transmission oil AUDI S4 1999 B5 / 1.G 01E Transmission Final Seal Grooved Ball Bearings For Flange Driveshaft Workshop Manual

39-8


7 -
O-ring
Always replace
8 -
Circlip
9 -
Spring plate Mark installation position when removing:
larger diameter (concave side) toward
shims - 10
10 -
Shims
11 -
Spring
12 -
Oil drain plug, 40 Nm
Pa
ge 4 of 10 Seal and
grooved ball bearin
g for flan
ge for driveshaft on transmission, re
placin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.3

39-9

Removing

Transmission installed

- Disconnect driveshaft at the front Page 39
-
68
, lift clear and tie-up on selector linkage.

- Place a drip tray underneath.

- Unscrew rear oil drain plug (on end cover) and
drain transmission oil.

- Unscrew securing bolts for bearing housing.

Note:
Generally, the bearing housing is pressed out via
the spiral spring when loosening bolts from
cover.
If the bearing housing is not pressed off:

- Pull drive flange together with bearing housing and balance weight off
end cover.
A - M8/M10 stud
- Take off bearing housing.
Pa
ge 5 of 10 Seal and
grooved ball bearin
g for flan
ge for driveshaft on transmission, re
placin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.3

39-13


- Lightly oil outer circumference of seal -B-.
- Fill space between sealing lips and dust lips with sealing grease G52
128 A1.
- Fit seal with shim -A-, Part No. 016 311 391 B (1.7 mm thick) onto
punch 2005.
Installation position: open side of seal toward transmission.

- Drive in seal for drive flange.
- Remove shim after driving in.
Pa
ge 9 of 10 Seal and
grooved ball bearin
g for flan
ge for driveshaft on transmission, re
placin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.3

39-14


- Press in drive flange.
- Fit circlip onto drive flange.
- Lightly oil O-ring and fit into bearing housing groove.
- Insert spring plate and shims into bearing housing.
Installation position: Page 39
-8
- Slide coil spring onto drive flange.
- Tighten securing bolts for bearing housing in diagonal sequence and in
stages to 25 Nm.
- Bolt on driveshaft Page 39
-71
.
- Top up oil in transmission and check oil level Page 34
-39
. Pa
ge 10 of 10 Seal and
grooved ball bearin
g for flan
ge for driveshaft on transmission, re
placin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.3