wheel size FORD AEROSTAR 1997 1.G Owners Manual

177
*
[GF15000(ALL)05/96]
Forced Downshifts
[GF15100(ALL)06/96]
To gain acceleration inj(Overdrive) or Drive
(Overdrive off) when passing another vehicle,
push the accelerator to the floor. The
transmission will downshift to the appropriate
gear: fourth, third, second or first gear.
%
*
[GF15600(ALL)05/96]
Traction-Lok Rear Axle
(If equipped)
*
[GF15700(ALL)05/96]
This axle provides added drive away traction on
slippery surfaces, particularly when one or more
wheels are on a surface with poor traction.
*
[GF15800(ALL)03/96]
Extended use of other than matching size tires
on a Traction-Lok rear axle could result in a
permanent reduction in effectiveness. This loss of
effectiveness does not affect normal driving and
should not be noticeable to the driver.
[GF16005(ALL)01/96]Electronic 4-Wheel Drive (E-4WD)
(If equipped)
[GF16015(ALL)01/96]
If your vehicle is equipped with the E-4WD
option, power is provided to all four wheels
whenever you press the accelerator pedal. It
improves both handling and traction during
difficult driving conditions, adjusting
automatically to your driving needs. Because the
entire E-4WD system is controlled by a
microprocessor, your vehicle is not equipped
with the switch or shift lever used with most
traditional 4WD vehicles. The microprocessor
does all the adjusting for you.
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996

178 [GF16025(ALL)01/96]How the Electronic 4-Wheel Drive (E-4WD)
System Works
[GF16036(ALL)01/96]
Under normal driving conditions, when the road
is firm, dry and level, the engine power is
distributed one-third to the front axle and
two-thirds to the rear axle. However, if a wheel
begins to slip, the microprocessor will sense this
condition and signal the system to transmit more
power to the axle with more traction. (You may
feel a momentary surge of power.)
[GF16046(ALL)01/96]
NOTE: The microprocessor is disabled when
the brakes are applied or when the
transmission selector is in the P (Park)
or N (Neutral) positions.
[GF16055(ALL)01/96]
Driving Your Electronic 4-Wheel Drive
(E-4WD) Vehicle
[GF16065(ALL)01/96]
Since your E-4WD vehicle is unique, follow these
steps to be safe:
[GF16075(ALL)01/96]
q
Avoid unnecessary turns or other maneuvers
that could cause loss of control and possible
injury.
[GF16076(ALL)01/96]
q
Use the same size and type of tire and wheel
as originally provided for your vehicle and
inflate the tires to the manufacturer's
recommended air pressure.
[GF16077(ALL)01/96]
q
Become familiar with your vehicle's operating
characteristics and study this Owner Guide
for specific operating instructions. Be sure all
occupants wear the safety belts provided.
Drive cautiously, defensively, and at speeds
safe for current road conditions.
File:09cpgfa.ex
Update:Wed Jun 5 12:04:06 1996

210 %
*
[ER04000(ALL)02/96]
The Temporary Spare Tire
%*
[ER04100(ALL)02/96]
You may have a high pressure temporary spare
tire. This spare tire is smaller than a regular tire
and is designed for emergency use only. Use it
only when you get a flat tire and replace it as
soon as you can. This spare tire is marked with
the words ªTEMPORARY USE ONLYº so that
you can easily identify it.
*
[ER04200(ALL)02/96]
RWARNING
If you use the temporary spare tire
continuously or do not follow these
precautions, the tire could fail, causing
you to lose control of the vehicle, possibly
injuring yourself or others.
[ER04250(ALL)01/96]
RWARNING
The tire size on the E-4WD must be
maintained.
[ER04260(ALL)01/96]
Your vehicle may have a full diameter mini
spare or a full size tire. This full diameter mini
spare is special for the E-4WD and another mini
spare from another vehicle can not be
substituted without the possibility of damage to
your vehicle. All tires should be inflated to the
manufacturer's recommended pressures.
*
[ER04275(ALL)05/96]
RWARNING
To avoid injury, never run the engine
with one wheel off the ground, such as
when changing a tire.
*
[ER04280(ALL)01/96]
Extended use of other than matching size spare
tires on a Traction-Lok axle could result in a
permanent reduction in effectiveness. This loss of
effectiveness does not affect normal driving and
should not be noticeable to the driver.
File:10cpera.ex
Update:Thu Jun 6 14:45:00 1996

221 % [ER22400(ALL)04/96]
quarter page art:0020312-B
Lug nut tightening sequence
*
[ER23400(ALL)01/96]
RWARNING
Never use wheels or lug nuts different
than the original equipment as this could
damage the wheel or mounting system.
This damage could allow the wheels to
come off while the vehicle is being
driven.
*
[ER23500(ALL)01/96]
7. Replace any wheel covers, ornaments, or hub
caps that your vehicle has. Make sure that
they are screwed or snapped into place.
[ER23625(ALL)01/96]
8. Put the tire, jack, and wrench away. Make
sure jack is securely fastened so it doesn't
rattle when you drive. The carrier is
designed to hold the temporary spare which
comes with your vehicle. The stowage of a
full size tire in the spare tire carrier may
damage the tire or the vehicle. The flat full
size tire should be stowed securely in the
vehicle until it can be repaired.
*
[ER23700(ALL)03/96]
9. Unblock the wheels.
*
[ER23800(ALL)03/96]
Retighten the wheel lug nuts to the specified
torque at 500 miles (800 km) of new vehicle
operation and at intervals specified in the
Maintenance Schedulebooklet.
File:10cpera.ex
Update:Thu Jun 6 14:45:00 1996

253
*
[MC25900(ALL)03/96]
RWARNING
Driving too fast for conditions creates the
possibility of loss of vehicle control.
Driving at very high speeds for extended
periods of time may result in damage to
vehicle components.
%*
[MC26100(ALL)03/96]
At least once a month, check the pressure in all
your vehicle's tires, including the spare. Use an
accurate tire pressure gauge. Check the tire
pressure when tires are cold, after the vehicle
has been parked for at least one hour or has
been driven less than 3 miles (5 km). You can
find proper cold pressure and load limits of
recommended size tires on the Safety
Compliance Certification Label.
*
[MC26150(ALL)01/96]
RWARNING
Improperly inflated tires can affect vehicle
handling and can fail suddenly, possibly
resulting in loss of vehicle control.
%*
[MC26200(ALL)01/96]
Tire Inspection and Maintenance
*
[MC26300(ALL)03/96]
Inspect the tire treads, and remove stones, nails,
glass or other objects that may be wedged in the
tread grooves. Check for holes or cuts that may
permit air to leak from the tire, and make the
necessary repairs.
*
[MC26400(ALL)03/96]
Inspect the tire side walls for cuts, bruises and
other damage. If you suspect internal damage to
the tire, have it demounted and checked. You
may need to repair or replace it.
[MC26410(ALL)01/96]
Wheel inspection and maintenance
*
[MC26420(ALL)03/96]
Check for damage that would affect the runout
of the wheels. Wobble or shimmy will eventually
damage the wheel bearings.
File:11cpmca.ex
Update:Fri Jun 7 14:30:56 1996

256
*
[MC27000(ALL)03/96]
If your vehicle has aluminum wheels, you may
demount the full size, non-temporary spare
tire (if so equipped) and remount on an
aluminum wheel to rotate the spare tire into
your vehicle's rotation pattern. Rebalance the
wheel.
[MC27100(ALL)04/96]
You may discover uneven outside shoulder wear
on your vehicle's front radial tires if you drive
often in the city and turn frequently around
curbs. You can extend the life of your front tires
by remounting them so the outside of the tire
faces inside on the wheel rim.
%*
[MC27300(ALL)01/96]
Replacing the Tires
*
[MC27400(ALL)01/96]
Replace any tires that show wear bands. When
your tire shows a wear band, it has only 1/16
inch (2 mm) of tread left.
*
[MC27500(ALL)01/96]
quarter page art:0060006-A
Wear band
*
[MC27600(ALL)02/96]
Because your vehicle's tires may wear unevenly,
you may need to replace them before a wear
band appears across the entire tread.
*
[MC27700(ALL)03/96]
Your wheels and tires are match-mounted for
improved ride. Before you begin to repair a tire,
mark the wheel and tire so that they are
properly aligned when remounted. This will
ensure that the tires will continue to give you
the same ride level.
File:11cpmca.ex
Update:Fri Jun 7 14:30:56 1996

259 %
*
[MC28800(ALL)03/96]
Wheel and Tire Matching
*
[MC28950(ALL)03/96]
See an authorized tire dealer for proper
servicing procedures. Wheels and tires must be
properly removed, matched and remounted to
maintain the best possible ride.
%*
[MC31100(ALL)01/96]
Snow Tires and Chains
*
[MC31200(ALL)03/96]
The tires on your vehicle have all-weather treads
that provide traction in rain or snow. However,
during the winter months in some climates, you
may need to use snow tires and occasionally
chains for your tires.
*
[MC31300(ALL)01/96]
RWARNING
Snow tires must be the same size and
grade as the tires you currently have on
your vehicle.
*
[MC31400(ALL)01/96]
Do not use chains when using a temporary
spare. For full size tires, use chains on the tires
only in an emergency or if the law requires
them where you live. When you use the tire
chains:
*
[MC31500(ALL)01/96]
q
Make sure the chains are the right size for
your tires. Use only SAE Class ªSº chains.
Other types may damage your vehicle.
*
[MC31550(ALL)01/96]
q
Tire chains may scratch or chip aluminum
wheels. IT IS RECOMMENDED THAT TIRE
CHAINS ARE INSTALLED ON STEEL
WHEELS ONLY. Be sure to remove wheel
covers (if equipped) from steel rims before
using tire chains to avoid scratches or
damage.
*
[MC31575(ALL)01/96]
q
Local regulations may prohibit or restrict the
use of tire chains. Investigate the laws and
regulations in your area before installing
chains.
File:11cpmca.ex
Update:Fri Jun 7 14:30:56 1996