odometer HYUNDAI I20 2017 Owners Manual

• Throttle Body
• Intake Manifold
• Idle Speed Control Actuator
3.4 Ignition System • H.T. Cable Set
• Ignition Coil
• Power Transistor
• Distributor and internal parts
3.5 Evaporative Emission Control System
• Vapour Storage Canister
• Fuel Tank
• Fuel Filler Tube and Fuel fillerCap
• Purge Control Solenoid Valve
• Canister Close Valve
3.6 PCV System • PCV Valve.
• PCV Hoses
• Oil Filler Cap
3.7 Catalytic Converter System • Exhaust Manifold
• Exhaust Pipe Assembly
• Catalytic Converter
3.8 Exhaust Gas Recirculation (EGR) System (Diesel Engines)
• EGR Control System
3.9 Miscellaneous items used in above Systems • Vacuum hoses\b clamps\b fit
tings\b tubing or mounting hard
ware used with the above sys
tems. Valves\b Switches and
Solenoids.
4. What is not covered
This Emission Warranty shall not apply to:
o Normal maintenance ser vices including without limitation\b
engine tuning\b oil/fluid changes\b
filters replenishment\b etc.
o Replacement of parts as a result of normal wear and tear such as
spark plugs\b filters\b etc.
o The vehicle reported without valid ‘Pollution Under Control’ certifi
cate for the period immediately
preceding the test during which
the failure is discovered.
o The vehicle which has been run on adulterated fuel or lubricant or
fuel/lubricants other than those
specified by HMIL.
o Damage or failure resulting from: vNegligence of proper mainte
nance as required in this
Owner’s Manual and Service Booklet.
v Misuse\b abuse\b accident\b theft\b
flooding or fire.
v Use of improper or insufficient
fuel\b fluids or lubricants.
v Any repair carried out other
than by Hyundai Authorized
Dealer/ Service Centre.
v Use of par ts other than
Hyundai Genuine Parts.
v Any device and/or accessories
not supplied by HMIL.
v Modifications\b alterations\b
tampering or improper repair.
v Parts used in applications for
which they were not designed
or not approved by HMIL.
v Any penalties that may be
charged by statutory authori
ties on account of failure to
comply with the Inuse emis
sion standards.
v The vehicle in which the
odometer has been tampered
with\b changed or been discon
nected.
o Any consequential repairs or replacement of parts which may
be found necessary to establish
compliance to Inuse emission
Hyundai Warran\fy Po\bicy
)%6

)'#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3''#()*"!+#)
%"()+*
1. Tachometer
2. Speedometer
3. Fuel gauge
4. Engine coolant temperature gauge
5. Warning and indicator lights
6. Odometer/Trip computer
7. LCD display (including trip computer)
OIB044101/OIB044100
■ Type A
❈ The actual cluster in the vehicle may differ
from the illustration.
For more details, refer to the "Gauges" in
this chapter.
■Type B,C

)'#10*30-30.2+3%.,/3(21+2"1,/2*3!-$&3
AA void driving with a very low fuel
level. Running out of fuel could
cause the engine to misfire damag-
ing the catalytic converter.
OdometerThe odometer indicates the total dis-
tance that the vehicle has been driv-
en and should be used to determine
when periodic maintenance should
be performed.
- Odometer range : 0 ~ 1599999 kilo- meters or 999999 miles.
Information
It is forbidden to alter the odometer of
all vehicles with the intent to change
the mileage registered on the odome-
ter. The alteration may void your war-
ranty coverage.i
NOTICEFuel Gauge
Running out of fuel can expose
vehicle occupants to danger.
You must stop and obtain addi-
tional fuel as soon as possible
after the warning light comes on or
when the gauge indicator comes
close to the “E (Empty)” level.
WARNING
OIB044116OIB044115
■Ty p e A■Ty p e B , C

1.((
,204/3424-3
WWheel replacement When replacing the metal wheels for
any reason, make sure the new
wheels are equivalent to the original
factory units in diameter, rim width
and offset.
Tire tractionTire traction can be reduced if you
drive on worn tires, tires that are
improperly inflated or on slippery
road surfaces. Tires should be
replaced when tread wear indicators
appear. Slow down whenever there
is rain, snow or ice on the road, to
reduce the possibility of losing con-
trol of the vehicle.Tire maintenance In addition to proper inflation, correct
wheel alignment helps decrease tire
wear. If you find a tire worn unevenly,
have your dealer check the wheel
alignment.
When you have new tires installed,
make sure they are balanced. This
will increase vehicle ride comfort and
tire life. Additionally, a tire should
always be rebalanced if it is removed
from the wheel.
Tire sidewall labelingThis information identifies and
describes the fundamental charac-
teristics of the tire and also provides
the tire identification number (TIN)
for safety standard certification. The
TIN can be used to identify the tire in
case of a recall.1. Manufacturer or brand nameManufacturer or Brand name is
shown.
A wheel that is not the correct size
may adversely affect wheel and
bearing life, braking and stopping
a bilities, handling characteristics,
ground clearance, body-to-tire
clearance, snow chain clearance,
spee dometer and odometer cali-
bration, headlight aim and bumper
height.
WARNING
I030B04JM
1
1
2
34
5,6
7