charging YAMAHA MAJESTY S 125 2015 Owners Manual
[x] Cancel search | Manufacturer: YAMAHA, Model Year: 2015, Model line: MAJESTY S 125, Model: YAMAHA MAJESTY S 125 2015Pages: 84, PDF Size: 2.21 MB
Page 63 of 84
PERIODIC MAINTENANCE AND ADJUSTMENT
6-26
2
3
4
567
8
9
ways shield your eyes when
working near batteries. In case
of contact, administer the fol-
lowing FIRST AID.
EXTERNAL: Flush with plenty
of water.
INTERNAL: Drink large quan- tities of water or milk and im-
mediately call a physician.
EYES: Flush with water for 15 minutes and seek prompt
medical attention.
Batteries produce explosive hy-
drogen gas. Therefore, keep
sparks, flames, cigarettes, etc.,
away from the battery and pro-
vide sufficient ventilation when
charging it in an enclosed
space.
KEEP THIS AN D ALL BATTER-
IES OUT OF THE REACH OFCHILDREN.
To charge the battery
Have a Yamaha dealer charge the bat-
tery as soon as possible if it seems to
have discharged. Keep in mind that the
battery tends to discharge more quickly if the vehicle is equipped with optional
electrical accessories.
NOTICE
ECA16522
To charge a VRLA (Valve Regulated
Lead Acid) battery, a special (con-
stant-voltage) battery charger is re-
quired. Using a conventional batterycharger will damage the battery.
To store the battery
1. If the model will not be used for more than one month, remove the
battery, fully charge it, and then
place it in a cool, dry place. NO-
TICE: When removing the bat-
tery, be sure the key is turned to
“OFF”, then disconnect the neg-
ative lead before disconnecting
the positive lead.
[ECA16303]
2. If the battery will be stored for more than two months, check it at least
once a month and fully charge it if
necessary.
3. Fully charge the battery before in- stallation. NOTICE: When install-
ing the battery, be sure the key
is turned to “OFF”, then con- nect the positive lead before
connecting the negative
lead.
[ECA16841]
4. After installing the battery, make
sure that the battery leads are
properly connected to the battery
terminals.
5. Turn the key from “ON” to “OFF” three times in three-second inter-
vals to initialize the idle speed con-
trol system.NOTICE
ECA16531
Always keep the battery charged.
Storing a discharged battery cancause permanent battery damage.
Page 76 of 84
SPECIFICATIONS
8-2
1
2
3
4
5
6
78
9
Trail:82 mm (3.2 in)Front tire:Type:Tubeless
Size: 120 / 70 - 13 M/C 53P
Manufacturer/model:
KENDA / K703FRear tire:Type:Tubeless
Size:
130 / 70 - 13 M/C 57P
Manufacturer/model: KENDA / K703Loading:Maximum load:
160 kg (353 lb)
* (Total weight of rider, passenger, cargo and accessories)Tire air pressure (measured on cold
tires):Loading condition:90 kg (198 lb)
Front:
200 kPa (2.00 kgf/cm
2, 29 psi)
Rear:
200 kPa (2.00 kgf/cm2, 29 psi)
Loading condition: 90 kg - maximum load
Front:
200 kPa (2.00 kgf/cm2, 29 psi) Rear:
225 kPa (2.25 kgf/cm
2, 33 psi)
Front wheel:Wheel type:Cast wheel
Rim size: J 13 × MT3.00Rear wheel:Wheel type:Cast wheel
Rim size: J 13 × MT3.5Front brake:Type:Single disc brake
Operation: Right hand operation
Specified brake fluid:
DOT 4Rear brake:Type:Single disc brake
Operation:
Left hand operation
Specified brake fluid: DOT 4Front suspension:Type:
Telescopic fork
Spring/shock absorber type: Coil spring/oil damper
Wheel travel: 79 mm (3.1 in)
Rear suspension:Type: Swingarm
Spring/shock absorber type: Coil spring/oil damper
Wheel travel: 93 mm (3.7 in)Electrical system:Ignition system:TCI
Charging system: AC magnetoBattery:Model:GT7B-4
Voltage, capacity: 12 V, 6.5 AhHeadlight:Bulb type:Halogen bulbBulb voltage, wattage × quantity:Headlight:
12 V, 60.0 W/55.0 W × 1
Tail/brake light: LED
Front turn signal light: 12 V, 10.0 W × 2
Rear turn signal light:
12 V, 10.0 W × 2
Auxiliary light: LED
License plate light: 12 V, 5.0 W × 1