M.dan Citroen C4 2005 2.G Workshop Manual

Page 403 of 462

Downloaded from www.Manualslib.com manuals search engine 397
AXLES
SUSPENSION
STEERING
TIGHTENING TORQUES: POWER-ASSISTED STEERING
Tightening torques (m.daN).
Unions between pump unions and power steering valve: 2 ± 0.3
(16)Fixing screw: 2.2 ± 0.3
(17)Fixing screw: 2.2 ± 0.3
(18) Fixing screw: 2.2 ± 0.3
NOTE: Coat the threads with product «E3».
A pressure switch is implanted in the hydraulic piping between the high
pressure pump and the power steering valve.
- Opening pressure = 30 / 35 bars.
- Closing pressure = 25 barsminimum.
Tightening torque = 2 ± 0.2.
B3EP118D
XSARA PICASSO
Angl.-t2-page361-397-2005 9/01/06 10:22 Page 397

Page 419 of 462

Downloaded from www.Manualslib.com manuals search engine 413
BRAKES
BRAKE SPECIFICATIONS
Gyrometer sensor (7) Hydraulic block
C4AP17YCB3HP002C
Observations Part no. Supplier Components
XSARA
ESP hydraulic
blockBOSCH 5.7 ESPLocated on the front
LH wheelarch:
4 adjustmentchannels.IMPERATIVE: Respect the direction of fitting of the gyrometer/
accelerometer sensor
(connector towards the rear of the vehicle).WARNING: The gyrometer/accelerometer sensor should not be
subjected to any impact. Any gyrometer/accelerometer sensor
having suffered an impact must be replaced.
Tightening torque (15): 0,6 ± 0,1 m.daN.
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 413

Page 420 of 462

Downloaded from www.Manualslib.com manuals search engine 414
BRAKES
TIGHTENING TORQUES: BRAKING SYSTEM
XSARA
Tighten the nuts (1)to 2.3 m.daN.
The shaft (2)is held in place by a plastic clip.
B3FP10YD
Angl.-t2-PAGE398-427-2005 9/01/06 10:24 Page 414

Page 442 of 462

Downloaded from www.Manualslib.com manuals search engine 436
AIR
CONDITIONING
SPECIAL FEATURES: AIR CONDITIONING SYSTEM (R 134.a)
Changing the filtering/drying cartridge
Move aside the radiator/condenser assembly.
Remove the plug (6), using tool [2].
Support the radiator/condenser assembly thus moved aside.
Remove the filtering/drying cartridge (7), using pliers.
Refitting.
Refit the filtering/drying cartridge (7).
Clean the threads of the plug (6).
It is essntial to change the O-ring seals (8).
Lubricate the O-ring seals (8)with aircon compressor oil.
Refit:
- The plug (6), using tool [2], tighten to 1,4 ± 0,2 m.daN.
- The brackets (5).
- The screws (4).
- The cardboard from the radiator harness.
- The nuts (1).
- The air filter assembly (3).
Couple the hose (2).
Recharge the circuit (R134.a)
(according to equipment) (see corresponding
operation).
Check the operation of the air conditioning.
C5HP14NCC5HP14PCC5HP14QC
XSARA PICASSO
Angl.-t2-page428-456-2005 9/01/06 10:25 Page 436

Page 453 of 462

Downloaded from www.Manualslib.com manuals search engine 447
AIR
CONDITIONING
(1)High pressure valve
(2)Low pressure valve
(3)Pressostat
(tighten to 0,6 m.daN)
(4)Aircon pressure reducer
(5)Filtering and drying cartridge
(6)Buffer capacity
«a»Outlet and inlet of the aircon pressure reducer, tighten to 0,8 m.daN
«b»Outlet and inlet of the aircon compressor, tighten to 0,7 m.daN
AIR CONDITIONING SYSTEM (R 134.a)
C5HP1BHP
Engines: ET3J4 - TU5JP4
C4
Angl.-t2-page428-456-2005 9/01/06 10:25 Page 447

Page 454 of 462

Downloaded from www.Manualslib.com manuals search engine AIR
CONDITIONING
448
(1)High pressure valve
(2)Low pressure valve
(3)Pressostat
(tighten to 0,6 m.daN)
(4)Aircon pressure reducer
(5)Filtering and drying cartridge
(6)Buffer capacity
«a»Outlet and inlet of the aircon pressure reducer, tighten to 0,8 m.daN
«b»Outlet and inlet of the aircon compressor, tighten to 0,7 m.daN
«c»and «d»Outlet and inlet of the aircon condenser, tighten to 0,6 m.daN
C5HP1BMP
AIR CONDITIONING SYSTEM (R 134.a)
Engine: EW10J4
C4
Angl.-t2-page428-456-2005 9/01/06 10:25 Page 448

Page 455 of 462

Downloaded from www.Manualslib.com manuals search engine AIR
CONDITIONING
449
(1)High pressure valve
(2)Low pressure valve
(3)Pressostat
(tighten to 0,6 m.daN)
(4)Aircon pressure reducer
(5)Filtering and drying cartridge
(6)Buffer capacity
«a»Outlet and inlet of the aircon pressure reducer, tighten to 0,8 m.daN
«b»Outlet and inlet of the aircon compressor, tighten to 0,7 m.daN
«c»and «d»Outlet and inlet of the aircon condenser, tighten to 0,6 m.daN
AIR CONDITIONING SYSTEM (R 134.a)
C5HP1BLP
Engines: EW10A - EW10J4S
C4
Angl.-t2-page428-456-2005 9/01/06 10:25 Page 449

Page 456 of 462

Downloaded from www.Manualslib.com manuals search engine AIR
CONDITIONING
450
(1) High pressure valve
(2)Low pressure valve
(3)Pressostat
(tighten to 0,6 m.daN)
(4)Aircon pressure reducer
(5)Filtering and drying cartridge
(6)Buffer capacity
«a»Outlet and inlet of the aircon pressure reducer, tighten to 0,8 m.daN
«b»Outlet and inlet of the aircon compressor, tighten to 0,7 m.daN
«c»and «d»Outlet and inlet of the aircon condenser, tighten to 0,6 m.daN
C5HP1BNP
AIR CONDITIONING SYSTEM (R 134.a)
Engine: DV6
C4
Angl.-t2-page428-456-2005 9/01/06 10:25 Page 450

Page 457 of 462

Downloaded from www.Manualslib.com manuals search engine AIR
CONDITIONING
451
(1)High pressure valve
(2)Low pressure valve
(3)Pressostat
(tighten to 0,6 m.daN)
(4)Aircon pressure reducer
(5)Filtering and drying cartridge
(6)Buffer capacity
«a»Outlet and inlet of the aircon pressure reducer, tighten to 0,8 m.daN
«b»Outlet and inlet of the aircon compressor, tighten to 0,7 m.daN
«c»and «d»Outlet and inlet of the aircon condenser, tighten to 0,6 m.daN
C5HP1BJP
AIR CONDITIONING SYSTEM (R 134.a)
Engine: DW10BTED4
C4
Angl.-t2-page428-456-2005 9/01/06 10:25 Page 451

Page 458 of 462

Downloaded from www.Manualslib.com manuals search engine 452
AIR
CONDITIONING
(1)High pressure valve
(2)Low pressure valve
(3)Pressostat
(4)Dryer
NOTE:The method of connecting the High Pressure and Low Pressure compressor
pipes may vary according to engine type.
T
ightening torques (m.daN).
(a) : 0,8
(b) : 4 ± 0,4
XSARAAIR CONDITIONING SYSTEM (R 134.a)
C5HP16RP
Engines: TU3JP - TU5JP4 - EW10J4 - DV4TD - DW8B - DW10TD - DW10ATED
Angl.-t2-page428-456-2005 9/01/06 10:25 Page 452

Page:   < prev 1-10 ... 141-150 151-160 161-170 171-180 181-190 191-200 next >