up driveshaft after
lowering the differential. When lowering driveshaft, protect it from
dropping and note the permissible bend angle of driveshaft Notes,
Page 39
-68
. - Tie driveshaft to mount for parking brake cable using wire.
Pa
ge 3 of 21 Drive flan
ge housin
g, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.11
Page 19 of 21
39-101
Removing
- Remove rear section of exhaust system located
rearward of exhaust pipe clamp(s).
Repair Manual, Engine Mechanical, Repair
Group 26
- Unbolt driveaxles on left and right from rear final
drive and place to side.
Repair Manual, Suspension, Wheels, Brakes,
Steering, Repair Group 42
- To loosen mounting bolts, screw two bolts into drive flange and
counterhold using pry bar.
- Place VAG1306 drip tray underneath and drain oil.
- Remove drive flange using screwed in bolts.
- Pry out drive flange seal using pry bar.
Pa
ge 19 of 21 Drive flan
ge housin
g, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.11