interior lights SUBARU BAJA 2006 1.G Owners Manual

15
–
CONTINUED –
12
54 3
UBF050BB
1) Moonroof (page 2-36)
2) Interior lights (page 6-2)
3) Sun visors (page 6-3)
4) Map light (page 6-3)
5) Inside mirror (page 3-30)

2-9
Keys and doors
– CONTINUED –
„Illuminated entry„
Illuminated entryThe interior dome light and ignition switch light will illu-
minate when the “ ” button is pressed. These
lights stay illuminated for approximately 30 seconds if
any of the doors is not opened.
If the “ ” button is pressed before 30 seconds have
elapsed, these lights will go out. Also, these lights will
go out if the key is inserted in the ignition switch. The interior light switch must be set to the middle position
in order for this function to operate. „ Vehicle finder function
Use this function to find your vehicle parked among
many vehicles in a large parking lot. Provided you are within 30 feet (10 meters) of the vehicle, pressing the
“ ” button three times in a five-second period will
cause your vehicle’s horn to sound once and its turn
signal lights to flash three times.
NOTE
If the interval between presses is too short when
you press the “ ” button three times, the sys-
tem may not respond to the signals from the re-mote transmitter. „
Sounding a panic alarm
„
Sounding a panic alarmTo activate the alarm, keep the “ ” button pressed
for more than two seconds .
The horn will sound and the turn signal lights will flash.
To deactivate it, press any button on the remote trans-
mitter. Unless a button on the remote is pressed, the
alarm will be deactivated after approximately 30 sec-
onds. „ Selecting audible signal operation
Using an electronic chirp, the system will give you an
audible signal when the doors lock and unlock. If de-
sired, you may turn the audible signal off.
Do the following to deactivate the audible signal. You
can also use the same steps to restore the function.
1. Sit in the driver’s seat and shut all doors and therear gate.
2. Open the driver’s door, then remove the key from
the ignition switch.
3. Hold down the “UNLOCK” side of the power door locking switch.
4. While holding down the “UNLOCK” side of the pow-
er door locking switch, insert the key into the ignition
switch and remove it again at least 6 times within 10
seconds after Step 3.
5. While still holding down the “UNLOCK” side of the

6-1
6
Interior and exterior equipments
Interior light .................................................. 6-2 Dome light ......................................................... 6-2
Map light ........................................................ 6-3
Sun visors ..................................................... 6-3 Vanity mirror (if equipped) ............................... 6-4
Storage compartment .................................. 6-4 Glove box ........................................................... 6-5
Center console .................................................. 6-5
Rear center console .......................................... 6-6
Coin compartment ............................................ 6-6
Cup holder .................................................... 6-7 Front cup holder ............................................... 6-7
Rear passenger’s cup holder ........................... 6-8
Accessory power outlet . .............................. 6-8
Cigarette lighter socket .. .............................. 6-9
Use with a cigarette lighter .............................. 6-10
Using as an accessory power outlet ............... 6-11
Ashtray .......................................................... 6-12
Convenience hook ....................................... 6-13 Coat hook .......................................................... 6-13
Cargo net hooks ................................................ 6-13
Floor mat (if equipped) ................................. 6-15
Cargo bed ...................................................... 6-16 Cargo tie-down hooks ...................................... 6-17
Bed extender (if equipped) .......................... 6-17 Operation ........................................................... 6-18
Bed extender removal ...................................... 6-19
Cargo lamp .................................................... 6-20
Soft bed cover (if equipped) ........................ 6-21 Securing the cover ........................................... 6-21
Cover removal ................................................... 6-22
Cover reinstallation .......................................... 6-23
Hard bed cover (if equipped) ....................... 6-24 Locking and unlocking the bed cover ............ 6-25
Internal hard bed cover release handle .......... 6-27
Opening and closing the hard bed cover ....... 6-28
Removal and installation of the hard bed cover ................................................................ 6-32
Roof rail and crossbar .................................. 6-36 Installing carrying attachments on the crossbars ........................................................ 6-37
Removal and installation of the crossbars .... 6-37
Sport activity lights (if equipped) ................ 6-42

6-3
Interior and exterior equipments
– CONTINUED –
Map light
1) Switches
2) Map lights
To turn on the map light, push the switch. To turn it off,
push the switch again.
When leaving the vehicle, make sure the light is turned
off to avoid battery discharge.Sun visors
To block out glare, swing down the visors. To use the
sun visor at a side window, swing it down and move it sideways.
1
2
UG6021CBUB7001BA

6-42
Interior and exterior equipments
Sport activity lights (if equipped)
1) Indicator light
The sport activity lights will operate only when the
parking brake is engaged. Push the “SPORT LIGHTS”
switch to turn the sport activity lights on.
Press the switch agai n to turn them off.
The indicator light located on the switch will illuminate
when the sport activity lights are on.
NOTE y In most states, the sport activity lights must
have stone shields installed when the vehicle is operated on public roads. y
In most states, the sport activity lights may not
be operated when the vehicle is in motion on a
public road.
The sport activity lights mount to the vehicle front cross bar. The sport activi ty lights cross bar wire har-
ness connects to the roof wire harness and then to the
vehicle’s electrical system.
A tool is provided which will activate the sport activity
lights’ positioning to be modified, so that each lamp
can be aimed or rotated. The lamps can be mounted
in two positions, upright (normal) or forward (down-
ward). The lamps should be rotated to the forward
1
UB6041BB
UB3019AA

6-43
Interior and exterior equipments
– CONTINUED –
(downward) position when washing your vehicle. If you choose to remove sport activity lights, the follow-
ing sequence should be utilized:
1. Disconnect the roof harness from the cross bar har-
ness connector.
2. Attach the water proof connector cap to the roof
harness connector.
3. Care should be used when removing or installing
this electrical product.

14-5
Index
Gauge ............................................................. 3-8
Requirements ................................................. 7-2
Fuses ............................................................... 11-59
Fuses and circuits ............................................. 12-5 G
GAWR (Gross Axle Weight Rating) ................... 8-19
Glove box ............................................................ 6-5
GVWR (Gross Vehicle Weight Rating) .............. 8-19 H
Hard bed cover .................................................. 6-24
Hazard warning flasher ....... ................................ 3-6
Head restraint adjustment (Fro nt) ........................ 1-6
Headlight flasher ................. .............................. 3-21
Headlights ............. ................................. 3-20, 11-66
Heater operation .... .......................................... .... 4-7
High beam indicator light ................................... 3-18
High mount stop and cargo light assembly ...... 11-79
Horn ................................................................... 3-35
Hose and connections ......... ............................ 11-18
I
Ignition switch ...................................................... 3-2
Illuminated entry .................................................. 2-9
Illumination brightness contro l ........................... 3-23 Indicator light
High beam .................................................... 3-18
Selector lever position .................................. 3-17
Turn signal .................................................... 3-17
Inside mirror ...................................................... 3-30
Interior light .......................................................... 6-2 J
Jack and tools ..................................................... 9-3
Jump starting ..................................................... 9-18 K Key Interlock release ............................................. 3-5
Number ........................................................... 2-2
Reminder chime ............................................. 3-4
Keys .................................................................... 2-2 L
Leather seat materials ....................................... 10-7
License plate bracket ........................................ 2-30
License plate light ............................................ 11-76
Light control switch ............................................ 3-19
Limited slip differential (LSD ) ............................ 7-30
Loading your vehicle ......................................... 8-17
Lower tether anchorages ................................... 1-40