steering wheel adjustment Lexus IS300 2005 Scheduled Maintenance Guide / LEXUS 2005 IS300 OWNER'S MANUAL (OM53489U)

SVPC012
Power Type
Manual Type
PICTORIAL INDEX
xvi
SEAT AND STEERING WHEEL
Page
1Tilt steering adjustmentlever 180 . . . . . . . . . . . . . . . . . . . . . . . . .
2Seat position, seat cushion
angle and height control switch 97, 98 . . . . . . . . . . . . . . . . . . . . . .
3Seatback angle control switch 97 . . .
4Seat position lock release
lever 102 . . . . . . . . . . . . . . . . . . . . . . . . .
5Seat cushion front edge angle
adjusting knob 103 . . . . . . . . . . . . . . . .
6Seat cushion height adjusting
knob 103 . . . . . . . . . . . . . . . . . . . . . . . . .
7Seatback lock release lever 102 . . . .
For detailed information, refer to the description given in each section.
04 06.30

OCCUPANT RESTRAINT SYSTEMS
178If any driving position memory switch is pushed while one of
the memorized driving position profiles is being activated, the
operation will stop.
To activate the system, push the desired button (ª1º or ª2º)\
again.
The driving position memory control system cannot be
operated while the vehicle is moving.
If the vehicle's battery is disconnected, the computer's
memory will be erased and the memorized positions will have
to be set again.
CAUTION

Do not start the vehicle while the adjustments are
being made.
 Take care not to select the wrong button, or the seat
could strike the rear passenger or hit your body
against the steering wheel. If this happens, you can
stop the movement by pressing another driving
position memory switch.
04 06.30

STEERING WHEEL AND MIRRORS
185
NOTICE
Do not put magnets or a metal object near the inside rearview mirror. Doing this may cause malfunction of thecompass sensor.
CALIBRATING THE COMPASS (deviation calibration)
The direction display on the compass deviates from the true
direction determined by the earth's magnetic field. The amount
of deviation varies according to the geographic position of the
vehicle.
To adjust for this deviation, stop the vehicle and push the
button for longer than about 6 seconds until the number (1±15)
appears on the display. Then push the button again, referring
to the following map to select the number of the zone where the
vehicle is.
SV16186

Zone number
If the direction is displayed several seconds after adjustment,
the calibration is finished.
04 06.30