remove seats Citroen C3 PICASSO DAG 2010.5 1.G Owner's Manual

Page 48 of 224

!
50
COMFORT
 Press the control located under the
front end of the armrest to release it.

 Move it to the low position.

 Raise it notch by notch to reach the
desired position.
To place the armrest in the vertical posi-
tion, raise it and push it backwards be-
yond the point of resistance.
Head restraint height adjustment

 To raise the head restraint, pull it up-
wards.

 To remove the head restraint, press
the lug A and pull the head restraint
upwards.

 To put the head restraint back in
place, engage the head restraint
stems in the openings keeping them
in line with the seat back.

 To lower the head restraint, press
the lug A and the head restraint at
the same time. The head restraint is fi tted with a
frame with notches which prevents
it from lowering; this is a safety de-
vice in case of impact.

The adjustment is correct when
the upper edge of the head re-
straint is level with the top of the
head.
Never drive with the head restraints
removed; they must be in place and
adjusted correctly.
Adjusting the armrest

Additional adjustments Heated seats control

 Use the adjustment dial, placed on
the side of each front seat, to switch
on and select the level of heating re-
quired:
0 : Off.
1 : Low.
2 : Medium.
3 : High.
With the engine running, the front seats
can be heated separately.

Page 51 of 224

i
i
i
52
COMFORT Fully-folded position Flaps behind the rear seats

 Move the corresponding front seat
forward if necessary.

 Put the rear seat in the fully back po-
sition.

 Place the head restraints in the low
position.

 Pull control A , to release the seat
back which folds easily onto the
seat cushion.
The seat fi ts into the fl oor, providing a
continuous level fl oor.
To put the seat back in position:

 Pull the seat back backwards until it
locks in place.

 Return the seat cushion to the de-
sired position. Flaps
B fi tted to the back of the rear
seat close the boot fl oor when the rear
seats are in the folded position.
Pull on the upper section of the fl aps to
release them.
They then provide a continuous level
fl oor.
Adjusting the head restraints
The 1/3 - 2/3 rear seat is fi tted with head
restraints.
They have a high position (for comfort
and safety) and a low position (for rear
visibility).
They may be removed, as follows:

 pull the head restraint upwards as
far as possible,

 then, press on the lug A .
When you are carrying rear pas-
sengers, never drive with the head
restraints removed. They must be se-
cured in place in the high position. When putting back in position,
take care not to jam the seat
belts. Use the fl aps only with the adjust-
able boot fl oor in the high position
and the bench rear seat folded and
in the fully back position.
Ensure that the fl aps are correctly
fi xed to the backrest before operat-
ing the seats.