AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install User Guide

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install User Guide A8 1996 D2 / 1.G AUDI AUDI https://www.carmanualsonline.info/img/6/1207/w960_1207-0.png AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install User Guide
Trending: torque, engine, differential, engine oil, automatic transmission, ECU, wheel

Page 11 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install User Guide 37-81
      
All except 2.7 Liter 5V turbo engine: 
     
- Remove starter.
     
       Repair Manual, Electrical Equipment, Repair 
Group 27; Starter, removing and installing
   
     
Disconnect to

Page 12 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install User Guide 37-82
      
All-wheel-drive vehicles  
    
 Repair Manual, Engine Mechanical, Repair Group 26; removing and 
installing exhaust system.    -  Remove heat shield -A- above driveshaft.
-  Remove rear

Page 13 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install User Guide 37-83
      
Continuation for all vehicles 
    
Use 3282/19 adjustment plate to position the 3282 transmission support 
for Automatic Transmission 01V.  
The symbols on the adjustment plate indicate

Page 14 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install User Guide 37-84
 
    
-  Unbolt multi-function Transmission Range (TR) switch -F125- for 
protection against damage (arrows) and expose wiring harness. 
    
-  Mark position of mounting bracket for selector l

Page 15 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install User Guide 37-85
 
    
-  If installed, press off securing brace (arrow) at end of selector lever 
cable. 
    
-  Pry off selector lever cable from lever/shift rod (arrow).
-  Remove upper connecting bolts for

Page 16 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install User Guide 37-86
      
For 6 cylinder TDI engines 
    
Note:  
Illustration depicts engine from rear with the transmission removed. 
Continuation for all vehicles  -  Loosen bolt -A- (at rear of turbocharger)

Page 17 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install User Guide 37-87
 
    
By removing the bolts, the subframe lowers itself approx. 150 mm at rear 
edge  page 37
-88
 , illustration A37-0067.  
 Repair Manual, Engine Mechanical, Repair Group 26; removing and 
i

Page 18 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install User Guide 37-88
 
    
-  Rotate transmission (arrow) and carefully move into position between 
subframe and vehicle floor. 
- Lower transmission.
-  Secure converter so it does not fall out.
Pa
ge 18 of 64 Tra

Page 19 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install User Guide 37-89
      
Installing
 
      Installation is reverse of removal, noting the 
following:  
      Before installing:  
     
All-wheel-drive vehicles  
     
-  Clean threads in driveshaft flange!

Page 20 of 64

AUDI A8 1996 D2 / 1.G 01V Transmission Remove And Install User Guide 37-90
 
    
For 4 cylinder engines (5 valve, turbo) 
Item A = bushings  
    
For 6 cylinder gasoline engines: 
Item A = bushings  
Pa
ge 20 of 64 Transmission, removin
g and installin
g
11/20/2002 h
Page:   < prev 1-10 11-20 21-30 31-40 41-50 51-60 ... 70 next >
Trending: engine, differential, torque, automatic transmission, ECU, engine oil, wheel