bulb Citroen C3 PICASSO DAG 2009.5 1.G Owner's Manual

!
22
INSTRUMENTS and CONTROLS
Warning lamps
When the engine is running or the vehicle is
being driven, the switching on of one of the fol-
lowing warning lamps indicates a fault which
requires action on the part of the driver. Any fault resulting in the switching on of a warning lamp must be investigated
further by reading the associated message on the multifunction screen.
If you encounter any problems, do not hesitate to contact a CITROËN dealer.

Warning lamp is on Cause Action/Observations

STOP fi xed, associated
with another
warning lamp,
accompanied by
an audible signal and a message on the screen. It is associated with the
braking system, the power
steering, the engine oil pres-
sure or the engine coolant
temperature.
Stop as soon as it is safe to do so.
Park, switch off the ignition and call a CITROËN
dealer.

Service temporarily,
accompanied
by an audible signal and a
message on the multifunction screen. A minor fault has occurred
for which there is no specifi c
warning lamp. Identify the fault by reading the message shown
on the screen, such as, for example:
- engine oil level,
- screenwash level,
- remote control battery,
- state of the bulbs,
- saturation of the particle emission fi lter (Die
sel).
For any other faults, contact a CITROËN dealer.
fi xed, accompanied
by an audible signal
and a message on the multifunction screen. A major fault has occurred
for which there is no specifi c
warning lamp. Identify the fault by reading the message shown
on the screen and contact a CITROËN dealer.


Braking fi xed.
The braking system fl uid
level has dropped signifi -
cantly. Top up with brake fl uid recommended by
CITROËN.
If the problem persists, have the system checked
by a CITROËN dealer.
+ fi xed, associated
with the ABS
warning lamp. The electronic brake force
distribution (EBFD) system
has a fault.
Have it checked by a CITROËN dealer.

!
!
126
PRACTICAL INFORMATION
CHANGING A BULB
Procedure for replacing a faulty bulb
with a new bulb.
1. Direction indicators
(H21W amber).

2. Dipped
beam
headlamps
(H7-55W).

3. Main beam headlamps (H1-55W).

4. Sidelamps
(W5W).

5. Foglamps
(PSX24W).
The headlamps are fi tted with poly-
carbonate glass with a protective
coating:

 do not clean them using a dry
or abrasive cloth, nor with a
detergent or solvent product,

 use a sponge and soapy water,

 when using a high pressure
washer on persistent marks, do
not direct at the lamps or their
outlines for too long, so as not
to damage their protective coat-
ing and seals. Front lamps

 Do not touch the bulb directly
with your fi ngers, use lint-free
cloths.
Changing a halogen bulb should
only be done after the headlamp
has been switched off for a few
minutes (risk of serious burns).
It is imperative to use only anti-
ultraviolet (UV) type bulbs in order
not to damage the headlamp.

i
!
i
127
PRACTICAL INFORMATION
Changing direction indicator bulbs
Amber coloured bulbs, such as
the direction indicators, must be
replaced with bulbs of identical
specifi cations and colour.

 Remove the plastic protective cover.

 Pull the bulb-holder and replace the
bulb.
To refi t, carry out these operations in
reverse order.
When refi tting, close the plastic
cover carefully to ensure the sealing
of the headlamp. If either of the direction indicator
warning lamps is fl ashing quickly,
one of the bulbs is faulty.
Changing main beam headlamp
bulbs

 Remove the protective plastic cover
by pulling on the tab.

 Disconnect the bulb connector.

 Move the springs to release the
bulb.

 Remove the bulb and change it.
To refi t, carry out these operations in
reverse order.
Changing sidelamp bulbs

 Remove the protective plastic cover
by pulling on the tab.

 Pull the bulb-holder.

 Remove the bulb and replace it.
To refi t, carry out these operations in
reverse order.
Changing dipped headlamp bulbs

 Remove the protective plastic cover
by pulling on the tab.

 Turn the bulb-holder by a quarter
turn.

 Remove the bulb and change it.
To refi t, carry out these operations in
reverse order.

i
i
128
PRACTICAL INFORMATION
Changing integrated direction
indicator side repeaters
Contact a CITROËN dealer to obtain
replacement repeaters.

 Insert a screwdriver on the edge of
the repeater.

 Tilt the screwdriver to extract the
repeater and remove it.

 Disconnect the repeater connector.
When removing:
- be careful not to damage the paint- work of your vehicle with the screw-
driver,
- do not allow the wire and the connector to slide inside the wing.
To refi t, carry out these operations in
reverse order.
If you experience any diffi culty
in replacing bulbs, contact your
CITROËN dealer. Changing front foglamp bulbs
To obtain them, contact your CITROËN
dealer.

 Remove the grille located under the
foglamp.

 Disconnect the bulb holder connec-
tor, by pressing on the tab.

 Remove the bulb-holber by pressing
on the 2 clips (at the top and the
bottom).
To refi t, carry out these operations in
reverse order.
If you experience any diffi culty
in replacing bulbs, contact your
CITROËN dealer.

129
PRACTICAL INFORMATION
Rear lamps

1. Stop lamps
/
sidelamps

(12VP21/5 W).

2. Foglamp,
left-hand side
(PR21W)
Reversing
lamp,
right-hand side
(P21W).

3. Direction indicators (
P21W
) Changing stop lamp/sidelamp and
direction indicator bulbs

 unscrew the two lamp unit fi xing
bolts,

 extract the lamp unit carefully pull-
ing it straight out,
 turn the bulb holder a quarter turn,

 remove the faulty bulb and replace
it.
To refi t, carry out these operations in
reverse order.

PRACTICAL INFORMATION
Changing fog/reversing lamp bulbs

 open the boot,


press on the tabs using 2 screwdrivers,

 disconnect the lamp unit connector,

 turn the bulb holder by a quarter
turn,

 remove the bulb and replace it.
To refi t, carry out these operations in
reverse order. Changing the third stop lamp bulbs
(4 x W 5 W bulbs)

 open the boot,

 remove the two plugs located on the
boot inner panel,

 press on the body of the lamp with
2 screwdrivers to remove it from its
housing,

 turn the corresponding bulb-holder
a quarter turn,

 pull the bulb and replace it.
To refi t, carry out these operations in
reverse order. Changing the number plate lamp
bulbs (W5W)

 insert a thin screwdriver into one of
the lens' exterior holes,

 push it outwards to unclip.

 remove the lens.

 pull the bulb and replace it.
To refi t, carry out these operations in
reverse order.

131
PRACTICAL INFORMATION
Interior lighting
Interior lamps (1/W5W)
Detach the cover of the interior lamp 1
with a thin screwdriver, close to the but-
ton, to access the faulty bulb.
Map reading lamps (2/W5W)
Detach the cover of the interior lamp. To
access the faulty bulb, detach the parti-
tion for the reading lamp 2 concerned,
as necessary. Footwell lamps (W5W)
Unclip the cover using a thin screw-
driver to access the faulty bulb.
Boot lamps (W5W)
Detach the unit by pushing it rear-
wards. Torch (Krypton 3.6 V)

 Open the tab.

 Push with a fl at screwdriver in the
hole under the tab and recover the
bulb unit.

 Open the bulb unit fully to change
the bulb.
Exterior mirror lamps (W5W)
Unclip the cover using a thin screw-
driver to access the faulty bulb.

i
!
144
PRACTICAL INFORMATION
ACCESSORIES
You can obtain a wide range of accessories and genuine parts from the CITROËN
dealer network.
They all benefi t from the CITROËN warranty and recommendation .
These accessories and parts, having been tested and approved f or reliability and
safety, are all adapted to your CITROËN vehicle.
The product range is structured around 5 categories:
"Styling":
seat covers, 15, 16 and 17 inch alloy
wheels, wheel embellishers, styling
strips...
"Protection":
anti-theft alarm, fi rst aid kit, warning tri-
angle, high visibility jacket, snow chains
and non-slip covers, front foglamp kit,
parking assistance system...
* To avoid any risk of jamming of the pedals:
- ensure that the mat is positioned and secured correctly,
- never fi t one mat on top of another.
"In-car technology":
Bluetooth
®
hands free kit, audio sys-
tems, portable navigation system,
auxiliary audio cable (e.g. for an MP3
connection), loudspeakers, USB Box,
portable video screen...
"Comfort and Leisure":
mats * , boot tray, sun blinds, roof bars,
towbar, bicycle carrier, ski carrier, dog
guard, luggage net, booster seats and
child seats... "Universal":
screenwash fl uid, maintenance and clean-
ing products for interior and exterior.
Depending on the country in which
the vehicle is sold, it is compulso-
ry to have a high visibilty jacket,
warning triangle and spare bulbs
available in the vehicle.
The fi tting of electrical equipment or
accessories which are not recom-
mended by CITROËN may result in
a failure of your vehicle's electronic
system and excessive power con-
sumption.
Please take note of this specifi c
warning. You are advised to contact
your dealer to be shown the range
of recommended equipment and
accessories.