length Lancia Ypsilon 2001 Owner handbook (in English)

24
G
The webbing must not be
twisted. The upper section
must pass across the
shoulder and chest diagonally. The
lower part must fit closely across
the passengers’ hips and not the
abdomen, to prevent them sliding
forward (fig. 20). Do not use clips,
fasteners, etc. to prevent the belt
adhering to the passenger’s body.
Make sure all seat belts
(both front and back) are
fastened at all times! You
increase the risk of serious injury
or death in a collision if you travel
with the belts unfastened even if
your car is fitted with the airbag
system.
fig. 20
P4C00068
GENERAL INSTRUCTIONS
FOR THE USE OF THE SEAT
BELTS
The driver is responsible for re-
specting and making sure the passen-
gers respect the local rules on the use
of seat belts. USING THE REAR CENTRAL
SEAT BELT(fig. 19)
To fasten the seat belt: push the
tongue of fastener Ainto slot Bof the
buckle until you hear it click.
To unfasten the seat belt: press
buttonC.
To adjust the seat belt: slide the
webbing through adjuster D, pulling
endEto shorten it and length Fto
lengthen it.
IMPORTANTThe belt is adjusted
properly when it fits closely across the
hips.
fig. 19
P4C00067
4C001-067 ING 11-03-2008 11:57 Pagina 24

100
G
7)Lower the car and re-
move the jack.
8)Tighten up the bolts com-
pletely in the order given previously in
(fig. 5).
9)Fit the wheel cover (LS version)
making sure that the inflation valve
seat is positioned correctly; press the
cover with the palm of your hands (do
not bang) against the rim shoulder
and ensure that all the retaining flaps
are inserted into the rim.
When you have finished:
– Put the space-saver spare
wheel into its special recess in
the boot.
– Refit the jack in its support mak-
ingA (fig. 7)coincide with the ring B
on the jack and positioning the base
of the jack to match C.
– Refit the tools you used on the sup-
port.
– Arrange the support and close the
fastenerA (fig. 8).
IMPORTANTCheck the inflation
pressure of the tyres and the spare
wheel regularly.
fig. 9
P4C00301
IMPORTANTIf the type of wheel is
to be changed (alloy wheels in place
of steel wheels and vice-versa) all the
wheel bolts must be replaced with
others of a suitable length and a spe-
cific spare wheel employed with dif-
ferent construction characteristics.
The original wheel bolts though,
should be kept in case you wish to
change back to the original wheels at
a later date.
To unscrew/screw the inflation valve
cap, use extension F (fig. 2).
4C090-119 ING 11-03-2008 12:00 Pagina 100

133
G
USEFUL ADVICE
FOR LENGTHENING
THE LIFE OF YOUR BATTERY
When you park the car, ensure the
doors, boot and bonnet are closed
properly. The ceiling and map-read-
ing lights must be off.
Do not leave accessories (e.g. radio,
hazard lights, etc.) switched on for a
long time when the engine is not run-
ning.
IMPORTANTIf the battery is left
with a charge of less than 50% for a
long time it will be damaged by sul-
phation, engine startup will deterio-
rate and it will be more subject to
freezing (this may occur at –10°C).
If the car is to be inactive for a long
period of time, refer to the “Storing
the car” paragraph in the “Driving
your car” section.
The liquid in the battery
is poisonous and corrosive.
Do not let it touch the skin
or eyes. Do not bring naked flames
or possible sources of sparks near
to the battery: fire and explosion
risk.
Incorrect fitting of elec-
trical and electronic ac-
cessories can seriously
damage the car.
IMPORTANTWhen removing/in-
stalling the battery, make sure the
battery is mechanically secured cor-
rectly.
Running the car with the
fluid level too low could
damage the battery beyond
repair, even breaking the casing
and allowing the acid contained in
it to leak out completely.
Always wear goggles to
protect the eyes when
working on or near the
battery.
If the car is to remain un-
used for a long period in
very cold weather, remove
the battery and keep it in a warm
place, otherwise it could freeze.
CHECKING THE BATTERY
FLUID LEVEL (electrolyte)
Check the electrolyte level and top
up, if required, at the frequency
shown in the Service Schedule in this
chapter. Have this operation carried
out at a LANCIA Dealership.
4C120-143 ING 11-03-2008 12:01 Pagina 133