weight NISSAN 300ZX 1984 Z31 Front Suspension Workshop Manual

TENSION ROD AND STABILIZER BAR
Removal and Installation
Remove tension rod and stabilizer bar
SFA287
Install tension rod as shown below.
SFA289
Final tightening should be carried out at curb
weight with tires on ground.
FA-I 1

TRANSVERSE LINK AND LOWER BALL JOINT
Removal ar
Separate knuckle arm from tie-rod using Tool.
SFA575
Separate knuckle arm from strut. Remove
stabilizer, tension rod and transverse link
SFA576
Separate ball joint from knuckle arm using
press
SFA577
Installation
To install transverse link, first temporarily
tighten nuts securing transverse
link spindle
which connects transverse
link to suspension
cross member.
Final tightening should be carried out at curb
weight with tires
on ground.
Make sure mating surface of bushing
is clean
and free from oil and grease.
FA-I 2

SUSPENSION CROSSMEMBER
Removal and Installation
Precaution
Support engine weight to remove
load from engine
mounting.
Inspection
Check suspension crossmember for deformation or
cracking. Replace
if necessary.
FA-I 4