door lock MITSUBISHI LANCER EVOLUTION 2010 10.G MMCS Manual

GPS Measurement 1-7
Introduction
GPS Measurement
GPSGPS is the acronym for Global Positioning System.
The MMCS uses GPS satellites that orbit the Earth
in space at an altitude of approximately 20,000km.
Electromagnetic waves from at least three of these
satellites are received on the Earth by the system,
making it possible to learn the current position.Map MatchingWhen traveling with just the GPS, there may be errors
in the current position display. In such case, “map
matching” is the function that compensates for this
error by assuming that vehicles travel on roads and
placing the current position on a nearby road.GPS antenna positionThe position of the vehicle is determined from the
weak electromagnetic waves from GPS satellites
received by the GPS antenna.
mngi263
NOTESince it may not be possible to accurately display the
vehicle position if the electromagnetic waves from
the GPS satellite are blocked, be sure to obey the
following:
 Do not attach re ective-type lms or lms containing
carbon to the window glass.
 Do not place objects on top of or close to the GPS
antenna.
 Do not use cellphones, computers, etc. near the
GPS antenna.Situations where accurate measurement is not
possibleIn situations such as the following, accurate
measurement may not be possible.
 Inside a tunnel or indoor parking area Under a two-tier freeway
 Area with many high-rise buildings Between closely-spaced treesThe US Tracking and Control Center controls the
satellites. Sometimes the electromagnetic waves are
stopped during upgrades or repairs to the system.NOTE Do not block the electromagnetic waves, from GPS
satellites by placing objects on or around the GPS
antenna.
 Avoid using a 1.5G digital mobile phone in the vicinity
of the GPS antenna, as it could prevent accurate
measurement.






 


Equipment 10-7
Settings
Equipment
Set the vehicle equipment.
1 Press the [SET] key, touch
[Equipment]
eng_a018
The equipment screen is displayed. 2 Touch the name of the equipment
group
eng_a237
3 Touch the item name
eng_a239
4 Touch the condition
eng_a240
5 Touch [Back]
The equipment settings are completed.
Equipment Items that Can Be Set
Refer to the section titled “Features and
Controls” in the vehicle owner’s manual for
details on setting these items.
Keyless Entry System Turn Signal Lights Answerback
 Horn Answerback Sounds at Keyless Entry Lock
 Duration of Horn Answerback SoundsF.A.S.T.*-key (Keyless Operation System)*:Free-hand Advanced Security Transmitter
 Turn Signal Lights Answerback
 Horn Answerback Sounds at keyless Entry Lock
 Duration of Horn Answerback Sounds
 Door Entry and Engine Start Function
 Keyless Operation Answerback Beep Sounds
 Time for Remote Unlock Inactivated after LockingNOTE Either “Keyless Entry System” or “Keyless Operation
System” will be displayed, depending on the equipment.
Wipers Windshield Wipers Intermittent Operation
 Wipers Linked to Washer
 Rear Wiper Intermittent Interval
 Rear Wiper Continuous OperationExterior Lights/Interior Lights Headlight Auto-cutout Function
 Interior Light Auto-cutout Time
 Duration Dome Light Remains On after Door is
ClosedTheft Alarm Panic AlarmTurn Signal Operation in Key Position
 Lane-change Signals (Flash Three Times with 1
Touch)Power Door Locks Automatic Relocking after Unlocked by Remote
 Unlock Operation
 Automatic Unlock when Transmission Shifted to ParkOthers Auto Cut of ACC Power