brakes NISSAN TITAN 2016 2.G Quick Reference Guide

5
When the vehicle’s outside mirrors are extended for towing, you may see the mirrors in the bird’s-eye view or the front-side view.
For information regarding how to access additional viewing cycles, please\
see your Owner’s Manual.
There are some areas where the system will not detect objects.



•

W
hen in the front or the rear view display, an object
below the bumper or on the ground may not be
detected
2.



•


W

hen in the bird’s-eye view, a tall object near the seams
of the camera detecting areas
3 will not appear in
the monitor.



•


T

he distance between objects viewed on the
Around View Monitor differs from the actual distance.
Objects in the bird’ s-eye view will appear further
than the actual distance.
MOVING OBJECT DETECTION (MOD) (if so equipped)
The MOD system helps inform the driver of moving objects around the vehicle.
The system will operate when the shift lever is in the D (DRIVE), N (NEUTRAL), R (REVERSE),
or P (PARK) position and the vehicle is driven
at speeds of approximately 5 mph (8 km/h)
or less.
If the MOD system detects moving objects, a yellow frame will be displayed on the camera image.
When the following is displayed:



• Blue
MOD icon
4; the system is active.



• Gray

MOD icon; the system is not active.



•

No MOD icon; the system is off. The indicator will also be off if all of the warning
systems are deactivated using the Settings menu.
For more information, refer to the “Monitor, climate, audio, phone and voice recognition systems (section 4) ” of
your Owner’s Manual.
4
LHA380 7
2A
3
2
HILL START ASSIST (HSA) AND HILL DESCENT CONTROL
(HDC) (if so equipped)
HILL START ASSIST (HSA)
The HSA system allows time for the driver to release the brake pedal and appl\
y the
accelerator when the vehicle is parked on a hill. The brakes are applied automatically for
2 seconds after the driver releases the brake pedal.
The HSA system will operate automatically under these conditions:



•

T
he shift lever is shifted into a forward or a reverse gear.



•

T
he vehicle is stopped completely on a hill by applying the brake.
The HSA system will not operate when the shift lever is in the N (NEUTRAL) or P (PARK) position or when the vehicle is on a flat and level road.
2027886_16b_Titan_US_pQRG_010716.indd 51/7/16 2:02 PM
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.

6
1
NEW SYSTEM FEATURES
BLIND SPOT WARNING (BSW) WITH REAR CROSS TRAFFIC
ALERT (RCTA)* (if so equipped)
The BSW helps to alert the driver when another vehicle moves into the vehicle’s detection zone.
An indicator light located on the outside mirrors
1 will illuminate if the radar sensors detect a
vehicle in the detection zone.
Push the warning systems switc h 2 to
temporarily turn the system off. When the system
is off, the indicator light
3 on the switch and
the indicator light
4 in the vehicle information
display will extinguish.
The indicator light 3 will also be off if all of
the warning systems are deactivated using the
Setting menu.
The indicator lights 3 and 4 will illuminate after the ignition
switch is ON and the BSW system is enabled. This indicates that
the BSW system is operational.
The RCTA system helps to alert the driver of an approaching vehicle when the driver is backing out of a parking space. The
system operates when the shift lever is in the R (REVERSE) position and the vehicle
speed is less than approximately 5 mph (8 km/h).
The radar sensors detect an approaching vehicle from up to 66 ft (20 m). The sensors are located on both sides of the vehicle’s near the rear and front bumpers. The system
gives visual and audible warnings if an approaching vehicle is detected.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
1
4
HILL DESCENT CONTROL (HDC) (if so equipped)
T he HDC system is designed to apply the
brakes to help control the speed of the vehicle
and reduce the workload of the driver while
descending steep hills. To activate the system:



•

T
he HDC switch
1 must be on. To deactivate
the HDC system, push the HDC switch
1 to the OFF position.



• T

he vehicle must be in 4H (4WD) mode.



•


T

he shift lever must be in a forward or a reverse gear.



•


T

he HDC system operates at speeds of 15 mph (25 km/h) or less.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
2
3
2027886_16b_Titan_US_pQRG_010716.indd 61/7/16 2:02 PM
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.

7
TOWI NG
TRAILER BRAKE CONTROLLER UNIT (if so equipped)
T
he Trailer Brake Controller Unit will assist with effective and smooth braki\
ng while
towing a trailer.
Operating Modes



•

Automatic: Automatic operation of trailer brake pressure based on gain a\
nd

boost settings



•

Manual: Manually applies trailer brake pressure without pressing the veh\
icle

brake pedal
In automatic mode, the gain controls the amount
of trailer braking pressure. T o set the gain:



•

Press the or button 1 to decrease or
increase the braking force supplied to the trailer
brakes. For example, a gain setting of 6.0 is a
typical starting point for heavy loads.
In automatic mode, the boost can be set to c hange the feel of the trailer brake when
the vehicle’s brake pedal is pressed. To set the boost:



•

Press the button 2 once to display the current boost setting.



•


Press the button 2 again to increase the boost level or continue to press the
button 2 to return boost to OFF.
To manually apply brake pressure to the trailer without pushing the vehic\
le’s brake pedal, pinch the manual control levers
3 together. The amount of pinch pressure
applied to the levers will correlate to the amount of brake pressure app\
lied.
TRAILER LIGHT CHECKING (if so equipped)
Your Nissan Intelligent Key
® can be used to check the
trailer lights from outside the vehicle. If your vehicle
is equipped with a three-button key fob, this feature
operates in the same manner.
1.


Aim the Intelligent K

ey at the vehicle.
2.


Press and release the button 4.
3.


W

ithin 2 seconds, press the
button 4 again
and hold it until the horn beeps once and the
parking lights turn on.
The trailer light check will follow the following sequence:



•


T

he left turn light on the vehicle and trailer will flash for 5 seconds\
.



•


T

he right turn light on the vehicle and trailer will flash for 5 second\
s.



•


T

he brake lights on the vehicle and trailer will turn on for 5 seconds.
1
23
4
2027886_16b_Titan_US_pQRG_010716.indd 71/7/16 2:02 PM
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.