height SUZUKI JIMNY 2021 User Guide

Left Side View
Bottom View
tt t
(1)
(1)
H♦
(2)
•
"a"
78RB02084
BEFORE DRIVING
(1) Fixing points on vertical (side) surfaces
(2) Maximum vertical load on trailer hitch point (EU): 75 kg (165 lbs)
Trailer hitch ball height "a" 450 -490 mm (17.7 -19.3 in.) Maximum permissible overhang "b" 787 mm (31.0 in.)
2-78

NOTE: SUZUKI highly recommends the use of ECSTAR brend brake fluid. ECSTAR has been specially formulated for your SUZUKI product and contributes to the desired vehicle performance and ideal driving experience.
A WARNING
Failure to follow the guidelines below can result in personal injury or seri­ous damage to the brake system. . If the brake fluid in the reservoir drops below a certain level, the brake warning light on the instru­ment cluster will come on (the engine must be running with the parking brake fully dise~gaged). Should the light come on, 1mmed1-ately ask a SUZUKI dealer to inspect the brake system. A rapid fluid loss indicates leakage in the brake system which should be inspected by a SUZUKI dealer immediately. Do not use any fluid other than DOT3 or SAE J1703 brake fluid. Do not use reclaimed fluid or fluid that has been stored in old or open con­tainers. It is essential that foreign particles and other liquids are kept out of the brake fluid reservoir.
A CAUTION
Brake fluid can harm your eyes and damage painted surfaces. Be careful when refilling the reservoir.
A WARNING
Brake fluid is harmful or fatal if swal­lowed, and harmful if it comes in con­tact with skin or eyes. If swallowed, do not induce vomiting. Immediately contact a poison control center or a physician. If brake fluid gets in eye~, flush eyes with water and seek medi­cal attention. Wash thoroughly after handling. Solution can be poisonous to animals. Keep out of reach of chil­dren and animals.
NOTE: • The fluid /eve/ can be expected to gredu­ally fall as the brake pad and/or shoe wear. Brake fluid absorbs water over time and brake fluid with high water content may cause vapor lock or breke system mal­function. Replace your breke fluid in accordance with the maintenance schedule m your Owner's Manual.
INSPECTION AND MAINTENANCE
Brake pedal
Check brake pedal stroke. If the stroke is so large, have the brake system inspected by a SUZUKI dealer. If you doubt th_e brake pedal is at its normal height, check 1t as fol­lows:
54G108
Minimum distance between brake pedal and floor carpet "a"
LHD 101 mm (4.0 in)
RHD 89 mm (3.5 in)
6-34

SPECIFICATION
Specifications
NOTE: Specifications are subject to change without notice.
MIT: Manual transmission NT: Automatic transmission
ITEM: Dimensions UNIT: mm (in.)
Overall length 3625 (142.7) (Front bumper to spare tyre) 3645 (143.5) (Front bumper to spare wheel half cover)
Overall width 1645 (64.8)
Overall height 1720 (67.7)
Wheelbase 2250 (88.6)
Track I Front 1395 (54.9)
I Rear 1405 (55.3)
Ground clearance 210 (8.2)
9-3

4) When routing the top tether strap, pass the top tether strap as shown in the illustration. (Refer to "Head restraints" section for details on how to adjust the height of head restraint or remove it.) 5) Check that cargo does not interfere with routing of the top tether strap.
NOTICE
When installing a child restraint sys­tem to the rear seat, adjust the front seat position so that the front seat does not interfere with the child restraint system.
SUPPLEMENT
Rear-facing child restraint
58MS030
A WARNING
Do not use a rearward facing child restraint on a seat protected by an airbag in front of it.
A WARNING
Do not install a rear-facing child restraint in the front passenger's seat. If the passenger's front airbag inflates, a child in a rear-facing child restraint could be killed or severely injured. The back of a rear-facing child restraint would be too close to the inflating airbag.
10-2

PANTOGRAPH JACK
INSTRUCTION MANUAL
CE
Manufacturers:
RIKENKAKI CO., LTD. 5-6-12 Chiyoda, Sakado-shl, Saitama, 350-0214 Japan Tel: 049-248-1661 Fax:049-284-4340
CHANGZHOU RIKENSEIKO MACHINERY CO., LTD. No.5 Xinlin Road. Zhonglou Changzho1.1, JiangsLJ CHINA Te!: 0519-327-5284 Fax:0519-327-0811
Please read this INSTRUCTION MANUAL before operation!
Norm: EN 1494:2000+A1:2008
Attention and warning -The JACK may be used only for replacing tyres, not for any other purpose. -Use the JACK no more than 50 times. -No-loadlng person. • Never get under vehicle raised by Jack. -Use of defective or Inadequately ma!ntalned jacks Is extremely dangerous.
Meaning of pictogram on caution label
Parts name of Pantograph Jack
FJG1
Technical Data and Application
'
This symbol Indicates a potential hazard that could result In death or serious Injury.
This symbol Indicates you never get under the vehicle when it Is supported by the Jack.
A ; TOPHOLDER B : BASE C: UPPER ARM D :LOWER ARM E : HANDLE JOINT F :JACKSCREW G : NOMINAL LOAD (t)
lL. H, H3 H,
H1: MINIMUM HEIGHT(mm) H2; MAXIMUM HEIGHT (mm) HJ: PERFORMANCE ASSURANCE HEIGHT (mm) X : JACK HEIGHT (mm) Y: LOAD(t) M: MODEL T :TYPE
M T G H, H, H, 55L Suzuki Tupe-I 0.95 89 327 208 72K Suzuki Tvoe-II 0.95 70 281 175.5 54L Suzuki Type-III 0.95 80 318 199 81A Suzuki Type-IV 1.0 85.5 344 214.75 77K Suzuki Type-V 1.25 100.8 436.3 268.55
FIG2