light Alfa Romeo MiTo 2010 Owner handbook (in English)

IN AN EMERGENCY175
4
INFLATIONPROCEDURE
fig. 16A0J0214m
Wear the gloves provided in the kit.
Proceed as follows:
❍Make sure the handbrake is on, unscrew the tyre valve cap,
take out the flexible filling pipe, B-fig. 16 and screw down
the ring nut C on the tyre valve;
❍make sure that switch A-fig. 17 on the compressor is in posi-
tion 0 (off), start the motor, insert pin A-fig. 18 into the cur-
rent socket/cigar lighter on the central tunnel and switch on
the compressor by placing switch A-fig. 17 in position I (on);
❍inflate the tyre to the pressure shown in the paragraph entitled
“Wheels” in chapter 6. In order to obtain a precise reading,
check the pressure on pressure gauge B-fig. 17 with the com-
pressor off;
fig. 17A0J0114m
163-200 Alfa MiTo GB 2ed:163-200 Alfa MiTo GB 23-12-2009 12:39 Pagina 175

178IN AN EMERGENCY
CHANGINGABULB
GENERAL INSTRUCTIONS
❍Before changing a bulb check the contacts for oxidation;
❍blown bulbs must be replaced with others of the same type and
power;
❍After replacing a headlight bulb, always check its alignment;
❍When a bulb is not working, check that the corresponding fuse
is intact before replacing it: refer to the “Replacing fuses” para-
graph in this section for the location of fuses.
BULBTYPESfig.21
The vehicle has the following light bulbs:
A. All glass bulbs: clipped into place. Pull to extract.
B. Bayonet bulbs: to remove this type of bulb from its holder, press
the bulb and turn it anticlockwise.
C. Cylindrical bulbs: release from the contacts to extract.
D. Halogen bulbs: release the fastening clip from the corresponding
seat to remove the bulb.
E. Halogen bulbs: release the fastening clip from the corresponding
seat to remove the bulb.
fig. 21A0J0117m
163-200 Alfa MiTo GB 2ed:163-200 Alfa MiTo GB 23-12-2009 12:39 Pagina 178

5/21W
–
55W
55W
D1S
21W
21W
5W
–
–
5W
55W
21W
21W
10W
5W
5W
5WA
–
D
D
–
B
B
A
–
–
A
E
B
B
C
A
C
A
IN AN EMERGENCY179
4
W21/5W
LED
H7
H7
F
WY21W
P21W
W5W
LED
LED
W5W
H1
P21W
P21W
C10W
W5W
C5W
W5W
Bulb TypePower Ref.figure
Front side lights/Daylight lights
Rear side lights
Dipped beams
Main beams
Dipped beams/Main beams (versions with Bi-xenon
headlights) (for versions/markets, where provided)
Front direction indicators
Rear direction indicators
Side direction indicators
Brake light
3rd brake light
Number plate light
Fog lights
Rear fog lights
Reversing light
Front courtesy light
luggage compartment courtesy light
Glove compartment courtesy light
Door lights
163-200 Alfa MiTo GB 2ed:163-200 Alfa MiTo GB 23-12-2009 12:39 Pagina 179

180IN AN EMERGENCY
REPLACINGEXTERIORBULBS
FRONT LIGHTCLUSTERSfig.22
These contain the bulbs for the side lights, dipped beams, main beams
and direction indicators. The bulbs are arranged as follows:
A. Side lights/daylight lights and main beam headlights;
B. Dipped beam headlights;
C. Direction indicators.
SIDELIGHTS/DAYLIGHT LIGHTS
To change the bulb, proceed as follows:
❍remove cover A-fig. 22;
❍withdraw lamp holder B-fig. 23, remove the bulb and
replace it;
❍refit lamp holder B making sure it is correctly secured;
❍refit cover A-fig. 22;
MAINBEAM HEADLIGHTS
To change the bulb, proceed as follows:
❍remove cover A-fig. 22;
❍withdraw lamp holder C-fig. 23, remove the bulb and replace it;
❍refit the lamp holder making sure it is correctly secured;
❍refit cover A-fig. 22.
fig. 22A0J0021mfig. 23A0J0041m
163-200 Alfa MiTo GB 2ed:163-200 Alfa MiTo GB 23-12-2009 12:39 Pagina 180

IN AN EMERGENCY181
4
DIPPED BEAM HEADLIGHTS
Withincandescentbulb
To change the bulb, proceed as follows:
❍remove cover B-fig. 22;
❍remove cover A-fig. 24 protecting the bulb;
❍remove the bulb and replace it;
❍refit the lamp holder making sure it is correctly secured;
❍refit cover B-fig. 22.
Withgasdischargebulbs(Bi-xenon)
(for versions/markets, where provided)
DIRECTIONINDICATORS
Frontindicators
To change the bulb take key A-fig. 25 (located in the document
holder case), insert in seat B and turn the bulb holder anticlock-
wise. Remove the bulb and replace it.
fig. 24A0J0040m
Contact an Alfa Romeo Authorised Service Provider
to replace these bulbs.
fig. 25A0J0018m
163-200 Alfa MiTo GB 2ed:163-200 Alfa MiTo GB 23-12-2009 12:39 Pagina 181

182IN AN EMERGENCY
Side indicators
To change the bulb, proceed as follows:
❍work on lens A-fig. 26 to compress clip B, then pull the unit
outwards;
❍turn bulb holder C anticlockwise, remove the bulb and replace
it;
❍refit the bulb holder C in the lens and turn it clockwise;
❍refit the unit, making sure that internal clip B clips into posi-
tion.
FRONT FOGLIGHTS(for versions/markets, where provided)
Contact an Alfa Romeo Authorised Services to replace these bulbs.
REAR LIGHTCLUSTERS
To access the light cluster, move the luggage compartment side
trim (see Fig. 27). These contain the bulbs for the side lights, di-
rection indicators and brake lights.
SIDELIGHTS/BRAKELIGHTS
These are LED lights. Contact an Alfa Romeo Authorised Services
to replace these lights.
DIRECTIONINDICATORS
To replace the bulb remove bulb holder A-fig. 27.
fig. 26A0J0042mfig. 27A0J0043m
163-200 Alfa MiTo GB 2ed:163-200 Alfa MiTo GB 23-12-2009 12:39 Pagina 182

IN AN EMERGENCY183
4
REAR FOGLIGHTS/REVERSINGLIGHTS
To replace the rear fog lights A-fig. 28 or reversing lights B con-
tact an Alfa Romeo Authorised Services.
NUMBER PLATELIGHTS
To change the bulb proceed as follows:
❍remove the lens unit A-fig. 29;
❍turn bulb holder B-fig. 30 anticlockwise, remove bulb C and re-
place it.
THIRDBRAKELIGHTS
These are located in the tailgate and are LED lights. Contact an
Alfa Romeo Authorised Services to replace these lights.
fig. 28A0J0044mfig. 30A0J0045m
fig. 29A0J0046m
163-200 Alfa MiTo GB 2ed:163-200 Alfa MiTo GB 23-12-2009 12:39 Pagina 183

184IN AN EMERGENCY
REPLACINGAN INTERIORBULB
FRONTCOURTESYLIGHT
To change the bulb, proceed as follows:
❍remove courtesy light A-fig. 31 by applying leverage at the
points shown by the arrows;
❍open flap B-fig. 32 replace bulb C, releasing it from the side
contacts. Make sure that the new bulbs are correctly secured
between the contacts;
❍close flap B-fig. 32 and secure courtesy light A-fig. 31 in its
housing.
LUGGAGE COMPARTMENTCOURTESYLIGHT
To change the bulb, proceed as follows:
❍open the luggage compartment and remove courtesy light A-fig.
33, by applying leverage at the points shown by the arrows;
fig. 31A0J0120m
fig. 32A0J0121m
fig. 33A0J0119m
163-200 Alfa MiTo GB 2ed:163-200 Alfa MiTo GB 23-12-2009 12:39 Pagina 184

IN AN EMERGENCY185
4
❍open cover B-fig. 34 and replace the bulb;
❍re-close the protective cover B on the lens;
❍refit courtesy light A-fig. 33, inserting it into the correct posi-
tion firstly on one side and then on the other until it clicks in-
to place.
GLOVECOMPARTMENT LIGHT
To change the bulb, proceed as follows:
❍open the glove compartment, and remove light A-fig. 35;
❍replace bulb B, releasing it from the side contacts and making
sure the new bulb is correctly fastened between the contacts.
fig. 34A0J0118mfig. 35A0J0122m
163-200 Alfa MiTo GB 2ed:163-200 Alfa MiTo GB 23-12-2009 12:39 Pagina 185

186IN AN EMERGENCY
SUN VISORCOURTESYLIGHT
(for versions/markets, where provided)
To change the bulb, proceed as follows:
❍lower the sun visor and remove courtesy light A-fig. 36 by ap-
plying leverage at the points shown by the arrows;
❍remove protective cover B, releasing it from tabs C, replace bulb
D-fig. 37 by pulling it outwards and releasing it from the side
contacts;
❍insert a new bulb, making sure that it is correctly secured be-
tween the contacts;
❍refit protective cover B by inserting it between tabs C;
❍refit the courtesy light by inserting into side E-fig. 37 and then
pressing the other side until hearing the locking click of tab F.
fig. 36A0J0123mfig. 37A0J0124m
163-200 Alfa MiTo GB 2ed:163-200 Alfa MiTo GB 23-12-2009 12:39 Pagina 186