towing GMC SIERRA 2008 Get To Know Guide

Getting to Know Your Sierra20
Folding the Rear Seat
(if equipped)
FullBench Seat
To fold up the fullbench seat, push
down on the front of the seat cushionwhile pulling down on the release straplocated under the seat cushion. Pull upthe seat cushion until it latches with theseatback.
To fold down the full bench seat, push
on the seat cushion and pull the release
strap. Pull down the seat cushion until itlatches in place.
60/40 SplitBench Seat
To fold either side of the splitbench
seat, pull up the seat cushion.
To unfold the seat, pull down the seat
cushion.
See Section 1 of your Owner Manual.
Cargo Management System
(if equipped)
The cargo management system is com
posed of three rails located on the frontand sides of the truck bed. It includesfour adjustable cargo tiedowns that canbe placed on the upper and lower slidesof the rail.
To adjust a tiedown, pull out the locator
pin and move the tiedown to anotherlocation. Make sure the locator pin linesup with a locator hole on the rail. Oncethe pin is inside the hole, the tiedownwill not move sidetoside.
The rails are notched at each end to
allow the tiedowns to be removed andplaced on another rail. To remove, pull
out the locator pin and slide the tiedown
to the end of the rail and pull back.
To remove or install cargo tiedowns at
the front of the bed, slide the corner captoward the center of the bed to expose
the rail notches. To remove the cornercap, pull either edge away from the rail.
See Section 2 of your Owner Manual.
TrailerTow Mirrors (if equipped)
The trailertow mirrors can be extended
manually to provide better visibility when
towing a trailer. The lower portion of the
mirror has a convex (spotter) mirror that
also can be adjusted manually to provide a better viewing angle.
See Section 2 of your Owner Manual
Sierra 2008 A 5/16/07 7:50 AM Page 20