remote control Citroen GRAND C4 PICASSO RHD 2013 1.G User Guide

73
2
Access





Doors


Opening


From outside
)After unlocking the vehicle using theremote control or the Keyless Entry and Starting system, pull the door handle.

From inside
)
Pull the front or rear door lever to open thedoor.

I
f a door is not properly closed:- with the engine running
, this warning lamp and a message
appear in the instrument panel
(type 1) for a few seconds,-when driving(speed above 6 mph (10 km/h)), thiswarning lamp and a message,
accompanied by an audible
signal, appear in the instrument
panel
(type 1 and type 2) for a
few seconds.

Closing

75
2
Access











Boot


Opening the tailgate


With the electronic key /
remote control
With the tailgate opening control
) With the vehicle unlocked or with theelectronic key of the Keyless Entry and Star ting system in the zone covered, press
the tailgate control A . )
Raise the tailgate.
)
Make a long press on this button
to release the tailgate. If the
vehicle was locked, this action first unlocks the vehicle. ) Raise the tailgate.

When selective unlocking is activated,the electronic key must be close to the rear of the vehicle.


Closing the tailgate
)
Lower the tailgate using the interior grips.)
Release the grips and press down on the
outside of the tailgate to close it.
If the tail
gate is not properly closed:
The tailgate is not designed to take abicycle carrier.
-engine running
, this warning lamp and a message appear in
the instrument panel (type 1) for
a few seconds,
- vehicle running(speed above6 mph (10 km/h)), this warninglamp and a message appear
in the instrument panel (type 1
and type 2) for a few seconds,
accompanied by an audible
signal.

77
2
Access

Motorised opening


Unlocking and opening the tailgate with the electronic key /
remote control

Unlocking and opening the tailgate with the Keyless Entryand Starting system

Openin
g the tailgate
)
Make a long press on this button.
)Press button Aon the tailgate, with theelectronic key in the area of coverage.



When selective locking is activated, the electronic key must be near the rear of the vehicle.


By default, the tailgate openscompletely or alternatively to the
memorised position.

)After complete unlocking of the vehicle, press control Aon the tailgate.
The instruction is confirmed by an audiblesignal.
Motorised closing
There are two possibilities:)
Press and release the exterior
control A.or
- by pressing one of thesetwo buttons,

The motorised tailgate has an anti-pinch system that interrupts closing if it encounters an obstacle.
Operation of the tailgate can be interrupted at any time:

After interruption of an operation,another press on one of the controlsresumes the movement, with the exception of a press on the remote control button, which only allows opening.

or
- by pressing the exterior control A.
Memorising an opening
position

Where height is restricted (garage with a low
ceiling, ...) it is possible to limit and memorise
the opening angle of the tailgate.
Thi
s memorisation is done as follows:


- open the tailgate to the desired position,

- press button
B
or the exterior control A
for more than 3 seconds.
Memorisation of the maximum opening position of the tailgate is confirmed by an audible signal.
To cancel the memorised position:


- stop t
he tailgate in an intermediate position,

- press button B
or the exterior control A
for more than 3 seconds.
)
Press and then release button B.

79
2
Access
For all work on the alarm system,contact a CITROËN dealer or a qualified workshop.





Alarm System which protects and provides a deterrent against theft and break-ins. It provides the following types of monitoring:


- Exterior perimeter

The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot or the bonnet...




- Interior volumetric

The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compar tment or moves inside the vehicle.
Self-protection function
The system checks for the
disconnection of any of its components. The alarm is triggered if the battery,the button or the wires of the siren aredisconnected or damaged.


Locking the vehicle with full
alarm system

Activation


If an opening (door, boot, bonnet...) is not closed fully, the vehicle is not locked but theexterior perimeter monitoring will be activated
after a delay of 45 seconds, at the same time
as the interior volumetric monitoring.
)Lock the vehicle using the remote control.
)Switch off the ignition and get out of the vehicle.
or )
Lock the vehicle using the "Keyless Entry
and Starting" system.


The monitorin
g system is active: the indicator
lamp in the button flashes once per second and
th
e the direction indicators come on for about
2 seconds.
After an instruction to lock the vehicle lockedusing the remote control or the Keyless Entry
and Starting system, the exterior perimeter
monitoring is activated after a delay of 5 seconds, the interior volumetric monitoring
after 45 seconds.

80
OFF
Access

Locking the vehicle
with exterior
perimeter
monitoring only
Deactivate the interior volumetric monitoringto avoid unwanted triggering of the alarm incertain cases such as:


- leaving a window par tially open,

- washing your vehicle,

- changing a wheel,


Deactivation of the volumetric monitoring
)
Switch of the ignition and within
ten seconds press this button until its indicator lamp is on fixed.
)Get out of the vehicle. )Immediately lock the vehicle using theremote control or the "Keyless Entry and Starting" system.
Only the exterior perimeter protection system is
active: the indicator lamp in the button flashes
once per second.
To be e
ffective, this deactivation must be doneevery time the ignition is switched off.
In the case of automatic locking of the vehicle (which occurs after a period of 30 seconds if a door or the boot is notopened), the monitoring system is not reactivated automatically. To reactivate it, it is necessary to unlock the vehicleand lock it again, using the remote control or the "Keyless Entry and Starting" system.

Deactivation
)Press one of the unlocking buttons on theremote control:
short press
long press
or )Unlock the vehicle using the "Keyless Entryand Starting" system.
The monitoring system is deactivated: the
indicator lamp in the button is off and the
direction indicators flash for about 2 seconds.

81
2
Access

Reactivation of the interior volumetric monitoring
)Deactivate the exterior perimeter monitoring by unlocking the vehicle usingthe remote control or the Keyless Entry andStarting system.
The indicator lamp in the button goes off.
)Reactivate the full alarm system by locking
the vehicle using the remote control or the
"Keyless Entry and Star ting" system.
The indicator lamp in the button flashes once
per second again.
Tr iggering of the alarm
This is indicated by sounding of the siren and flashing of the direction indicators for
thirty seconds.
The monitoring functions remain active until
the alarm has been triggered eleven times in
succession.When the vehicle is unlocked using the remotecontrol or the Keyless Entry and Startingsystem, rapid flashing of the indicator lampin the button informs you that the alarm was
triggered during your absence. When the
ignition is switched on, this flashing stops immediately.
Failure of the remote control
To deactivate the monitoring functions:
) Unlock the vehicle using the key (integral
with the remote control) in the driver's door lock. ) Open the door; the alarm is triggered. )
Switch on the ignition; the alarm stops. The
indicator lamp in the button goes off.




Locking the vehicle without
activating the alarm
)
Lock or deadlock the vehicle using the key (integral with the remote control) in thedriver's door lock.




Operating fault


When the ignition is switched on, fixed
illumination of the indicator lamp in the button
indicates a fault in the system.
Have it checked by a CITROËN dealer or a qualified workshop.



Automatic activation *



2 minutes after the last door or the boot is closed, the system is activated automatically. )
To avoid triggering the alarm on enteringthe vehicle, first press the unlocking button on the remote control or unlock the vehicleusing the Keyless Entry and Starting system.

* Accordin
g to country.

101
3
Comfort





Mirrors
Adjustment
)
Move control A
to the right or to the left to select the corresponding mirror. )
Move control B
in all four directions to
adjust.
) Return control Ato the central position. Each fitted with an ad
justable mirror glass providing the lateral rear ward vision necessaryfor overtaking or parking. They can also be folded for parking in confined spaces.


Demisting - Defrosting


Door mirrors
Demisting-defrosting of the door
mirrors operates with the enginerunning, by switching on the heated rear screen (refer to the "Rear screen
demist-defrost" section).
The objects observed are, in reality,
closer than they appear. Take this into account in order to correctly judge the distance of vehicles approaching from behind.




Folding
)
From outside: lock the vehicle using the electronic key or the Keyless Entry and Starting system. )
From inside: with the ignition on, pull thecontrol Ain the central position rearwards.
If the mirrors are folded using control A,they will not unfold when the vehicle isunlocked. Pull again on control A.
The folding and unfolding of the door mirrors using the remote control can be deactivated by a CITROËN dealer or aqualified workshop.
)
From outside: unlock the vehicle using the electronic key or the Keyless Entry and Starting system. )
From inside: with the ignition on, pull thecontrol Ain the central position rearwards.
Unfolding
If necessary, it is possible to fold the mirrors manually.

210
Visibility
To make your approach to the vehicle easier,
these illuminate:


- the zones facing the driver’s and
passenger’s doors,

- the zones forward of the door mirrors andrearward of the front doors.


Door mirror spotlamps


Switching on

The spotlamps come on automatically:


- when you unlock the vehicle,

- when you remove the electronic key from the reader,

- when you open a door,

- when you use the remote control to locate the
vehicle.




Switching off

They go off automatically after 30 seconds.

Exterior welcome lighting


Switching on
)
Press the open padlock on the
remote control or one of the front
door handles with Keyless Entry
and Star ting.
The dipped beam headlamps
and the sidelamps come on; your
vehicle is also unlocked.




Programming
Daytime running lamps
(LEDs)
They come on automatically when the engineis star ted, when the lighting control stalk is in position "0" or " AUTO".

In some weather conditions (e.g. low
temperature or humidity), the presence of misting on the internal sur face of theglass of the headlamps and rear lampsis normal; it disappears after the lamps have been on for a few minutes.
The remote switching on o
f the lighting makesyour approach to the vehicle easier in poor
light. It is activated when the lighting control
is in the "AUTO" position and the level of light
detected by the sunshine sensor is low.



Switching off

The activation, deactivation and choice of
welcome lighting duration are done in the
" Driving assistance" menu then "Vehicle
settings". The exterior welcome li
ghting switches off
automatically after a set time, when the ignition
is switched on or on locking the vehicle.

219
5
Visibility






Courtesy lamps
1.Front courtesy lamp2.Front map reading lamps 3.Rear cour tesy lamp4.Rear map reading lamp s
Front - rear courtesy lamps
)
With the ignition on, press thecorresponding switch.


Front - rear map reading
lamps
With the "permanent lighting" mode, the lightingtime varies according to the circumstances:


- with the ignition off, approximately ten minutes,

- in energy economy mode, approximatelythirty seconds,

- with the engine running, unlimited.


In this position, the courtesy lamp comes on gradually:
Permanentl
y off.

Permanent lighting. - when the vehicle is unlocked
,
- when the electronic key is removed from
the reader,
- when opening a door,
- when the remote control locking button is
activated, in order to locate your vehicle.
It switches o
ff gradually:
- when the vehicle is locked,
- when the i
gnition is switched on,
- 30 seconds after the last door is closed.


Take care to avoid leaving anything in contact with the courtesy lamps.

Dependin
g on
version, you canalso switch the courtesy lamp on or
off by pressing thisbutton.

296
Practical information
Do not apply excessive force on thetab as locking will not be possible if the clamp is not positioned correctly; star tthe procedure again.



Disconnecting the (+) cable
)Raise the locking tab Dfully to release the cable terminal clamp E.


Reconnecting the (+) cable
)Position the open clamp Eof the cable on
the positive post (+) of the battery.
)Press vertically on the clamp E to position
it correctly on the battery.
)Lock the clamp by spreading the positioning lug and then lowering the tab D.
)Operate the star ter on the broken down
vehicle and let the engine run
If the engine does not start straight away,
switch off the ignition and wait a few moments before trying again. )Wait until the engine returns to idle then
disconnect the jump lead cables in the reverse order.






Before disconnecting the battery

Wait 2 minutes after switching off the ignitionbefore disconnecting the battery.

Close the windows and the doors before
disconnecting the battery.

Following reconnectionof the battery

Following reconnection of the battery, switch on
the ignition and wait 1 minute before star ting to
permit initialisation of the electronic systems.However, if problems remain following this
operation, contact a CITROËN dealer or a
qualified workshop.
Referring to the corresponding section, you
must yourself reinitialise (depending on
version):


- the remote control key,

- the electric blind(s),

- ...