dead battery Alfa Romeo 166 2006 Owner handbook (in English)

19
KEY BATTERY CHANGE
If pressing the remote control buttons
(AorB-fig. 7), the led (C-fig. 7)
(where required) gives only one brief
flash and the alarm system led (where
fitted) (A-fig. 8) on the dashboard s-
tays on glowing steadily for about 2 min-
utes (after turning off the alarm and with
the ignition switch off), it is necessary to
replace the battery with a new one of the
equivalent type to be found c/o normal
retailers.
To replace the battery, remove the plas-
tic lid (A-fig. 9), insert the new battery
according to the correct polarity and put
the lid back on.For further information contact Autho-
rised Alfa Romeo Services.
OPERATION
Each time the ignition key is turned to
theSTOPposition, the Alfa Romeo
CODE system deactivates the functions of
the engine electronic control unit.Each time the engine is started, turning
the key to the MARposition, the control
unit of the Alfa Romeo CODE system
sends a recognition code to the engine
control unit to deactivate the inhibition of
the functions.
The recognition code, which is crypted
and variable between over 4 billion com-
binations, is only sent if the system con-
trol unit has recognised the code sent to
it by the key, which contains an electronic
transmitter, through an aerial in the igni-
tion switch. Dead batteries consti-
tute a hazard for the
environment and must
be disposed of in the special con-
tainers as specified by the rela-
tive laws.
fig. 7
1011PGSm
fig. 9
1034PGSm
fig. 8
305PGSm

226
The characteristics of these products are
compatible with the type of paint, gas-
kets and trim of all Alfa Romeo vehicles.
The application of these products should
however be carried out by Alfa Romeo
personnel who will be able to guarantee
the best results and avoid problems which
may compromise the bodywork warranty
cover.
To correctly wash the car, proceed as fol-
lows:
1) Spray the vehicle with a low pres-
sure jet of water.
2) Pass a sponge moistened with a
light detergent solution (2-4% shampoo
in water) over the bodywork rinsing the
sponge frequently.
3) Rinse well with water and dry with a
jet of air or chamois leather.Detergents cause water
pollution. The car should
therefore be washed in
areas equipped for the collection
and purification of the liquid used
in the washing processes.RECOMMENDATIONS TO
PRESERVE THE BODYWORK
Particular care should be taken to en-
sure that residual deposits of industrial
dust, tar spots, dead insects etc. do not
remain on the bodywork.
Where possible do not park under trees
as, during certain seasons, residues, buds
and leaves containing chemical sub-
stances which are harmful to the paint
may fall onto the vehicle.
When topping up ensure that petrol, lu-
bricating oil, brake fluid, liquid for the
cooling system, battery electrolyte solu-
tion etc. is not splashed onto the body-
work.
If this should occur however, clean the
area immediately and wash the vehicle
as soon as possible.
PAINT
The paintwork does not only serve an
aesthetic purpose but also protects the
underlying sheet metal.
In the case of deep scrapes or scores
you are advised to have the necessary
touching up carried out immediately by a
specialised workshop to avoid the forma-
tion of rust.
Normal paint maintenance consists in
washing at intervals depending on the
conditions and environment of use.
For example:
– in areas with high atmospheric pollu-
tion.
– Roads sprayed with salt.
– Parking under trees that release
resinous substances.
It is wise to wash the car more frequently.
Alfa Romeo markets a complete series
of products specifically designed for the
care and cleanliness of its vehicles (sham-
poo, wax, touch-up paint stick, stain re-
mover, polish etc.).