service interval Citroen C4 PICASSO RHD 2014.5 1.G Owner's Manual

Page 34 of 428

32
Warning / indicator lampStateCause Action / Observations
Service temporarily,
 a

ccompanied   by   a  
m

essage.One
  or   more   minor   faults   for   which  
t

here   is   no   specific   warning   lamp  
h

ave   been   detected.Identify
  the   cause   of   the   fault   using   the   message  
d

isplayed   in   the   screen.
You
  can   deal   with   some   problems   yourself,   such   as   a  
d

oor   open   or   the   start   of   saturation   of   the   particle   filter  
(

as   soon   as   the   traffic   conditions   allow,   regenerate  
t

he   filter   by   driving   at   a   speed   of   at   least   40   mph  
(

60 km/h),   until   the   warning   lamp   goes   off).
For
  any   other   problems,   such   as   a   fault   with   the   tyre  
u

nder   inflation   detection   system,   contact   a   CITROËN  
d

ealer   or   a   qualified   workshop.
fixed,
  accompanied   by  
a

  message.One
  or   more   major   faults   for   which  
t

here   is   no   specific   warning   lamp  
h

ave   been   detected.Identify
  the   cause   of   the   fault   using   the   message  
d

isplayed   in   the   screen;   you   must   then   contact   a  
C

ITROËN   dealer   or   a   qualified   workshop.
fixed,
  associated  
w

ith   the   flashing   and  
t

hen   fixed   display   of  
t

he   service   indicator  
span

ner.The
  servicing   interval   has   been  
e

xceeded.Only
  on   BlueHDi   Diesel   versions.
Your
  vehicle   must   be   serviced   as   soon   as   possible.
Monitoring

Page 316 of 428

314
Topping up the engine oil level
Refer to the "Petrol engine" or "Diesel engine" section for the location of the oil filler cap in the
engine
  compartment   of   your   vehicle.
F

U
nscrew the oil filler cap to reveal the filler
aperture.
F
 
A
dd   oil   in   small   quantities,   avoiding   any  
s

pills   on   engine   components   (risk   of   fire).
F
 
W
ait   a   few   minutes   before   checking   the  
l

evel   again   using   the   dipstick.
F
 
A
dd   more   oil   if   necessary.
F
 
A
fter   checking   the   level,   carefully   refit   the  
o

il   filler   cap   and   the   dipstick   in   its   tube.
Engine oil change
Refer to the manufacturer's service schedule for   details   of   the   interval   for   this   operation.
In
  order   to   maintain   the   reliability   of   the   engine  
a

nd   emission   control   system,   never   use  
a

dditives   in   the   engine   oil.
After
  topping   up   the   oil,   the   check   when  
s

witching   on   the   ignition   with   the   oil  
l

evel   indicator   in   the   instrument   panel  
i

s   not   valid   during   the   30   minutes   after  
t

opping   up.
Oil grade
Before topping-up the oil or changing the oil, c
heck   that   the   oil   is   the   correct   grade   for   your  
e

ngine   and   conforms   to   the   manufacturer's  
r

ecommendations.
Checks

Page 317 of 428

315
Coolant level
The coolant level should be close to   the   "MA X"   mark   but   should   never  
e

xceed   it.
In
 
addition,   as   the   cooling   system   is   pressurised,
 w

ait
 
at
 
least   one   hour   after   switching   off   the
 e

ngine
 
before   carrying   out   any   work.
To
 
avoid
 
any   risk   of   scalding,   unscrew   the   cap
 b

y
 
two
 
turns   to   allow   the   pressure   to   drop.   When
 t

he
 
pressure   has   dropped,   remove   the   cap   and
 t

op
 
up
 
the
  level.
Fluid specification
The coolant must conform to the ma nufacturer's r ecommendations.
The
 
brake
 
fluid
 
level
 
should
 
be
 
close
 
t

o
 
the
 
"MA X"
 
mark.
 
If
 
it
 
is
 
not,
 
check
 
t

he
 
brake
 
pad
 
wear.
Brake fluid level
Changing the fluid
Refer to the manufacturer's service schedule f
or   details   of   the   interval   for   this   operation.
Fluid specification
The brake fluid must conform to the manufacturer's r ecommendations. The cooling fan may star t after switching
off the engine: take care with ar ticles and
clothing that might be caught by the fan
blades. When   the   engine   is   warm,   the   temperature   of  
t

he   coolant   is   regulated   by   the   fan.
8
Checks

Page 319 of 428

317
Checks
12 V battery
The battery does not require any maintenance.However, check that the terminals are clean and   correctly   tightened,   particularly   in   summer a

nd   winter.
Refer to the manufacturer's service   schedule   for   details   of   the  
r

eplacement   intervals   for   these  
c

omponents.
Air filter and passenger compartment filter
Replace the oil filter each time the e ngine   oil   is   changed.
Refer
  to   the   manufacturer's  
s

ervice   schedule   for   details   of  
t

he   replacement   interval   for   this  
c

omponent.
Oil filterThe presence of this label, in particular with
the   Stop   &   Start   system,   indicates   the   use   of  
a

  specific   12   V   lead-acid   battery   with   special  
t

echnology   and   specification.   The   involvement  
o

f   a   CITROËN   dealer   or   a   qualified   workshop  
i

s   essential   when   replacing   or   disconnecting  
t

he   battery.
Unless
  other wise   indicated,   check   these   components   in   accordance   with   the   manufacturer's   service   schedule   and   according   to   your   engine.
Other wise,   have   them   checked   by   a   CITROËN   dealer   or   a   qualified   workshop.
Depending   on   the   environment   (e.g.   dusty  
a

tmosphere)   and   the   use   of   the   vehicle  
(e.g.   city   driving),   replace them twice as often
if necessary .
A   clogged   passenger   compartment   filter   may  
h

ave   an   adverse   effect   on   the   per formance  
o

f   the   air   conditioning   system   and   generate  
u

ndesirable
 o
dours.
Particle filter (Diesel)
The start of saturation of the
particle
  filter   is   indicated   by   the  
f

ixed   illumination   of   this   warning  
l

amp   accompanied   by   a   warning  
m

essage.
As
 
soon   as   the   traffic   conditions   permit,  
r

egenerate   the   filter   by   driving   at   a  
s

peed
 
of   at   least   40   mph   (60   km/h)   until  
t

he
 
warning   lamp   goes   off.
If
 
the
 
warning   lamp   stays   on,   this  
i

ndicates   a   low   additive   level.
on a n

ew vehicle, the first particle
filter
 
regeneration   operations   may   be  
a

ccompanied   by   a   "burning"   smell,  
w

hich
 
is   per fectly   normal.
Following
  prolonged   operation   of   the  
v

ehicle
 
at   very   low   speed   or   at   idle,  
y

ou
 
may,   in   exceptional   circumstances,  
n

otice
 
the   emission   of   water   vapour   at  
t

he
 
exhaust   on   acceleration.   This   does  
n

ot affect the behaviour of the vehicle
or
 
the
 
environment.
When
 
carrying
 
out
 
work
 
on
 
the
 
battery,
 
refer
 
t

o
 
the
 
"12
 
V
 
battery"
 
section
 
for
 
details
 
of
 
the
 
p

recautions
 
to
 
be
 
taken
 
before
 
disconnecting
 
t

he
 
battery
 
and
 
following
 
its
 
reconnection.
8
Checks

Page 320 of 428

318
Brake wear depends on the style of   driving,   particularly   in   the   case  
o

f   vehicles   used   in   town,   over   short  
d

istances.   It   may   be   necessary   to  
h

ave
 
the
 
condition   of   the   brakes   checked,   even  
b

etween
 v
ehicle
 s
ervices.
Unless
 
there   is   a   leak   in   the   circuit,   a   drop   in  
t

he
 
brake
  fluid   level   indicates   that   the   brake  
p

ads
 
are
 
worn.
Brake pads
For information on checking brake d isc   wear,   contact   a   CITROËN   dealer  
o

r   a   qualified   workshop.
Brake disc wear
Only use products recommended by CITROËN   or   products   of   equivalent  
q

uality
 an
d
 sp
ecification.
In
  order   to   optimise   the   operation   of  
u

nits   as   important   as   those   in   the  
b

raking   system,   CITROËN   selects   and  
o

ffers   very   specific   products.
After
  washing   the   vehicle,   dampness,  
o

r   in   wintry   conditions,   ice   can   form  
o

n   the   brake   discs   and   pads:   braking  
e

fficiency   may   be   reduced.   Make   light  
b

rake   applications   to   dry   and   defrost  
t

he   brakes.
Electric parking brake
For more information, refer to the "Electric parking   brake   -   Operating   faults"   section.
This
  system   does   not   require   any  
r

outine   servicing.   However,   in   the  
e

vent   of   a   problem,   have   the   system  
c

hecked   by   a   CITROËN   dealer   or   a  
q

ualified
 w
orkshop.
Manual gearbox
The gearbox does not require any m
aintenance   (no   oil   change).
Refer
  to   the   manufacturer's   service  
s

chedule   for   the   checking   interval   for  
t

his
 c
omponent.
Electronic gearbox
The gearbox does not require any maintenance   (no   oil   change).
Refer
  to   the   manufacturer's   service  
s

chedule   for   details   of   the   checking  
i

nterval   for   this   component.
Automatic gearbox
The gearbox does not require any maintenance   (no   oil   change).
Refer
  to   the   manufacturer's   service  
s

chedule   for   details   of   the   level  
c

hecking   interval   for   this   component.To
  avoid   damaging   the   electrical   units,  
n

ever use   a   high   pressure   jet   wash   in  
t

he   engine   compartment.
Checks