boot CITROEN C-ELYSÉE 2014 Handbook (in English)

49
2
Access











Boot


Opening

Unlocking and releasing the boot using the remote control
)
Press the centre button on the
remote control for more than one second.The boot lid is released and opens
slightly.
Releasing the boot from the
inside
Openin
g the boot
) Raise the boot lid to its fully open position.
)
Lower the boot lid using one of the interior grab handles.
Closing

Electric boot opening
-when the engine is running
, this
warning lamp comes on, accompanied
by a message in the multifunction
screen for a few seconds,-when the vehicle is moving (speed above 6 mph (10 km/h)), this warning lamp comes
on, accompanied by an audible signal and
a message in the multifunction screen for a few seconds.

)
Press the boot opening switch located
on the left of the dashboard (electric boot
opening).or ) Raise the control lever below the driver's
door (mechanical boot opening).
The boot lid is released and opens slightly.
Mechanical boot opening

There is no associated warning for the boot lid
not being fully closed.

Yo u should ensure that the boot is closed correctly.
If the boot is not closed correctl
y:

50
Access
Locking / unlocking from the inside
)
Press the switch.
This allows the doors and the boot to be lockedor unlocked.


Automatic central locking of the doors

The doors can lock automatically while driving (speed above 6 mph (10 km/h)).
To turn this function on or off (on by default). )press and hold the button until there is anaudible signal and/or a message in thescreen.
Locking from outsideWhen the vehicle is locked fromoutside, the switch does not operate.)To unlock the vehicle, pull theinterior door lever.
If one of the doors is open, the doorsare not locked.


Driving with the doors locked may makeaccess to the passenger compartmentby the emergency services moredifficult in an emergency.

Boot release
Unlocking
)Fold back the rear seats to gain access
to the lock from inside the boot.)Insert a small screwdriver into hole A of the lock to unlock the boot lid.
System for mechanical unlocking of the boot
in the event of a battery or central lockingmalfunction.

If your vehicle is fitted with a fixedbench seat, contact a CITROËN dealer or a qualified workshop.

57
3
Comfort





Rear seats
)Move the corresponding front seat forward
if necessary. )Check that the corresponding seat belt ispositioned correctly against the backrest and buckle it.
) Straighten the seat backrest 2
and secure it.)
Unbuckle and reposition the seat belt on
the side of the backrest.
When repositioning the seat backrest,take care not to trap the seat belts. Ensure that the backrest has latchedproperly into place.

)
Pull the strap 1
to release the seat backrest 2
. )
Fold the seat backrest 2on to the cushion.


Folding the backrest


Depending on version, your vehicle may be fitted with a fixed rear bench seat. For removing and refitting it, contact a CITROËN dealer or a qualified
workshop.
Bench seat with fixed one-piece cushion and split backrest
(left hand 2/3, right hand 1/3) which can be folded individually to adapt the load space in the boot.

Repositioning the seat backrest

62
Comfort
In order for these systems to be fully effective, follow the operation and maintenance guidelines below: )To obtain an even air distribution, take care not to obstruct the exterior air intake grilles
located at the base of the windscreen, the nozzles, the vents and the air outlets, as wellas the air extractor located in the boot. )Operate the air conditioning system for at least 5 to 10 minutes, once or twice a month to keep it in perfect working order. )Ensure that the passenger compar tment filter is in good condition and have the filter elements replaced regularly. )To ensure correct operation of the air conditioning system, you are also advised to have it checked regularly as recommended in the ser vicing booklet.)If the system does not produce cold air, switch it off and contact a CITROËN dealer or a qualified workshop.
When towing the maximum load on a steep gradient in high temperatures, switching off theair conditioning increases the available engine power and so improves the towing ability.











Recommendations for ventilation and air conditioning


If after an extended stop in sunshine, the interior temperature is very high, firstventilate the passenger compar tment for
a few moments. Put the air flow control at a setting highenough to quickly change the air in the passenger compartment.

The air conditioning system does not contain chlorine and does not present any danger to the ozone layer.


The condensation created by the air conditioning results in a discharge of water under the vehicle which isperfectly normal.

73
4
Fittings





Boot fi ttings
1.Boot lamp2.Storagebox (see details on a following page)

74
Fittings
Storage box
)Raise the boot carpet for access to the
storage box.
This has areas
for the storage of a box of spare
bulbs, a first aid kit, two warning triangles...
It also contains the vehicle tools, the temporary puncture repair kit...

96
Visibility





Headlamp adjustment
To avoid causing a nuisance to other road users, the headlamp beams should be adjustedaccording to the load in the vehicle.
This adjstment can be carried out using the control located:
- under the bonnet
,- below and to the left of the steering wheel (depending on version).


The initial setting is position "0".
01 or 2 people in the front seats.- 5 people. 15 people + maximum authorised load in the boot.-Driver + maximum authorised load in the boot.2Not used. -Not used. 3Not used.
Under the bonnet
)Raise the bonnet for access to the control (one per headlamp). Adjustment is always done clockwise.



Tr a v e l l i ng abroad

If using your vehicle in a country thatdrives on the other side of the road, theheadlamps must be adjusted to avoid dazzling on-coming drivers. Contact a CITROËN dealer or a qualified workshop.


To the left of the steering wheel

120
Practical information
boot floor. Complete s
ystem consisting of a compressor and a sealant car tridge which permits
temporary repair of a tyre so that you can rdrive to the nearest garage.It is designed to repair most punctures which could affect the tyre, located on the tyre tread or shoulder.




















Temporary puncture repair kit
Access to the kit


List of tools

All of these tools are specific to your vehicle
and can vary according to equipment. Do not
use them for other purposes.
1.12 V compressor.
Contains a sealant cartridge for the
temporary repair of a tyre and can also be used for adjusting tyre pressures.
2. Removable towing eye.
See "Towing the vehicle".

126
Practical information














Changing a wheel
The tools are installed in the boot under the floor. To gain access to them: )open the boot, )lift the floor and remove it ,)remove the storage box containing the
tools.
Access to the tools

List of tools
Procedure for changing a faulty wheel for the spare wheel using the tools provided with the vehicle.

All of these tools are specific to your
vehicle and can vary according to the level
of equipment. Do not use them for other purposes. 1. Wheelbrace.
For removing the wheel trim and removing
th
e wheel bolts. 2.Jack with integral handle.
For raising the vehicle.3."Bolt cover" tool.
For removing the bolt protectors (covers)
on alloy wheels.4. Towing eye.
See "Recovering the vehicle".

127
9
Practical information

Wheel with trim
When refitting the wheel
, refit the trim starting by placing its notch facing the valve and press around its edge withthe palm of your hand.

The spare wheel is installed in the boot under
the floor
(depending on version).
To gain access to it, refer to the paragraph"Access to the tools" on the previous page.
Access to the spare wheel

Ta k i ng out the wheel
)
Unscrew the yellow central bolt. )
Raise the spare wheel towards you from
the rear. ) Take the wheel out of the boot.