bulb Citroen C4 PICASSO 2008 1.G Owner's Manual

12
3
4
182
VIFRONT LENS
 Dipped beam
 Main beam
 Sidelamp
 Direction indicator
Note : A slight misting may appear on the internal sur-face of the headlamp glass in some climatic conditions (e.g. low temperature or humidity) ; this disappears af-ter the lamps have been on for a few minutes.
C H A N G I N G B U L B SH A L O G E N H E A D L A M P S
Dipped beam
1. Remove the rubber plug.
2. Rotate the bulb-holder a quarter turn anti-clockwise and remove it from its housing.
3. Replace the bulb H7.
4. Reposition the bulb-holder by pushing it in, tighte -ning it by a quarter turn (clockwise).
5. Put back the rubber plug.
Changing a halogen bulb should only be done after the headlamp has been switched off for a few minutes (risk of serious burns).
Do not touch the bulb directly with your fi ngers, use lint-fre e cloths.
It is imperative to use only anti-U.V. type bulbs in order not to damage the headlamp.
When using a high-pressure washer on persistant marks, do not direct at the lamps or their outlines for too long, so as not to damage their coating and their seals.

VI
183
Main beam
1. Remove the rubber plug.
2. Detach the clips by lowering them on each side of the bulb.
3. Pull on t he bulb- holder t o remove it.
4. Replace the bulb H1.
5. Push the bulb-holder back into its housing.
6. Reattach the clips.
7. Put back the rubber plug.
Sidelamp
1. Rotate the bulb-holder a quarter turn anti-clockwise.
2. Remove it from its housing.
3. Replace the bulb H6W.
4. Reposition the bulb-holder.
5. Rotate it a quarter turn clock-wise to reposition in its housing.
Direction indicator
1. The direction indicator bulb is located underneath the main beam bulb. Remove the rub-ber plug.
2. Pull on the bulb-holder to re-move it.
3. Replace the bulb H21.
4. Reposition the bulb-holder in the bracket and push it in.
5. Put back the rubber plug.
C H A N G I N G B U L B SH A L O G E N H E A D L A M P S

12
3
4
184
VI Main beam (H7)
1. Remove the rubber plug.
2. Rotate the bulb-holder a quarter turn anti-clockwise and remove it from its housing.
3. Replace the bulb H7.
4. Reposition the bulb-holder by pushing it in, tighte -ning it by a quarter turn (clockwise).
5. Put back the rubber plug.
FRONT LENS WITH XENON DUAL-FUNCTIONDIRECTIONAL HEADLAMPS
Xenon dual-function headlamp (dipped/main beam)
C H A N G I N G B U L B SX E N O N D U A L - F U N C T I O N H E A D L A M P S
If the headlamp bears this symbol, any operation to change the Xenon dual-function directional headlamp D1S is the preserve of professionals (risk of electrocution).
Contact a CITROËN dealer.
It is recommended to change both bulbs at the same time if one of them is faulty. Sidelamp (see “Halogen headlamps”)
 Direction indicator (see “Halogen headlamps”)
When using a high-pressure washer on persistant marks, do not direct at the lamps or their outlines for too long, so as not to damage their coating and their seals.

1
23
A
B
VI
185
REAR LENS
Note the bulb that is faulty.
Bulbs
 Direction indicator: PY21W.
 Stoplamp and sidelamp :P21/5W.
 Reversing lamp : P21W.
Rear lamp units on the bodywork
1. With the tailgate open, press on the plastic cover A, located close to the lens, to release it from its housing.2. Undo the two screws B on the side of the lens and detach the lamp by pulling it rearwards.3. Disconnect the connector linking the lens unit with the tailgate.4. Remove the bulb-holder.5. Replace the bulbs. To remove a bulb, rotate it a quarter turn. To refi t the bulb, rotate it a quarter turn in the other direction.6. Reposition the bulb-holder.7. Reconnect the connector to the lens unit.8. Reattach the lamp unit on the body work and do up the two screws.9. Reposition the plastic cover by exerting pressure.
Rear lamps on the tailgate
1. With the boot open, remove the plastic cover on the tailgate.
2. Remove the bulb-holder from its housing.
3. Replace the bulb. To remove a bulb, rotate it a quarter turn. To refi t the bulb, rotate it a quarter turn in the other direction.
4. Reposition the bulb-holder.
5. Refi t the plastic cover.
C H A N G I N G B U L B SR E A R L E N S - C 4 P I C A S S O

3
2
1
4
186
VIREAR LENS
Note the bulb that is faulty.
Bulbs :
 Direction indicator : PY21W.
 Stoplamp : P21W.
 Reversing lamp : P21W.
 Sidelamp : LED
Contact a CITROËN dealer.
Rear lamps
1. With the tailgate open, undo the 3 screws located on the side of the lens unit and pull it rearwards to detach.
2. Disconnect the connector lin-king the lens unit to the boot. Do not disconnect the LEDs.
3. Remove the seal.
4. Remove the bulb-holder.
5. Replace the bulbs. To remove a bulb, rotate it a quarter turn. To fi t the bulb, rotate it a quarter turn in the other direction.
6. Reposition the bulb-holder.
7. Put back the seal.
8. Reconnect the connector to the lens unit.
9. Stow the harness in the open-ing provided in the bodywork.
10. Reattach the lens unit on the bodywork and do up the 3 screws.
Third stoplamp with bulb
1. With the boot open, detach the interior trim.
2. Undo the nuts.
3. Using a thin screwdriver, de-tach the 3 retaining lugs.
4. Remove the lamp via the ex-terior of the tailgate.
5. Remove the bulb-holder.
6. Change the faulty bulb(s).
Check that the vehicle lamps work correctly after each operation.
C H A N G I N G B U L B S
R E A R L E N S - G R A N D C 4 P I C A S S O
Third stoplamp with LED
Contact a CITROËN dealer

12
VI
187
C H A N G I N G B U L B S
Number plate lamp
1. Insert a thin screwdriver in one of the holes on the outside of the plastic cover.
2. Push outwards.
3. Remove the plastic cover.
4. Pull on the bulb to remove it.
5. Replace the faulty bulb W5W.
Foglamp
1. Pass your hand underneath the bumper to reach the bulb-holder.
2. Rotate the bulb-holder a quar-ter turn.
3. Pull on the bulb-holder.
4. Rotate the bulb a quarter turn to remove it.
5. Replace the bulb P21W.
6. Fit the bulb.
7. Reposition the bulb-holder by rotating it a quarter turn.
Front foglamps
1. Insert the key in the notch 1, tilt-ing the bulb-holder cover locat-ed underneath the bumper, then insert the key in the notch 2 to remove it.
2. Undo the lens.
3. Tilt the bulb-holder.
4. Change the bulb H11.
5. Reposition the bulb-holder.
6. Do up the lens and refi t the bulb-holder cover fi rmly in place.

2
2
1
188
VIDirection indicators side repeaters in the rear view mirrors
To change the side repeater, press fi rmly downwards on the zone indi-cated by the arrow, then pull out the side repeater bulb.
C H A N G I N G B U L B S
Interior lamp (1)
Detach the cover of the interior lamp 1 with a thin screwdriver close to the button, to access the bulb.
Bulb : W 5 W
Spotlamps (2)
Detach the cover of the interior lamp. To access the bulb, detach the partition for the spotlamp con-cerned, as necessary.
Bulb: W 5 W
Boot lamps
Detach the unit by pushing it rear-wards.
Bulb: W 5 W
Torch
1. Open the tab.
2. Push with a fl at screwdriver in the hole under the tab and re-cover the bulb unit.
3. Open the bulb unit fully to change the bulb.
Bulb: Krypton 3.6V.

198
VI
A C C E S S O R I E S
A wide range of accessories and parts are available from the CITROËN network.and parts are available and parts
These accessories and parts have been tested and approved for reli-ability and safety.
They are all adapted to the needs of your vehicle and come with a CITROËN guarantee.of your vehicle and come your vehicle
There are 5 families into which these accessories and parts are arranged :
"Comfort and leisure" :
fl oor mats*, boot tray, boot carpet, sun visors, mini-bar, fragrance dif-fuser, boosters and child seats, roof bars, bicycle carrier, ski carri-ers, roof box, towbars, etc.
The fi tting of electrical equipment or accesso-ries which are not rec-ommended by CITROËN may result in a failure of your ve-hicle’s electrical system and overconsumption.
We ask you to take note of this warning and advise you to con-tact a dealer who can show you the range of approved equip-ment and accessories.
"Safety" :
anti-intrusion alarm, anti wheel theft, stolen vehicle locating, medical kit, warning triangle, high-visibility vest, dog guard, snow chains, front foglamps kit, rear parking assistance, etc.
"Navigation and communication" :
audio systems, navigation sys-tems, CD changer, DVD player, Bluetooth hands-free kit, auxiliary cable to connect a portable MP3 player, USB Box, loudspeakers, etc.
Depending on the country of sale, the law may require you to carry high-visibility vests, warn-ing triangles and replacement bulbs in the vehicle.
"Personalisation" :
seat covers, alloy wheels, wheel trims, mud fl aps, door sill protec-tors, etc.
"Boutique products" :
screen wash fl uid, cleaning and in-terior/exterior maintenance prod-ucts, bodywork touch-up aerosol and pen, etc.
* To avoid any risk of interfering with the pedals :
- check that the fl oor mat is cor-rectly positioned and fi xed,
- never use more than one fl oor mat.