engine coolant BMW Z4 COUPE 2007 E86 Service and warranty information

Maintenance Program
The BMW Maintenance Program has been
devised with the following objectives: to maxi-
mize vehicle safety, reliability, and resale value by
minimizing breakdowns resulting from wear, and
minimizing cost and inconvenience by comput-
ing maintenance intervals based upon the spe-
cific manner in which each individual vehicle is
driven.
Maintenance intervals on motor vehicles have
conventionally been specified based upon
accumulated mileage. However, the type of
driving conditions has a major influence on
routine maintenance requirements; distance
traveled is only one of the significant factors.
A vehicle driven for 50,000 miles of short trips
in the city with numerous cold starts, pro-
longed periods of idling, stop-and-go driving,
and high engine speeds during acceleration
requires more frequent maintenance intervals
than a vehicle driven for 50,000 miles for long
distances at low engine speeds primarily at
operating temperature.
The advanced technologies at BMW have led to
the development of the unique BMW service
interval indicator which computes the actual opti-
mum maintenance requirements based not only
upon the accumulated mileage, but taking into
account important factors such as engine cool-
ant temperatures, high or low engine speeds,
short or long trip driving, and number of vehicle
starts. The maintenance interval may therefore
be maximized with considerable savings to own-
ers of vehicles subjected to light duty.
TheService Interval Indicatorconsists of a
mileage reading, and the inscriptions “OIL SER-
VICE” and “INSPECTION”.
Whenever the ignition is switched on, the display
shows the next scheduled type of service and the
remaining distance until the service should be
performed. The distance is based on your driving
style.If the maintenance interval has been exceeded, a
“--” symbol reminds you of the urgent need for
servicing. In the interests of road safety and reli-
ability,you should avoid driving your BMW
when the “--” symbol is showing,and have the
essential maintenance work performed without
delay.
After each maintenance is performed the service
indicator is reset in order to compute the next
service interval.
If the Service Interval Indicator displays an illogi-
cal reading, or if there is no display, consult a
BMW center.
If the speedometer, tachometer or coolant tem-
perature gauge should develop a fault, the ser-
vice interval indicator will probably cease to
operate correctly as well, since it depends on
correct speed, distance and temperature read-
ings. The fault must be located and rectified by a
BMW center.
A detailed list of all maintenance operations
included in each of the elements of the BMW
Maintenance System is found on pages4-13.
These elements are as follows:
Quality Certification I will be performed by your
selling center and certified on the following page.
The performance of certain subsequent mainte-
nance elements, as required by the BMW New
Vehicle Limited Warranty, will be specified at
intervals computed by the BMW service interval
indicator as follows:
– Oil Service: Engine oil changed with the engine
at operating temperature.
Note: change oil at least once a year.
Your BMW is factory-equipped with a newly-
developed synthetic engine oil. At the time of
the printing of this booklet BMW High-Perfor-
mance Synthetic 5W-30 Oil (Part Number 07
51 0 017 866) and Mobil 1 5W-30 and 5W-40
oils are strongly recommended and approved
by BMW for the BMW Z4 models. BMW is eval-
uating various synthetic oils for inclusion in our
list of recommended motor oils.
BMW recommends that you check engine oil
level whenever fuel is added to your vehicle.
2

– Inspection I: Major vehicle maintenance as
specified in the following pages under Inspec-
tion I.
– Inspection II: Additional major vehicle mainte-
nance as specified in the following pages under
Inspection II.
The following maintenance elements must be
performed at the mileage/time stated (time inter-
vals begin from the vehicle’s production date):
– Brake Fluid Service: Change brake fluid every
two years.
– Oxygen Sensor Service: The oxygen sensor
deteriorates strictly on a mileage basis and
must therefore be replaced every 120,000
miles to maximize vehicle fuel economy and
minimize exhaust pollution. The replacement of
the oxygen sensor is required under the terms
of the applicable BMW emission system
warranties.
– Spark Plug Service: Replace spark plugs every
100,000 miles.
– Automatic Transmission Service: Change ATF
every 100,000 miles.
The engine coolant has a lifetime rating and does
not need to be changed.For your convenience, you may also wish to have
your BMW center perform any necessary opera-
tions to fulfill any state inspection requirements
in your area concurrent with the maintenance
elements specified above during other repairs.
Make sure that confirmation of maintenance
work is always entered in this Service and War-
ranty Information Statement. You may need this
for any warranty claims that become necessary,
and later on as evidence that your car has been
given the correct and regular maintenance that
justifies its resale or trade-in value.
BMW has applied the most modern technologi-
cal advances not only to the design and produc-
tion of your vehicle, but also to computing of the
optimum maintenance interval for your type of
operations and driving style. Your BMW center
has made a substantial investment in unique
BMW special service tools to enable his BMW
factory trained service technicians to perform
quality repairs on your BMW in minimal time.
Your service technician looks forward to serving
your every service need and to help maximize
your satisfaction with your BMW, its longevity,
and resale value.
3

Inspection I
Only those items of inspection work which apply to your vehicle will be performed. This list is subject to
amendment.
Undercarriage
Z4 Roadster 3.0i,
3.0si
Coupe 3.0si
Change oil and oil filter while engine is at normal operating temperature. We
recommend BMW 5W-30 High Performance Synthetic Oil, p/n 07 51 0 017 866.•
Check transmission for leaks.•
Check rear axle for leaks.•
Half-shafts: Check for leaks at flexible boots.•
Visually check fuel tank, lines and connections for leaks.•
Check condition, position, and mounting of exhaust system. Examine for leaks.•
Check steering for absence of play, condition of suspension track rods, front axle
joints, steering linkage and joint disc.•
Check overall thickness of front and rear disc brake pads using special tool. If
replacement is necessary: Examine brake disc surfaces. Clean brake pad contact
points in calipers. Grease wheel centering hubs. Check thickness of parking brake
linings only when replacing rear brake pads. Check brake system connections and
lines for leaks, damage and incorrect positioning.•
Check parking brake actuation. Adjust if necessary.•
Check all tire pressures. Correct if necessary. Check condition of tires (outer
surface [left/right]), tread wear and pattern; in case of uneven tread wear, readjust
wheel alignment if requested (invoice separately).•
Inspect entire body according to terms of rust performation limited warranty. (Must
be performed at least every two years).•
Engine Compartment
Read out diagnostic system.•
Check engine cooling system/heater hose connections for leaks. Check coolant
level and antifreeze protection level. Add coolant if required.•
Check windshield washer fluid level and antifreeze protection. Fill up and/or
correct if required.•
Check air conditioner for operation.•
Replace microfilter (Note: reduce replacement interval in dusty operating
conditions).•
Reset service interval indicator.•
Check brake fluid level. Add fluid if needed•
6

New Vehicle Limited Warranty -
2007 Models (Valid only in the
U.S.A. and Puerto Rico)
Warrantor
BMW NA warrants 2007 U.S. specification vehi-
cles distributed by BMW NA or sold through the
BMW NA European Delivery Program against
defects in materials or workmanship to the first
retail purchaser, and each subsequent purchaser.
Warranty Period
The warranty period is 48 months or 50,000
miles, whichever occurs first.
Warranty Begins
This warranty begins on the date of first retail
sale, or the date the vehicle is first placed in
service as a demonstrator or company vehi-
cle, whichever is earlier.
Warranty Coverage
To obtain service under this warranty, the vehicle
must be brought, upon discovery of a defect in
material or workmanship, to the workshop of any
authorized BMW center, during normal business
hours. The BMW center will, without charge for
parts or labor, either repair or replace the defec-
tive part(s) using new or authorized remanufac-
tured parts. The decision to repair or replace said
part(s) is solely the prerogative of BMW NA. Parts
for which replacements are made become the
property of BMW NA.
In all cases, a reasonable time must be allowed
for warranty repairs to be completed after the
vehicle is received by the BMW center.
Safety Belt Warranty - Kansas
Safety belts are covered under the BMW New
Vehicle Limited Warranty for defects in material
or workmanship for a period of 10 years, unlim-
ited mileage from the date of purchase. In order
to be eligible for this coverage, the vehicle must
be a new car retailed in the State of Kansas and
the repair performed by an authorized BMW cen-
ter in Kansas.
Towing/Other Owner Benefits
A 24-hour Roadside Assistance Program is avail-
able to every BMW owner during the new vehicle
warranty period.
Roadside assistance and other owner benefits
are available by calling:
1 800 332-4269
For additional details on towing and other owner
benefits please refer to the BMW Roadside
Assistance section of this Statement (page 31).
Other Items
Wheel alignment, balancing and wiper blade
inserts are covered up to 2,000 miles.
Items which are subject to wear and tear or
deterioration due to driving habits or condi-
tions, such as brake pads/linings, brake
discs, clutch disc, pressure plate, filters,
upholstery, trim and chrome items, paint fin-
ish, drive belts, glass, and similar items, are
specifically limited to defects in material or
workmanship.
This warranty does not apply to the following:
Damage which results from negligence, improper
operation of the vehicle, improper repair, lack of
or improper maintenance, environmental influ-
ences, flood, accident or fire damage, road salt
corrosion, or use of improper or contaminated
fuel.
Maintenance services and parts when replaced
during maintenance such as spark plugs, lubri-
cants, fluids, engine tuneup parts, replacement
of filters, coolant, and refrigerant.
Failure to maintain the vehicle properly in accor-
dance with the instructions in the Owner’s Man-
ual or the Service section of this Statement, that
results in the failure of any part of the vehicle.
Failure to maintain the vehicle properly in accor-
dance with the instructions in the Owner’s Man-
ual or the Service section of this Statement, that
results in the failure of any part of the vehicle.
35