display Acura RL 2005 User Guide
Page 66 of 394
If this happens, pull to the side of the
road when it is saf e, check which tire
has lost the pressure on the multi-
inf ormation display, and determine
the cause. If it is because of a flat tire,
replace the flat tire with the compact
spare (see page ), and have the
f lat tire repaired as soon as possible.
If two or more tires are underinf lated,
call a prof essional towing service.
For more inf ormation, see page .
Pull to the side of the road when it is
saf e, shif t to Park, and let the engine
idle until the indicator goes out.
This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to ON (II).
If it comes on while driving, it
indicates that one or more of your
vehicle’s tires are extremely low on
pressure.
This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to ON (II). If this
indicator comes on at any other time,
there is a problem in the SH-AWD
system. You will also see a ‘‘CHECK
SH-AWD SYSTEM’’ message on the
multi-inf ormation display (see page
). Take your vehicle to a dealer to
have it checked. For more
inf ormation, see page .
You will also see a ‘‘CHECK TIRE
PRESSURE’’ message on the multi-
inf ormation display (see page ).
If it comes on while driving, it
indicates the dif f erential
temperature is too high.
You will also see a ‘‘SH-AWD DIFF
TEMP. HIGH’’ message on the
multi-inf ormation display (see page
).
If the indicator blinks while driving,
pull to the side of the road when it is
saf e, shif t to Park, and let the engine
idle until the indicator goes out. 336
360
76
272
77
76 SH-A WD Indicator
Low Tire Pressure
Indicator
Instrument Panel Indicators
Inst rument s and Cont rols
65
Continuing to drive with the SH-AWD
indicator blinking may cause serious
damage to the system.
Page 67 of 394
This indicator normally comes on
when you turn the ignition to ON (II)
and goes off after the engine starts.
If it comes on at any other time,
there is a problem with the power
steering system. You will also see a
‘‘CHECK POWER STEERING
SYSTEM’’ message on the multi-
inf ormation display (see page ). If
this happens, stop the vehicle in a
saf e place, and turn of f the engine.
Reset the system by restarting the
engine, and watch this indicator. If it
does not go of f , or comes back on
again while driving, take the vehicle
to your dealer to have it checked.
With the indicator on, the ECPS is
turned of f , which could make the
vehicle harder to steer.This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to ON (II). If it comes
on at any other time, it indicates that
there is a problem with the system.
You will also see a ‘‘CHECK
KEYLESS ACCESS SYSTEM’’
message on the multi-inf ormation
display (see page ). For more
inf ormation, see page .
This indicator comes on when there
is a system message in the multi-
inf ormation display. Press the INFO
button on the steering wheel (see
page ) to see the message (see
page ).
Most of the time, this indicator
comes on along with other indicators
in the instrument panel such as the
seat belt reminder indicator, SRS
indicator, VSA system indicator, etc.
The indicator comes on when you
gun the engine while the vehicle is
not moving. To turn the indicator of f ,
restart the engine. 76
140
77 76
69
Instrument Panel Indicators
K eyless Access System
Indicator Message Indicator
Electronically Controlled
Power Steering System
(ECPS) Indicator
66
Page 68 of 394
This indicator comes on f or a f ew
seconds when you turn the ignition
switch to ON (II).
Itcomesonasareminderthatyou
have turned off the Adaptive Front
Lighting System (AFS).
This indicator blinks when there is a
problem with the AFS system; you
will also see a ‘‘CHECK ADAPTIVE
FRONT LIGHTING SYSTEM’’
message on the multi-inf ormation
display (see page ). If this
happens, stop the vehicle in a saf e
place, turn the ignition switch to
ACCESSORY (I) or LOCK (0), and
restart the engine. If the indicator
does not go of f or blinks again, take
your vehicle to a dealer to have it
checked. For more inf ormation, see
page .This indicator comes on when the
security system is set. For more
inf ormation, see page .
76
107 200
A daptive Front L ighting
(A FS) System Indicator
Security System Indicator
Instrument Panel Indicators
Inst rument s and Cont rols
67
SECURITY SYSTEM INDICATOR
Page 70 of 394
ÛÝ
The multi-inf ormation display in the
instrument panel displays various
inf ormation and messages when the
ignition switch is in the ON (II)
position. Some of the messages help
you operate your vehicle more
comf ortably.
Others help to keep you aware of the
periodic maintenance your vehicle
needs f or continued trouble-f ree
driving.You can change the display and
customize your vehicle control
settings by pressing the SEL/RESET
or INFO buttons on the right side of
the steering wheel.With the ignition switch in the ON
(II) position, the lower part of the
multi-inf ormation display changes as
shown in the illustration, each time
you press the SEL/RESET button.
When you open the driver’s door, a
‘‘Welcome’’ message is shown on the
multi-inf ormation display. When you
turn the ignition switch from ON (II)
position to ACCESSORY (I) position,
a ‘‘Goodbye’’ message is shown on
the display.
Multi-Inf ormation Display
Inst rument s and Cont rols
69
SEL
RESET
BUTTON
U.S.
CANADA
INFO ( / )
BUTTONS
Page 71 of 394
The odometer shows the total
distance your vehicle has been
driven. It measures miles in U.S.
models and kilometers in Canadian
models. It is illegal under U.S.
federal law and Canadian provincial
regulations to disconnect, reset, or
alter the odometer with the intent to
change the number of miles or
kilometers indicated.This meter shows the number of
miles (U.S.) or kilometers (Canada)
driven since you last reset it. There
are two trip meters: Trip A and Trip
B. Each trip meter works
independently, so you can keep track
of two dif f erent distances.
To reset a trip meter, display it, then
press and hold the SEL/RESET
button until the number resets to
‘‘0.0’’.When you reset Trip A, average f uel
economy A is reset at the same time.
When you reset Trip B, average f uel
economy B is reset.
In the customizing mode, you can set
Trip A and average f uel economy A
to reset at the same time when you
ref uel your vehicle (see page ).
84
Multi-Inf ormation Display
Odometer T rip Meter
70
ODOMETER
TRIP METER
Page 72 of 394
This shows the outside Fahrenheit
temperature in U.S. models, and
Centigrade temperature in Canadian
models.The temperature sensor is in the
f ront bumper. The temperature
reading can be affected by heat
ref lection f rom the road surf ace,
engine heat, and the exhaust f rom
surrounding traf f ic. This can cause
an incorrect temperature reading
when your speed is under
19 mph (30 km/h). When you start
your trip, the sensor is not f ully
acclimatized, theref ore it may take
several minutes until the proper
temperature is displayed.
In certain weather conditions,
temperature readings near f reezing
(32°F, 0°C) could mean that ice is
f orming on the road surf ace.
This shows the remaining lif e of the
engine oil. It shows 100% af ter the
engine oil is replaced and the display
is reset. The engine oil lif e is
calculated based on engine operating
conditions and accumulated engine
revolutions. For more inf ormation,
see page .
You can adjust the outside
temperature display (see page ).
291
83
Outside Temperature
Engine Oil Lif e
Multi-Inf ormation Display
Inst rument s and Cont rols
71
OUTSIDE TEMPERATURE
U.S.
CANADA ENGINE OIL LIFE
Page 73 of 394
ÝÛ
Ý
With the ignition switch in the ON
(II) position, the upper part of the
display changes, as shown in the
illustration, each time you press thebutton. If you press the button,
the display returns to the previous
message.
Multi-Inf ormation Display
72
U.S. CANADA If ON
Press button
Press button
Page 74 of 394
Along with the trip meter, the trip
computer calculates these values:Range is the estimated distance you
cantravelonthefuelremainingin
the tank. This distance is estimated
f rom the f uel economy you received
over the last several miles, so it will
vary with changes in speed, traf f ic,
etc.
When you turn the ignition switch to
the LOCK (0) position, ELAPSED
TIME is reset.
When Trip A is reset, average f uel
economy A is reset at the same time.
When Trip B is reset, average f uel
economy B is reset at the same time. Instant Fuel Economy
Range
Average Vehicle Speed Elapsed Time
Average Fuel Economy
Trip Computer
Multi-Inf ormation Display
Inst rument s and Cont rols
73
Page 75 of 394
This monitor shows how much
torque is being delivered to each
wheel. For more inf ormation, see
page .Whenthetirepressuremonitoris
shown on the multi-inf ormation
display, press the SEL/RESET
button. The display changes as
shown.
You can see the pressure of each tire
in this monitor. If one or more tires
are low, inflate them to the correct
pressure. For more inf ormation, see
page .
277
272
Multi-Inf ormation Display
SH-AWD T orque Distribution
Monitor Tire Pressure Monitor
74
U.S.
Canada
Page 76 of 394
You can receive or make phone calls
f rom your cell phone through your
Acura’s HandsFreeLink (HFL)
system without touching your cell
phone.When the engine oil lif e reaches 15
percent, the display shows
‘‘SERVICE DUE SOON’’ and the
code f or the maintenance items to be
perf ormed.
When the engine oil lif e reaches 5
percent, the display shows
‘‘SERVICE DUE NOW’’ along with
the same maintenance items.Have your dealer do the indicated
maintenance as soon as you see this
message, and have them reset the
display af ter completing the service.
If you do not perf orm the indicated
maintenance or do not reset the
display, the message changes to
‘‘SERVICE PAST DUE’’ when the
engine oil lif e becomes 0 percent.
These messages appear on the multi-
inf ormation display each time you
turn the ignition switch to ON (II).
For details on engine oil lif e and
maintenance messages, ref er to page
.
Also ref er to page f or important
maintenance saf ety precautions.
To use the system, your cell phone
and the HFL system must be linked.
Not all cell phones are compatible
with this system. Ref er to page
for instructions on how to link
your cell phone to the HFL and how
to receive or make phone calls. 291
290
230
HandsFreeL ink
Maintenance Messages
Multi-Inf ormation Display
Inst rument s and Cont rols
75
TM