wiper blades FORD AEROSTAR 1996 1.G Owners Manual

111
*
[SC05000(ALL)02/95]
To set the interval wipers, rotate the knob at the
end of the turn signal lever toward or away
from the instrument panel to the interval
operation you desire.
*
[SC05200(ALL)08/95]
To clean the windshield, push in the end of the
wiper knob. For a constant spray, keep the knob
pushed in. After you release the knob, the
wipers operate for two to three cycles before
turning off (if wipers were off) or returning to
the selected setting.
[SC05250(ALL)06/95]
NOTE: The addition of shields to the front of
the vehicle (e.g., bug shields) may
adversely affect the windshield washer
system from delivering fluid to the
windshield. Devices such as bug
shields are not recommended for your
Ford vehicle.
*
[SC05300(ALL)01/95]
Do not try to clean the windshield when the
washer fluid container is empty or activate the
washers at any time for more than 15 seconds
continuously. This could damage the washer
pump system.
*
[SC05400(ALL)01/93]
RWARNING
In freezing weather, the washer solution
may freeze on the windshield and obscure
your vision. Always warm up the
windshield with the defroster before you
use the washer fluid. If you cannot see
through the windshield clearly, it can
increase the risk of being involved in a
collision.
*
[SC005450(ALL)07/95]
For information about refilling the washer fluid
or replacing your windshield wiper blades, see
Windshield washer fluid and Wipersin the Index.
File:07cpsca.ex
Update:Tue Aug 29 17:38:34 1995

292 %
*
[SV23850(ALL)01/95]
Use specially formulated windshield washer
fluid rather than plain water, because specially
formulated washer fluids contain additives that
dissolve road grime. For safety reasons, washer
fluids containing an appropriate antifreeze such
as methanol should be used in freezing weather
(temperatures below32ÊF [0ÊC]).State or local
regulations on Volatile Organic Compounds
(VOC's) may restrict use of the most common
antifreeze, methanol. Washer fluids containing
non-methanol antifreeze agents should be used
only if they provide cold weather protection
without damaging the vehicle's paint finish,
wiper blades, and windshield washer system.
*
[SV23900(ALL)10/89]
If you choose to use a windshield washing
solution that must be mixed, follow the
manufacturer's mixing instructions. Improperly
mixed solutions may freeze unexpectedly.
*
[SV24300(ALL)03/90]
Checking/adding the washer fluid for the
liftgate
[SV24400(ALL)03/95]
Check the liftgate washer reservoir regularly.
This is not the same reservoir your front
windshield wipers use. The opening for this
reservoir is on the right side of the liftgate above
the tail lamp. A fill cup is located on top of the
right hand tail lamp and is accessible when the
liftgate is open. Close the fill cup cover after
filling and before closing the liftgate. Refill this
reservoir with the same solution you use for
your windshield. To find out how much washer
fluid the liftgate reservoir holds, seeRefill
capacitiesin the Index.
File:15cpsva.ex
Update:Tue Aug 29 17:51:51 1995

293 [SV24450(ALL)12/91]
one third page art:0020362-B
Liftgate window washer reservoir
%*
[SV24500(ALL)03/95]
Wiper Blades
*
[SV24600(ALL)03/95]
Check the windshield wiper blades at least twice
a year. Also check them whenever they seem
less effective than usual. Substances such as tree
sap and some hot wax treatments used by
commercial car washes reduce the effectiveness
of wiper blades.
*
[SV24700(ALL)03/95]
If the blades do not wipe properly, clean both
the windshield and the wiper blades. Use
undiluted windshield washer solution or a mild
detergent. Rinse thoroughly with clear water. Do
not use fuel, kerosene, paint thinner, or other
solvents to clean your wiper blades. These will
damage your blades.
*
[SV24800(ALL)03/95]
To make reaching the wiper blades easy, simply
turn the ignition to the ACC position and turn
your wipers on. Wait for them to reach a
vertical position and turn the ignition to the OFF
position. Do not move the wipers manually.
Manually moving the wipers across the
windshield may damage them.
File:15cpsva.ex
Update:Tue Aug 29 17:51:51 1995

294
*
[SV24900(ALL)03/01]
Wiper blade replacement
*
[SV25000(ALL)07/95]
If the wiper blades still do not work properly
after you clean them, you may need to replace
the wiper blade assembly or the blade element.
When replacing the wiper blade assembly, blade
refill, or wiper arm always use a Motorcraft part
or equivalent. To replace the blades, follow the
instructions that come with them.
%
*
[SV25200(ALL)03/95]
Tires
*
[SV25300(ALL)03/95]
Look at your tires each time you fill your fuel
tank. If one tire looks lower than the others,
check the pressure in all of them. Always follow
these precautions:
*
[SV25400(ALL)03/95]
q
Keep your tires inflated to the recommended
pressures.
*
[SV25500(ALL)02/95]
q
Stay within the recommended load limits (see
Load limitsin the Index).
*
[SV25600(ALL)02/95]
q
Make sure the weight of your load is evenly
distributed.
*
[SV25700(ALL)10/89]
q
Drive at safe speeds.
[SV25750(ALL)08/95]
q
Make sure the spare tire is mounted and
anchored properly in the tire carrier without
contacting functional parts such as brake
tubes, fuel lines, exhaust pipes, etc.
*
[SV25800(ALL)01/95]
If you do not take these precautions, your tires
may fail or go flat.
*
[SV25890(ALL)07/95]
Ford Motor Company recommends obeying
posted speed limits.
File:15cpsva.ex
Update:Tue Aug 29 17:51:51 1995

Index 379
Windshield, washing.......... 110
Windshield washer fluid and wipers . . . 110
checking and adding fluid....... 291
checking and replacing wiper blades . . 293
liftgate reservoir........... 291
operation.............. 110
reservoir............... 291
specifications...........292, 338
variable interval wipers........ 110
Windshield wipers and washer...... 110
Wrecker towing............. 243
File:cpixa.ex
Update:Tue Aug 29 17:47:05 1995