ECU CHRYSLER 300 2006 1.G Owner's Manual
[x] Cancel search | Manufacturer: CHRYSLER, Model Year: 2006, Model line: 300, Model: CHRYSLER 300 2006 1.GPages: 392, PDF Size: 6.72 MB
Page 219 of 392
A reset feature is available to allow the vehicle to be
driven to a dealer for service. To reset the transmission,
use the following procedure:
1. Stop the vehicle.
2. Move the selector lever to the PARK position.
3. Turn off the engine.
4. Wait approximately 10 seconds.
5. Restart the engine.
6. Move the shift lever to the desired range. If the
problem is no longer detected, the transmission will
return to normal operation.
NOTE:Even if the transmission can be reset, we
recommend that you visit a dealer at your earliest
possible convenience. Your dealer has diagnostic equip-
ment to determine if the problem could recur.Have the transmission checked at your authorized dealer
as soon as possible.
If the problem has been momentary, the transmission can
be reset to regain all forward gears.
Permanent Transmission Limp Home Mode
Permanent Limp Home Mode will be activated if the
transmission enters temporary Limp Home Mode three
times. Follow the reset procedure described under“Tem-
porary Transmission Limp Home Mode”in this section.
In Permanent Limp Home Mode, PARK (P), REVERSE
(R) and NEUTRAL (N) will continue to operate. SEC-
OND gear will operate in the DRIVE (D) shifter position.
The malfunction indicator light may illuminate.
STARTING AND OPERATING 219
5
Page 259 of 392
NOTE:
•
Tighten the gas cap until you hear a“clicking”sound.
This is an indication that the gas cap is properly
tightened. If the gas cap is not secured properly the
Malfunction Indicator Light in the instrument cluster
will turn on. Make sure that the gas cap is tightened
each time the vehicle is refueled.
•When the fuel nozzle“clicks”or shuts off, the fuel
tank is full.
Loose Fuel Filler Cap Message
If the vehicle diagnostic system determines that the fuel
filler cap is loose, improperly installed, or damaged, a
“Check Gascap”message will display in the Electronic
Vehicle Information Center (EVIC)—if equipped. Refer
to“Electronic Vehicle Information Center (EVIC)”in
Section 4 of this manual. Tighten the fuel filler cap
properly and press the odometer reset button to turn the
message off. If the problem continues, the message will
appear the next time the vehicle is started. Refer to
“Onboard Diagnostic System”in Section 7 of this manual
for more information.
WARNING!
•Remove the fuel tank filler tube cap (gas cap)
slowly to prevent fuel spray from the filler neck
which may cause injury.
•The volatility of some gasolines may cause a
buildup of pressure in the fuel tank that may
increase while you drive. This pressure can result
in a spray of gasoline and/or vapors when the cap
is removed from a hot vehicle. Removing the cap
slowly allows the pressure to vent and prevents
fuel spray.
•Never have any smoking materials lit in or near
the vehicle when the gas cap is removed or the
tank filled.
•Never add fuel to the vehicle when the engine is
running.
•A fire may result if gasoline is pumped into a
portable container that is inside of a vehicle. You
could be burned. Always place gas containers on
the ground while filling.
STARTING AND OPERATING 259
5
Page 261 of 392
Overloading
The load carrying components (axle, springs, tires,
wheels, etc.) of your vehicle will provide satisfactory
service as long as you do not exceed the GVWR and front
and rear GAWR.
The best way to figure out the total weight of your
vehicle is to weigh it when it is fully loaded and ready for
operation. Weigh it on a commercial scale to insure that it
is not over the GVWR.
Figure out the weight on the front and rear of the vehicle
separately. It is important that you distribute the load
evenly over the front and rear axles.
Overloading can cause potential safety hazards and
shorten useful service life. Heavier axles or suspension
components do not necessarily increase the vehicle’s
GVWR.
Loading
To load your vehicle properly, first figure out its empty
weight, axle by axle and side by side. Store heavier items
down low and be sure you distribute their weight as
evenly as possible. Stow all loose items securely beforedriving. If weighing the loaded vehicle shows that you
have exceeded either GAWR, but the total load is within
the specified GVWR, you must redistribute the weight.
Improper weight distribution can have an adverse effect
on the way your vehicle steers and handles and the way
the brakes operate.
A loaded vehicle is shown in the illustration. Note that
neither the GVWR or the GAWR capacities have been
exceeded.
STARTING AND OPERATING 261
5
Page 267 of 392
Towing Requirements
To promote proper break-in of your new vehicle driv-
etrain components the following guidelines are recom-
mended:
CAUTION!
•Avoid towing a trailer for the first 500 miles (805
km) of vehicle operation. Doing so may damage
your vehicle.
•During the first 500 miles (805 km) of trailer
towing, limit your speed to 50 mph (80 km/h).
Perform the maintenance listed in Section 8 of this
manual. When towing a trailer, never exceed the GAWR,
or GCWR, ratings.
WARNING!
Improper towing can lead to an injury accident.
Follow these guidelines to make your trailer towing
as safe as possible:
Make certain that the load is secured in the trailer
and will not shift during travel. When trailering
cargo that is not fully secured, dynamic load shifts
can occur that may be difficult for the driver to
control. You could lose control of your vehicle and
have an accident.
•When hauling cargo or towing a trailer, do not over-
load your vehicle or trailer. Overloading can cause a
loss of control, poor performance or damage to brakes,
axle, engine, transmission, steering, suspension, chas-
sis structure or tires.
•Safety chains must always be used between your
vehicle and trailer. Always connect the chains to the
frame or hook retainers of the vehicle hitch. Cross the
chains under the trailer tongue and allow enough
slack for turning corners.
STARTING AND OPERATING 267
5
Page 277 of 392
Jack Location/Spare Tire Stowage
The jack and spare tire are both stowed under an access
cover in the trunk. Follow these steps to access the jack
and spare tire.
NOTE:The spare tire must be removed in order to
access the jack.
•Open the trunk.
•Lift the access cover using the pull strap.
•Remove the fastener securing the spare tire.
Opening The Access Panel
Spare Tire Fastener
WHAT TO DO IN EMERGENCIES 277
6
Page 278 of 392
•Remove the spare tire.
•Remove the fastener securing the jack.
Jacking and Changing a Tire
1. Block the wheel diagonally
opposite the flat tire. Passengers
should not remain in the vehicle
when the vehicle is being jacked.2. Remove the spare tire, jack and lug wrench.
3. Before raising the vehicle, use lug wrench to carefully
pry off wheel cover (if equipped with steel wheels) or
center cap (if equipped with aluminum wheels).
Jack Fastener
Center Cap Removal
278 WHAT TO DO IN EMERGENCIES
Page 317 of 392
Pay particular attention to those hoses nearest to high
heat sources such as the exhaust manifold. Inspect hose
routing to be sure hoses do not come in contact with any
heat source or moving component which may cause heat
damage or mechanical wear.
Insure nylon tubing in these areas has not melted or
collapsed.
Inspect all hose connections such as clamps and cou-
plings to make sure they are secure and no leaks are
present.
Components should be replaced immediately if there is
any evidence of wear or damage that could cause failure.
Brakes
In order to assure brake system performance, all brake
system components should be inspected periodically.
Suggested service intervals can be found in the Mainte-
nance Schedules section of this manual.
WARNING!
Riding the brakes can lead to brake failure and
possibly an accident. Driving with your foot resting
or riding on the brake pedal can result in abnormally
high brake temperatures, excessive lining wear, and
possible brake damage. You wouldn’t have your full
braking capacity in an emergency.
Brake And Power Steering Hoses
When the vehicle is serviced for scheduled maintenance,
inspect surface of hoses and nylon tubing for evidence of
heat and mechanical damage. Hard and brittle rubber,
cracking, tears, cuts, abrasion, and excessive swelling
indicate deterioration of the rubber. Particular attention
should be made to examining those hose surfaces nearest
to high heat sources, such as the exhaust manifold.
Insure nylon tubing in these areas has not melted or
collapsed.
Inspect all hose connections such as clamps and cou-
plings to make sure they are secure and no leaks are
present.
MAINTAINING YOUR VEHICLE 317
7
Page 344 of 392
License Light
1. Remove the screws securing the light to the rear fascia.
2. Remove the bulb and socket assembly and pull the
bulb from the socket.
3. Replace the bulb and reinstall the bulb and socket
assembly.
4. Reattach the light to the rear fascia.
FLUIDS AND CAPACITIES
U.S. Metric
Fuel (approximate)
2.7 Liter Engines (87 Octane) 18 gal-
lons68 liters
3.5 Liter Engines (87 to 89 Oc-
tane)18 gal-
lons68 liters
5.7 Liter Engines (87 to 89 Oc-
tane)19 gal-
lons72 liters
Engine Oil-With Filter
2.7 Liter Engines (SAE 5W-20,
API Certified)6.0 qts. 5.7 liters
3.5 Liter Engines (SAE 10W-30,
API Certified)6.0 qts. 5.7 liters
5.7 Liter Engines (SAE 5W-20,
API Certified)7.0 qts. 6.6 liters
344 MAINTAINING YOUR VEHICLE
Page 374 of 392
ABS (Anti-Lock Brake System)............. 225
Adding Engine Coolant (Antifreeze)......... 314
Adding Fuel.......................... 257
Adding Washer Fluid..............109,110,310
Additives, Fuel........................ 255
Adjustable Pedals....................... 98
Air Conditioner Maintenance.............. 307
Air Conditioning....................... 192
Air Conditioning Filter................202,308
Air Conditioning, Operating Tips........... 203
Air Conditioning Refrigerant.............. 308
Air Conditioning System................. 192
Air Pressure, Tires...................... 244
Airbag................................ 39
Airbag Deployment....................43,49
Airbag Light....................44,51,61,144
Airbag Maintenance...................... 50
Airbag, Side........................... 47
Airbag, Window (Side Curtain)...........40,47
Alarm System (Security Alarm)............. 25
Alignment and Balance.................. 250
All Wheel Drive (AWD)...............229,321
Alterations/Modifications, Vehicle............ 7Antenna, Satellite Radio.................. 185
Antifreeze (Engine Coolant)............313,344
Disposal............................ 315
Anti-Lock Brake System (ABS)............. 225
Anti-Lock Warning Light................. 144
Anti-Theft Security Alarm (Theft Alarm)...... 25
Appearance Care....................... 321
Auto Down Power Windows............... 27
Auto Up Power Windows................. 28
Automatic Dimming Mirror................ 67
Automatic Door Locks..................17,18
Automatic Headlights................... 103
Automatic Temperature Control (ATC)....... 196
Automatic Transmission............210,215,320
Adding Fluid.....................320,347
Fluid and Filter Changes................ 320
Fluid Change........................ 320
Fluid Level Check..................... 320
Fluid Type.......................... 347
Gear Ranges......................... 211
Torque Converter..................... 214
Automatic Transmission Limp Home Mode . . . 214
Autostick..........................217,222
374 INDEX
Page 384 of 392
Rear Folding......................... 94
Reclining............................ 91
Security Alarm (Theft Alarm)............... 25
Selection of Coolant (Antifreeze).........313,346
Self-Sealing Tires....................... 229
Sentry Key (Immobilizer).................. 12
Service Assistance...................... 366
Service Contract........................ 368
Service Engine Soon Light
(Malfunction Indicator).................. 149
Service Manuals........................ 369
Setting the Clock..............162,166,172,188
Settings, Personal....................... 158
Shift Speeds........................... 210
Shoulder Belt Upper Anchorage............. 36
Side Airbag............................ 47
Signals, Turn.......................... 143
Slippery Surfaces, Driving On............. 284
SmartBeams........................... 104
Snow Chains (Tire Chains)................ 251
Snow Tires............................ 252
Spare Tire.......................246,247,277
Spark Plugs........................... 303Speed Control (Cruise Control)............. 119
Speedometer.......................... 143
Starting.............................. 208
Engine Fails to Start................... 209
Starting and Operating................... 208
Steering
Linkage............................ 309
Power...........................228,309
Tilt Column....................... 111,112
Wheel, Tilt....................... 111,112
Steering Wheel Mounted Sound System
Controls............................ 189
Storage...........................135,332
Storage, Vehicle.....................202,332
Storing Your Vehicle..................... 332
Sun Roof............................. 128
Sunglasses Storage...................... 122
Supplemental Restraint System - Airbag....... 39
System, Navigation..................... 188
Tachometer........................... 143
Telescoping Steering Column........... 111,112
Temperature Control, Automatic (ATC)....... 196
384 INDEX