reset Citroen BERLINGO FIRST 2012 1.G Owner's Manual

CONTENTS
2-
46 - 53  ACCESS AND STARTING
Keys 46
Alarm 48
Front and side doors 49
Rear doors 51
Opening the bonnet 53
Filling with fuel 53
54 - 57  VISIBILITY
Lights 54
Windscreen wiper stalk 55
Electric windows 56
Rear windows 56
Exterior mirrors 57
Interior mirror 57
4 - 18  FAMILIARISATION
19 - 27 
MONITORING AND DISPLAY SCREENS
Instrument panel 20
Warning lamps 21
Temperature indicator 23
Instrument panel display 24
Service indicator 24
Distance recorder zero reset 26
Lighting rheostat 26
Clock 26
28 - 33  COMFORT
Display A 27
Ventilation 28
Heating 30
Air conditioning 32
34 - 45  SEATS
Front seats 34
Rear bench seat
(4/5 seat versions) 36
Child seats 37
Locations for child seats
attached with the seat belt 40
ISOFIX mountings 41
ISOFIX child seat 42
Seat belts 44 Eco-driving 17

25MONITORING and DISPLAY SCREENS
-

Engine oil level indicator

When the ignition is switched on,
the engine oil level is indicated for
approximately 10 seconds, after the
service information.
Flashing of the six squares and the
display of "max" indicate that the oil
level is too high, which could damage
the engine.
If the excess oil is confi rmed by a
check using the dipstick, contact a
CITROËN dealer without delay. Your CITROËN dealer carries out
this operation after each service.
The reset procedure is as follows:


- Switch off the ignition.

- Press and hold button 1
.

- Switch on the ignition.
The display begins a 10 second
countdown.


- Keep button 1
pressed for 10 sec-
onds.
The display shows [=0]
and the span-
ner disappears.
Flashing of the six bars and the dis-
play of "min" indicate that the oil level
is too low, which could damage the
engine.
If the lack of oil is confi rmed by a
check using the dipstick, it is essential
that the level is topped up. Flashing of the six bars indicates a
malfunction of the oil level indicator.
There is a risk of damage to the engine.
Consult a CITROËN dealer.

The level read on the dipstick or on
the indicator will only be correct if
the vehicle is on level ground and
the engine has been off for more
than 30 minutes.




Resetting the service indicator

Oil level too high

Oil level too low
Oil level indicator fault

MONITORING and DISPLAY SCREENS
26 -
Briefl y pressing button 1
alternates
between the total and trip distance
displays.
To reset the trip recorder to zero,
when it is displayed press button 1

until zeros appear.


Total distance recorder

With the lights on, press the button
to vary the intensity of the lighting of
the instruments and controls. When
the lighting reaches the minimum (or
maximum) setting, release the button
then press it again to increase (or re-
duce) the brightness.
As soon as the lighting is of the re-
quired brightness, release the button.
LIGHTING RHEOSTAT CLOCK
Button 1
: hour adjustment
Button 2
: minute adjustment
Press and hold the button for rapid
advance.

AUDIO
11 0 -






RD3 AUDIO SYSTEM



Stalk movement



Function



1
- Press (behind) Increase volume

2
- Press (behind) Decrease volume

1 + 2
- Simultaneous press Sound cut-off (mute); restoring of the sound by pressing any button

3
- Press Automatic search of higher frequencies (radio) - Selection of the next track (CD)

4
- Press Automatic search of lower frequencies (radio) - Selection of the previous track (CD)

5
- Press the end Change of source (radio/CD)

6
- Rotation (clockwise) Selection of next preset station (radio)

7
- Rotation
(anti-clockwise) Selection of previous preset station (radio)

AUDIO
11 4 -
Briefl y press button L
or N
to search
for the station immediately above or
below. By continuing to press the
button in the direction selected, you
will obtain continuous scrolling of the
frequency.
The scrolling stops at the fi rst sta-
tion found as soon as the button is
released.
If the TA
traffi c information pro-
gramme is selected, only stations
broadcasting this type of programme
are selected.
Searching for a station occurs fi rst in
"LO"
sensitivity (selection of the most
powerful transmitters) during scan-
ning of the waveband, then in "DX"

sensitivity (selection of the weakest
and most distant transmitters).
To make a direct search in "DX"
sen-
sitivity, press button L
or N
twice.
Manual station search
Press the "MAN"
button.
Briefl y press button L
or N
to in-
crease or decrease the frequency
displayed.
By continuing to press the button in
the direction selected, you will obtain
continuous scrolling of the frequency.
The scrolling stops at the fi rst sta-
tion found as soon as the button is
released.
Pressing the "MAN"
button again
returns you to automatic station
search.

Manual presetting of stations
Select the station required.
Press one of the buttons "1"
to "6"

for more than two seconds.
The sound stops then becomes audi-
ble again, confi rming that the station
has been stored in the memory.
Automatic station search
Automatic presetting of FM
stations (autostore)
Press and hold button R
for
more than two seconds.
Your radio automatically presets the
6 stations with the strongest signal in
FM
. These stations are stored in the
FMast waveband.
If it is not possible to fi nd 6 stations,
the remaining preset positions are
empty.

Recalling preset stations
For each waveband, briefl y press
buttons "1"
to "6"
to recall the cor-
responding station.

VISUAL INDEX120 -

INSTRUMENTS AND CONTROLS

Overhead storage, sun visor,
courtesy lamp ................14, 58-59
Rear view mirror ......................... 57
Instrument panel, dials,
speedometer ............................ 20
Warning lamps,
indicator lamps ....................21-23
Indicators, displays, screen ...23-27
Setting the time, dimmer,
resetting to zero ..................25-27
Interior fuses ..........................88-90
Parking brake, handbrake .... 64, 78
Front fi ttings ...........................58-59 Electric windows ......................... 56
Hazard warning lamps ................ 60
Audio system ..................... 110-117
Fitting an audio system,
speakers ................................... 93
Heating/
Air conditioning ........ 28-31, 32-33


- vent, demisting, defrosting

- air conditioning A/C,

- air recirculation,

- ventilation.
Opening the bonnet .............. 16, 53