bulb TOYOTA AVENSIS 1999 Supplement

PP12J–02
– PREPARATIONBODY ELECTRICAL
PP–19
BODY ELECTRICAL
EQUIPMENT
Voltmeter
Ammeter
Ohmmeter
Test lead
SyphonBrake fluid level warning switch
Bulb (3.4 W)Fuel sender gauge,
Dry cell batteryFuel sender gauge

I01275
Ignition
Switch
BatterySender
Gauge Receiver
Gauge
I01276
Ignition
Switch
BatteryReceiver
Gauge
Test Bulb
(3.4 W)
I01277
Battery Ignition
SwitchWarning Light
Wire Harness Side
1
– BODY ELECTRICALCOMBINATION METER
BE–7
(b) Compare the tester and tachometer indications.
DC 13.5 V 25
C at (77
F)
Standard indicationAllowable range
700630 – 770
1,000900 – 1,100
2,0001,850 – 2,150
3,0002,800 – 3,200
4,0003,800 – 4,200
5,0004,800 – 5,200
6,0005,750 – 6,250
7,0006,700 – 7,300
4. INSPECT ENGINE COOLANT TEMPERATURE RE-
CEIVER GAUGE OPERATION
(a) Disconnect the connector from the sender gauge.
(b) Turn the ignition switch ON and check that the receiver
gauge needle indicates COOL.
(c) Ground terminal on the wire harness side connector
through a 3.4 W test bulb.
(d) Turn the ignition switch ON, and check that the bulb lights
up and the receiver gauge needle moves to the hot side.
If operation is as specified, replace the sender gauge.
Then recheck the system.
If operation is not as specified, measure the receiver gauge re-
sistance.
5. INSPECT LOW OIL PRESSURE WARNING LIGHT
(a) Disconnect the connector from the warning switch and
ground terminal on the wire harness side connector.
(b) Turn the ignition switch ON and check that the warning
light lights up.
If the warning light does not light up, test the bulb.