remote start FORD EXPLORER 2016 5.G Quick Reference Guide

1617*if equipped*if equipped
CONVENIENCE
KEYLESS TRANSMITTER ICONS*
• Press once to lock all doors.
Press again within three seconds
to confirm all doors are locked.
• Press
once to unlock the driver’s
door. Press again within three
seconds to unlock all doors.
• Press
to start the panic alarm.
Press again or switch on the ignition
to stop the alarm.
• Press
twice within three
seconds to open the liftgate.
• Car finder: Press
twice within
three seconds to locate your
vehicle. The horn sounds and
the direction indicators flash.
INTELLIGENT ACCESS*
NOTE: Your intelligent access
transmitter must be within 3 feet
(1 meter) of the vehicle for intelligent
access to function properly.
To unlock and open the door, pull the
front exterior door handle. The unlock
sensor is on the back of the handle.
Make sure not to touch the lock sensor
area on the front of the handle.
To lock the doors, press and hold the
door handle lock sensor for about a
second. To avoid unlocking the door
inadvertently, make sure you only touch
the lock sensor and not other areas of
the door handle.
To unlock and open the liftgate, press
the exterior release button on top of
the liftgate pull-cup handle.
See your Owner’s Manual for more
information.
REMOTE START*
Remote start allows you to start the
engine from outside your vehicle using
your key. To start, press
and then
press twice within three seconds.
Your vehicle will run for 5, 10, or 15
minutes, depending on the setting.
See the Information Displays chapter
in your Owner’s Manual to select the
duration of the remote start system.
Once inside, switch the ignition on as
you normally would before driving. To
switch the engine off from outside the
vehicle after using your remote start,
press
once.
REMOTE CONTROL FEEDBACK
An LED on your transmitter provides
visual feedback from your remote start
or stop commands:
Solid Green: Remote start successful.
The light remains on for a short time
and then goes out.
Solid Red: Remote stop successful,
vehicle off. The light remains on for a
short time and then goes out.
Blinking Red: Remote start or stop
failed. The light blinks a few times and
then stops.
Blinking Green: Waiting for status
update. The light blinks a few times
and then stops.
110-VOLT AC POWER POINT* The power point
is located on
the rear of the
center console
and can be used
to power your
smaller electrical
devices that do
not exceed 150
watts. You can use this feature after
you switch your ignition on and the
battery voltage is above 11 volts. When
the indicator light is on, the power point
is working and ready to use.
POWER LIFTGATE*
Your liftgate has an automatic open
and closing feature. To open remotely,
press
twice on your transmitter
within three seconds. Press twice
again to close or reverse the movement.
To use the power feature from the
driver seat, press the
control
located on the instrument panel.
You can also program a new liftgate
height by opening the liftgate, adjusting
the liftgate manually to your desired
height and then pressing and holding
the liftgate control button. The system
sounds a tone once it saves the new
liftgate height.
HANDS-FREE LIFTGATE OPERATION*
To Open Your Liftgate Hands-Free While You Are at the Liftgate
1. Make sure you have an intelligent access transmitter*
within 3 feet (1 meter) behind the liftgate.
2. Move your foot under and away from the rear bumper
using a single kicking motion. Do not move your foot
sideways or the sensors may not detect the motion.
DUAL-PANEL MOONROOF AND POWER SUNSCREEN*
Use the one-touch, express-opening and express-closing
feature to control various functions. To open, press and
release the SLIDE control. The sunscreen opens
automatically and the moonroof opens to the first position.
To open the moonroof fully, press and release the SLIDE
control again. To close, pull and release the SLIDE control.
Press and release the TILT control to vent the moonroof.
Pull and release the TILT control to close the moonroof.
To open the sunscreen, press and release
. Pull and
release to close the sunscreen.
SMART-CHARGING USB PORT*
Plug in, charge and listen to your playlists, or just use the
smart-charge feature to power up your USB devices.
*if equipped