roof rack MITSUBISHI LANCER EVOLUTION VIII 2004 Workshop Manual

REFERENCE MA
TERIAL – MAIN EQUIPMENT, COLD CLIMATE SPECIFICATIONS88
4WD
RSGSR
Equipment
5/MT6/MT
ABSrll
SRS airbags
Fuel level
Parking brake
Charge
Brake fluid
Engine check
Warning
lights
Door not properly closed
Lighting monitor warningBuzzer
Ignition key reminder warning
lll
Fixed time
intermittentll
Variable
intermittent(speed
sensitive)l
Windscre
en wipers2 speed
Mist spray
Equip
ment
Windscreen washer (synchronized with
wiper, 4jet)
lll
4WD
RSGSR
Equipment
5/MT6/MT
Rear
windowwiper /
washerFixed time intermittent,
synchronized with (R) gearpositionl
AM/FM tuner radio + MD player
+ DVDMMCS (DVD navigation
Mitsubishi MultiCommunication
System)r
Roof aeriallll
Roof and window aerial (diversity
aerial)r
W/out audiolll
Audio
parts
6 speakers (2 DIN compatible)r*3
Digital clock
Immobiliser system
lll
Manual heater
Air conditioning kit
ll
Equip
ment
Air
conditioning
Fully automatic air
conditioningl
Notes:
*3: Brackets for an aerial and radio are installed as standard.
Cold Climate Specifications
4WD
RSGSR
Equipment
5M/T6M/T
Battery
Weather strip silicon coating
Rear seat heater duct
Cold Climate Specification label
rrr
Door mirrors with heating elementsr

33CHANGING WELDED PANELS – ROOF
(Front pillar upper support (Rear pillar upper support
removed condition) removed condition)
IMPORTANT POINTS TO OBSERVE WHEN DOING THE
WORK
REMOVAL
1.When removing the roof, use a support to prevent the side
panels opening out or leaning in.
2. To cut weld the front or rear roof rail, remove the front pillar
upper support and rear pillar upper support.
3. Using a drill (
5mm), make a hole in through the centre of the
rivet, crack it, and remove. Normally, selfpiercing rivets are
used, but blind rivets may also be used.
For areas where there is adhesive, use a cold chisel or similar
tool to free and remove the roof.Selfpiercing rivetBlind rivet
Drill
Rivet
Roof panel