40A-11
GENERAL INFORMATION
Hollow section inserts: Precautions for the repair
40A
The expanding inserts ensure that the vehicle cavities
are sealed and soundproofed. They react to the tempe-
rature when the bodywork is immersed in the catapho-
retic bath at the factory. These conditions cannot be
reproduced on the bodywork.
As inserts are not recoverable, always replace expan-
ding inserts.
The inserts supplied by the Parts Department are
identical to the original parts.
To obtain the same sealing and soundproofing proper-
ties, carry out the following operations:
-clean the bonding surfaces with heptane,
-if necessary, block the holes in the insert using pieces
cut from a soundproofing pad.
-apply a bead of preformed trim sealing mastic around
and inside the insert holes,
-fit the insert by compressing the mastic.
In some cases, it is possible to replace the accessible
part of the insert only, which must be cut out of the re-
placement part.WARNING
Do not refit the part after compressing the bead.
When EGW welding, protect the inserts from spat-
ter and heat dispersion.
For example, use a heat shield.
40A-28
GENERAL INFORMATION
Structural components to be positioned on the repair bench: Description40A
VIII - REAR SIDE MEMBER END
The jig rests under the rear side member and is cen-
tred in hole (17) .
The jig should be used with the mechanical compo-
nents in place to realign a rear side member.
The jig is used with the mechanical components remo-
ved, under the same conditions, to replace the comple-
te rear side member.
IX - INNER REAR WHEEL ARCH
The jig supports the underneath of the rear shock ab-
sorber cup and is centred on hole (18) .The jig is used when replacing the rear wheel arch.
121748
121749