sensor AUDI A4 1996 B5 / 1.G AWM Engine Diagnostic Trouble Code Memory Checking Workshop Manual

Page 7 of 49

01-17
Diagnostic Trouble Code (DTC) table

Notes:

When malfunctions occur in monitored sensors or components, Diagnostic Trouble Codes (DTCs) are stored in DTC
memory with a description of the malfunction type.
"E-Gas" relevant malfunctions are also indicated in the instrument cluster by the warning lamp for Electronic Power
Control ("EPC warning lamp"); Notes for E-Gas system Page 24
-120
.
Malfunctions that worsen emissions are indicated by an exhaust warning lamp (MIL) in the instrument cluster. Notes for
Malfunction Indicator Lamp (MIL) Page 01
-3 .
The DTC table is organized by the 5 digit code at left.
If a stored DTC does not recur within the next 40 warm-up cycles, the DTC will be erased automatically.
Malfunctions that occur sporadically (temporarily occurring malfunctions) are identified with "sporadic" on display. The
word sporadic means "appearing or occurring at irregular intervals, occasional".
Do not immediately replace components that the VAS5051 suggests are faulty, instead: Check wire connections and
harness connectors to these components according to wiring diagram. Also check Ground (GND) connections according
to wiring diagram. This is particularly valid when malfunctions are displayed as "sporadic".
If the connector is disconnected from the ECM or the battery is disconnected, all adaptation values in the control module
are erased. DTC memory content will remain intact however. If the engine is started after this, a rough, uneven idle can
result. In this case, engine must be allowed to run at idle for a few minutes until adaptation procedure has been
completed.
Pa
ge 7 of 49 Dia
gnostic Trouble Code
(DTC
) memor
y, checkin
g and erasin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU07.01.2

Page 9 of 49

01-18
DTC codes 16395 - 17624

DTC
DTC text
Corrective action
SAE
VAG


P0011 16395 Bank 1 camshaft advance
adjustment
Specified value not
obtained Repair Manual, 1.8 Liter 4
-Cyl. 5V Turbo Engine Mechanical, Engine Code
(s): AWM, Repair Group 15; Checking camshaft adjustment

P0012 16396 Bank 1 camshaft
adjustment
Specified value not
obtained
P0101 16485 Mass Air Flow (MAF)
sensor -G70-
Implausible signal - Check Mass Air Flow (MAF) sensor Page 24
-59
P0102 16486 Mass Air Flow (MAF)
sensor -G70-
Signal too small
P0103 16487 Mass Air Flow (MAF)
sensor -G70-
Signal too large
Pa
ge 9 of 49 Dia
gnostic Trouble Code
(DTC
) memor
y, checkin
g and erasin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU07.01.2

Page 10 of 49

01-19

DTC
DTC text
Corrective action
SAE
VAG


P0106 16490 MAP sensor -G71-/BARO
sensor -F96-
Implausible signal
1) Repair Manual, 1.8 Liter 4
-Cyl. 5V Turbo Engine Mechanical, Engine
Code(s): AWM, Repair Group 21, Charge air system with turbocharger, checking

P0112 16496 Intake Air Temperature (IAT)
sensor -G42-
Signal too small - Intake Air Temperature (IAT) sensor, checking Page 28
-21
P0113 16497 Intake Air Temperature (IAT)
sensor -G42-
Signal too large
P0116 16500 Engine Coolant Temperature
(ECT) sensor -G62-
Implausible signal - Engine Coolant Temperature (ECT) sensor, checking Page 28
-31
P0117 16501 Engine Coolant Temperature
(ECT) sensor -G62-
Signal too small
P0118 16502 Engine Coolant Temperature
(ECT) sensor -G62-
Signal too large
Pa
ge 10 of 49 Dia
gnostic Trouble Code
(DTC
) memor
y, checkin
g and erasin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU07.01.2

Page 11 of 49

1) Intake manifold pressure is determined by the charge air pressure sensor -G31- (instead of -G71- as indicated), air
pressure is determined by the Barometric Pressure (BARO) sensor -F96- (in ECM).
Pa
ge 11 of 49 Dia
gnostic Trouble Code
(DTC
) memor
y, checkin
g and erasin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU07.01.2

Page 12 of 49

01-20

DTC
DTC text
Corrective action
SAE
VAG


P0130 16514 Bank 1, sensor 1
Electrical malfunction in
circuit - Check Oxygen Sensor (O2S) and oxygen sensor control before Three Way
Catalytic Converter (TWC) Page 24-71

P0131 16515 Bank 1, sensor 1
Voltage too low
P0132 16516 Bank 1, sensor 1
Voltage too high
P0133 16517 Bank1, sensor 1
Signal too slow
P0134 16518 Bank 1, sensor 1
No activity
P0135 16519 Bank 1, sensor 1
Heating circuit, electrical
malfunction
Pa
ge 12 of 49 Dia
gnostic Trouble Code
(DTC
) memor
y, checkin
g and erasin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU07.01.2

Page 13 of 49

01-21

DTC
DTC text
Corrective action
SAE
VAG


P0136 16520 Bank 2, sensor 1
Electrical malfunction
in circuit - Check Oxygen Sensor (O2S) and oxygen sensor control behind Three Way
Catalytic Converter (TWC) Page 24
-94

P0137 16521 Bank 2, sensor 1
Voltage too low
P0138 16522 Bank 2, sensor 1
Voltage too high
P0139 16523 Bank1, sensor 2
Signal too slow
P0140 16524 Bank 2, sensor 1
No activity
P0236 16620 Charge air pressure
sensor -G31-
Implausible signal Repair Manual, 1.8 Liter 4
-Cyl. 5V Turbo Engine Mechanical, Engine Code(s):
AWM, Repair Group 21, Charge air system with turbocharger, checking

P0237 16621 Charge air pressure
sensor -G31-
Signal too small
P0238 16622 Charge air pressure
Pa
ge 13 of 49 Dia
gnostic Trouble Code
(DTC
) memor
y, checkin
g and erasin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU07.01.2

Page 14 of 49

sensor -G31-
Signal too large
Pa
ge 14 of 49 Dia
gnostic Trouble Code
(DTC
) memor
y, checkin
g and erasin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU07.01.2

Page 15 of 49

01-22

DTC
DTC text
Corrective action
SAE
VAG


P0300 16684 Combustion misfire detected
- Check fuel pressure Page 24
-32
- Check fuel injectors Page 24
-37
P0301 16685 Cyl. 1 combustion misfire detected
- Check spark plugs and ignition wires with connector
P0302 16686 Cyl. 2 combustion misfire detected
- Ignition coils with power output stages Checking Page 28
-4
P0303 16687 Cyl. 3 combustion misfire detected
- Check misfire recognition Page 28
-55
P0304 16688 Cyl. 4 combustion misfire detected
- Fill fuel tank with fuel
P0321 16705 Engine Speed (RPM) sensor -G28-
Implausible signal - Check engine speed (RPM) sensor Page 28
-27
P0322 16706 Engine Speed (RPM) sensor -G28-
No signal
Pa
ge 15 of 49 Dia
gnostic Trouble Code
(DTC
) memor
y, checkin
g and erasin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU07.01.2

Page 16 of 49

01-23

DTC
DTC text
Corrective action
SAE
VAG


P0327 16711 Knock Sensor (KS) 1 -G61-
Signal too small - Check knock sensor Page 28
-45
P0328 16712 Knock Sensor (KS) 1 -G61-
Signal too large
P0332 16716 Knock Sensor (KS) 2 -G66-
Signal too small
P0333 16717 Knock Sensor (KS) 2 -G66-
Signal too large
P0341 16725 Camshaft Position (CMP) sensor -G40-
Implausible signal - Check Camshaft Position (CMP) sensor Page 28
-49
P0342 16726 Camshaft Position (CMP) sensor -G40-
Signal too small
P0343 16727 Camshaft Position (CMP) sensor -G40-
Signal too large
Pa
ge 16 of 49 Dia
gnostic Trouble Code
(DTC
) memor
y, checkin
g and erasin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU07.01.2

Page 21 of 49

01-28

DTC
DTC text
Corrective action
SAE
VAG


P1102 17510 Bank 1, sensor 1,
heating circuit
Short circuit to B+ - Oxygen sensor heating before catalytic converter Checking Page 24
-89
P1103 17511 Bank 2, sensor 1,
heating circuit
Performance too low - Check oxygen sensor heating behind catalytic converter Page 24
-107
P1105 17513 Bank 2, sensor 1,
heating circuit
Short circuit to B+
P1111 17519 Oxygen sensor control,
bank 1
System too lean - Check oxygen sensor control behind catalytic converter Page 24
-71
P1112 17520 Oxygen sensor control,
bank 1
System too rich
P1113 17521 Bank 1, sensor 1
Internal resistance too
high - Next, check signal wires for contact resistances Page 24
-82
; if no contact
resistances are present: Replace oxygen sensor
P1114 17522 Bank 2, sensor 1
- Next, check signal wires for contact resistances Page 24
-105
; if no contact
Pa
ge 21 of 49 Dia
gnostic Trouble Code
(DTC
) memor
y, checkin
g and erasin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU07.01.2

Page:   1-10 11-20 21-30 next >