jack points AUDI R8 SPYDER 2011 Owners Manual
[x] Cancel search | Manufacturer: AUDI, Model Year: 2011, Model line: R8 SPYDER, Model: AUDI R8 SPYDER 2011Pages: 244, PDF Size: 59.74 MB
Page 220 of 244
218 What do I do n ow ?
-On hard, slippery sur face (such as tiles)
use a rubber mat or similar to prevent
the jack from slipping.
- To help prevent injury to yourself and
your passenge rs:
- Do not raise the vehicle unti l you a re
sure the ja ck is sec urely engaged.
- Passenge rs must not rema in i n the ve
h icl e when it is ja cked up.
- Make sure t hat passengers wait in a
safe p lace away from the vehicle and
well away from the road and traffi c.
- Make sure jack position is correct , ad
just as necessary and then continue to ra ise the jack.
CD Note
A floo r jack or the pads on the hoist arms
m ust
n ot be posit ioned at the points
shown
-arrows-.
Remov ing the wheel
Follow these instructions step-by-step for
changing the wheel.
F ig . 161 Wh eel ch an ge : alignment pin in side the t op
hole
After you have loosened all wheel bolts and
ra ised the vehicle off the ground, perform the
following steps to remove and rep lace the
wheel :
Removing the wheel
" Use the
hexagon al socke t in the screwdri v
e r handle
to comp letely turn out the top
most wheel bolt and set it as ide on a
clean
surface . "
Sc rew the threaded end of the
al ignment
pin
from t he tool kit hand-tight into the
now vacant bolt ho le
c::> fig . 161.
" Then completely unscrew the other wheel
bolts as described above.
" Take off the whee l leaving the a lignment pin
in the bolt hole
c::> (D .
Putting on the wheel
"Lift the spare whee l and carefully s lide it
over the alignment p in to guide it in place
c::> (D .
" Use the hexagonal socket in the screwdriver
ha ndle to screw in and tighten a ll whee l
bolts
slightly .
"Unscrew the alignment p in and inse rt and
tighten the rema ining wheel bolt slightly
like the rest.
" Turn the jack hand le counter-clockwise to
lower the vehicle until the jack is fully re
leased.
T he wheel bo lts must be clean and turn easily.
Check the contact s urfaces of whee l and hub .
Remove contaminants on these surfaces be
fore insta lling the wheel.
T he hexagonal socket in the screwdriver han
dle makes it easier to handle the w heel bo lts.
The reversible blade shou ld be removed .
When mounting
u nidire ctional ti res, observe
the d irection o f rotation
c::> page 216.
CD Note
When remov ing or inst alling the whee l,
t he r im cou ld hi t the b ra ke ro tor and dam
age the rotor . Work caref ully an have a
second person help you.
(D Tips
Never use the he xagonal socket in the han
dle of t he screwdriver to loosen or tighten
the wheel bo lts .