glove box Citroen C4 RHD 2012 2.G Owner's Manual

Page 12 of 324

10
INSTRUMENTS AND CONTROLS




1.
Steering wheel adjustment control.

2.
Steering mounted control paddles
for the 6-speed electronic gearbox
system.

3.
Lighting and direction indicators
control stalk.

4.
Speaker (tweeter).

5.
Windscreen demisting vent.

6.
Sunshine sensor.

7.
Passenger’s airbag.

8.
Glove box/Audio/video sockets/
Passenger’s airbag deactivation
switch/Fusebox.

9.
Bonnet release.

10.
Heated seat control.

11 .
Lumbar massage control.

12.
Electric parking brake.

13.
Gear lever, 6-speed electronic
gearbox system.

14.
Large multifunctional storage unit.

Page 21 of 324

19
FAMILIARISATION
PASSENGER SAFETY - STARTING


Passenger’s front airbag
Seat belts and passenger’s
front airbag
Ignition switch



1.
Open the glove box.

2.
Insert the key.

3.
Select the position:
"OFF"
(deactivation), with "rear fac-
ing" child seat,
"ON"
(activation), with front passen-
ger or "forwards facing" child seat.

4.
Remove the key keeping the switch
in the new position.



138


A.
Front left seat belt not fastened/
unfastened warning lamp.

B.
Front right seat belt not fastened/
unfastened warning lamp.

C.
Rear right seat belt unfastened
warning lamp.

D.
Rear centre seat belt unfastened
warning lamp.

E.
Rear left seat belt unfastened warning
lamp.

F.
Passenger’s front airbag deactivated
warning lamp.

G.
Passenger’s front airbag activated
warning lamp.



135, 139


1.
Stop
position.

2.
Ignition on
position.

3.
Starting
position.



81
When switching the ignition on or off,
the speedometer needle and the rev
counter and fuel gauge bars go full trav-
el and then return to 0.

Page 44 of 324

1
MONITORING
42




Passenger's
airbag system
fi xed in the
seat belt and
passenger's front
airbag warning
lamps display. The control switch, located
in the glove box, has been
placed in the "ON"
position.
The passenger's front airbag
is activated.
In this case, do not install a
"rear facing" child seat. Move the control switch to the "OFF"

position to deactivate the passenger's
front airbag.
In this case, you can install a "rear
facing" child seat.

Warning lamp



is on



Cause



Action/Observations






Stop & Start


fi xed.
When the vehicle stops (red
lights, traffi c jams, ...) the Stop &
Start system has put the engine
into STOP mode. The warning lamp goes off and the
engine restarts automatically in START
mode, as soon as you want to move off.

fl ashes for a few
seconds, then
goes off. STOP mode is temporarily
unavailable.
or
START mode is invoked
automatically. Refer to "Driving - § Stop & Start" for
special cases with STOP mode and
START mode.


Parking space
sensors


fi xed. The parking space sensors
function is selected. To start measurement, operate the direction
indicator on the side of the space to be
measured, and do not exceed 12 mph
(20 km/h). A message is displayed once the
measurement has been completed.





Automatic
wiping


fi xed. The wiper control is pushed
downwards. Automatic front wiping is activated.
To deactivate automatic wiping, operate
the control stalk downwards or put the
stalk into another position.


Lighting
dimmer


fi xed. The lighting dimmer is making
an adjustment. You can adjust the level of illumination of
the instruments between 1 and 16.

Page 45 of 324

1
MONITORING
43










Deactivation indicator lamps
If one of the following indicator lamps comes on, this confi rms that the corresponding system has been switched off intentionally.
This is may be accompanied by an audible signal and a message on the multifunction screen.



Warning lamp



is on



Cause



Action/Observations








Passenger's
airbag system


fi xed in the
instrument panel
and/or seat
belt and front
passenger's
airbag warning
lamps display. The control switch, located
in the glove box, is set to the
"OFF" position.
The passenger's front airbag
is deactivated. Set the control to the "ON" position to
activate the passenger's front airbag.
In this case, do not fi t a child seat in the
rear-facing position.





ESP/ASR


fi xed. The button, located at the
bottom left of the dashboard,
is pressed. Its indicator lamp
is on.
The ESP/ASR is deactivated.
ESP: electronic stability
programme.
ASR: anti-slip regulation. Press the button to activate the ESP/ASR.
Its indicator lamp goes off.
The ESP/ASR system is activated
automatically when the vehicle is started.
If deactivated, the system is reactivated
automatically from around 30 mph
(50 km/h).

Page 112 of 324

6
FITTINGS
110




















INTERIOR FITTINGS



1.
Grab handle


2.
Sun visor

(see details on a following page)

3.
Ticket/card holder


4.
Oddments storage


5.
Illuminated
glove box

(see details on a following page)

6.
Door pocket

s


7.
Large open storage box (without
audio system)

or
Small storage box with fl ap (with
audio system)


8.
Small open storage box (without
audio system)


9.
USB port/Auxiliary socket

(see details on a following page)

10.
Cigarette lighter/12 V accessory
socket

(see details on following pages)

11 .
Portable ashtray

(see details on following pages)

12.
Centre armrest with storage

(see details on a following page)

Page 113 of 324

6
FITTINGS
111
Component which protects against sunlight
from the front or the side, also equipped with
an illuminated courtesy mirror.


)
With the ignition on, raise the con-
cealing fl ap; the mirror is lit auto-
matically.
This sun visor is also equipped with a
ticket holder.








SUN VISOR










ILLUMINATED GLOVE BOX


Its lid has locations for storing a pen, a
pair of glasses, tokens, maps, a cup...


)
To open the glove box, raise the
handle.
It is lit when the lid is opened.
It houses the front passenger airbag
deactivation switch A
.
If the vehicle is fi tted with air condition-
ing, it provides access to the ventilation
nozzle B
, distributing the same cooled
air as the vents in the passenger com-
partment.
It gives access to the dashboard fuse-
box (see “Practical information - §
Changing a fuse”).






PORTABLE ASHTRAY




)
Pull the cover to open the ashtray.

)
To empty it, remove the ashtray by
pulling it upwards.
To avoid any problem of interfer-
ence or risk of overturning, do
not place the ashtray near the
gear lever.

Page 140 of 324

8
SAFETY
138
AIRBAGS


System designed to maximise the safety
of the occupants (with the exception of
the rear centre passenger) in the event
of violent collisions. It supplements the
action of the force-limiting seat belts
(with the exception of the rear centre
passenger).
If a collision occurs, the electronic de-
tectors record and analyse the front
and side impacts sustained in the im-
pact detection zones:


- in the case of a serious impact, the
airbags are triggered instantly and
protect the occupants of the vehicle
(with the exception of the rear cen-
tre passenger); immediately after the
impact, the airbags defl ate rapidly so
that they do not hinder visibility or the
exit of the occupants,

- in the case of a minor or rear impact
or in certain roll-over conditions, the
airbags will not be triggered; the
seat belt alone is suffi cient to pro-
vide optimum protection in these
situations.


The airbags do not operate when
the ignition is switched off.

This equipment will only deploy
once. If a second impact occurs
(during the same or a subse-
quent accident), the airbag will
not be triggered again.

A.
Front impact zone.

B.
Side impact zone.
Impact detection zones
Triggering of the airbag(s) is ac-
companied by a slight emission
of harmless smoke and a noise,
due to the activation of the pyro-
technic cartridge incorporated in
the system.
This smoke is not harmful, but
sensitive individuals may experi-
ence slight irritation.
The noise of the detonation may
result in a slight loss of hearing
for a short time.

















Front airbags

System which protects the driver and
front passenger in the event of a seri-
ous front impact in order to limit the risk
of injury to the head and thorax.
The driver's airbag is fi tted in the centre
of the steering wheel; the front passen-
ger's airbag is fi tted in the dashboard
above the glove box.

Deployment
The airbags are deployed simultaneously,
unless the passenger's front airbag is de-
activated, in the event of a serious front
impact to all or part of the front impact
zone A
, in the longitudinal centreline of the
vehicle on a horizontal plane and directed
from the front to the rear of the vehicle.
The front airbag infl ates between the tho-
rax and head of the front occupant of the
vehicle and the steering wheel, driver's
side, and the dashboard, passenger's side
to cushion their forward movement.

Page 189 of 324

11
PRACTICAL INFORMATION
187














CHANGING A WHEEL

Procedure for changing a faulty wheel
for the spare wheel using the tools pro-
vided with the vehicle.

Access to the tools

The tools are installed in the boot under
the fl oor.
To gain access to them:


)
open the boot,

)
raise the fl oor,

)
secure it by hooking its cord on the
hook on the rear shelf support,

)
with a standard size spare wheel,
unclip and remove the box in the
middle of the wheel containing the
tools,
or

)
with a "space-saver" spare wheel;
lift the wheel at the rear towards
you for access to the storage box
containing the tools.
List of tools
All of these tools are specifi c to your
vehicle. Do not use them for other
purposes.


1.
Wheelbrace.
For removing the wheel trim and
the wheel fi xing bolts.

2.
Jack with integral handle.
For raising the vehicle.

3.
"Bolt cover" tool.
For removing the bolt protectors
(covers) on alloy wheels.

4.
Socket for the security bolts (located
in the glove box).
For adapting the wheelbrace to the
special "security" bolts.


Wheel with trim

When removing the wheel
, detach the trim fi rst using the wheelbrace 1

pulling at the valve passage hole.

When refi tting the wheel
, refi t the trim starting by placing its notch facing
the valve and press around its edge with the palm of your hand.

Page 199 of 324

11
PRACTICAL INFORMATION
197




















CHANGING A FUSE

Access to the tools

The extraction tweezer is fi tted to the
back of the dashboard fusebox cover.
To gain access to them:


)
open the glove box lid,

)
unclip the carrier fi tted to the fuse-
box cover by pulling on the right,

Changing a fuse

Before changing a fuse,


)
the cause of the failure must be
identifi ed and rectifi ed,

)
all electrical consumers must be
switched off,

)
the vehicle must be immobilised
with the ignition off,

)
Identify the failed fuse using the al-
location tables and illustrations on
the following pages.
Good

Failed

To replace a fuse, you must:


)
use the special tweezer to extract
the fuse from its housing and check
the condition of its fi lament.

)
always replace the failed fuse with
a fuse of the same rating (same
colour); use of a different rating may
cause malfunctions (risk of fi re).
if the fuse fails again soon after re-
placement, have the electrical system
checked by a CITROËN dealer or a
qualifi ed workshop.
Installing electrical
accessories
Your vehicle’s electrical sys-
tem is designed to operate with
standard or optional equipment.
Before installing other electrical
equipment or accessories on
your vehicle, contact a CITROËN
dealer or a qualifi ed workshop.
CITROËN will not accept re-
sponsibility for the cost incurred
in repairing your vehicle or for
rectifying malfunctions resulting
from the installation of accesso-
ries not supplied and not recom-
mended by CITROËN and not
installed in accordance with its
instructions, in particular when
the combined consumption of all
of the additional equipment con-
nected exceeds 10 milliamperes.
The replacement of a fuse not
mentioned in the following ta-
bles may cause a serious mal-
function of your vehicle. Contact
a CITROËN dealer or a qualifi ed
workshop.
Tweezer


)
remove the tweezer,

)
open the fusebox cover by pulling at
top right, then left,

)
fold down the fusebox cover com-
pletely.

Page 200 of 324

11
PRACTICAL INFORMATION
198

Dashboard fuses

The fuseboxes are located in the lower
dashboard (left-hand side).

Access to the fuses


)
Refer to the paragraph "Access to
the tools".

Fuse tables

Fusebox 1



Fuse N°



Rating


Functions



F8



3 A

Alarm siren, alarm ECU.


F13



10 A

Cigarette lighter.


F14



10 A

12 V socket in boot.


F16



3 A

Lighting for the large multifunctional storage unit,
rear map reading lamps, glove box illumination.


F17



3 A

Sun visor illumination, front map reading lamps.


F28



15 A

Audio system, radio (after-market).


F30



20 A

Rear wiper.


F32



10 A

Hi-Fi amplifi er.

Page:   1-10 11-20 next >