Warning mode HYUNDAI I20 2023 Owner's Guide

07
7-163
How to turn off Exit mode whilst
operating

[Press the Parking/View () button or
Parking Safety () button.
Exit mode will cancel in the following
conditions:

[ When checking space to exit
- Shifting the gear to R (Reverse)
- The vehicle moves
- Not enough space to exit
- An object is detected within 2mm (79
in.) in the direction of exit
- The steering wheel, gearshift,
braking, and drive controls are not
working normally
- ABS, TCS or ESC system operates
due to slippery road conditions

[When the steering wheel is being
controlled
- The steering wheel is steered
- Approximately 6 minutes have
passed after the steering wheel has
been controlled
- The steering wheel, gearshift,
braking, and drive controls are not
working normally
- ABS, TCS or ESC system operates
due to slippery road conditions
OBC3070104TU
Additional instructions (messages)
When Parking Assist is operating, a
message may appear regardless of the
operating order. The messages will
appear according to the circumstances.
Follow the instructions provided whilst
using Parking Assist.
WARNING

[Always check surroundings for
pedestrians, animals or objects
before taking your foot off the brake
pedal.

[If the vehicle does not move even
though the brake pedal is not
depressed, check the surroundings
before depressing the accelerator
pedal.

[ If it is determined that the space is
too small when the vehicle is being
controlled to exit, Exit mode will be
canceled.

8-11
08
OBC3N081002AU
ONX4E080005
(1) Low Tyre Pressure Telltale/TPMS
Malfunction Indicator
(2) Low Tyre Pressure Position Telltale
and Tyre Pressure Telltale (Shown on
the LCD display)
Check tyre pressure
ONX4E040019

[You can check the tyre pressure in the
Warning mode on the cluster.
Refer to the “LCD Display Modes” in
chapter 4.

[Tyre pressure is displayed after a few
minutes of driving after initial engine
start up.

[If tyre pressure is not displayed when
the vehicle is stopped, “Drive to
display” message will appear. After
driving, check the tyre pressure.

[The displayed tyre pressure values
may differ from those measured with a
tyre pressure gauge.

[You can change the tyre pressure
unit in the User Settings mode on the
instrument cluster.
- psi, kpa, bar (Refer to “LCD Modes”
in chapter 4).
7<5(35(6685(021,725,1*6<67(0

9-31
09
%DWWHU\FDSDFLW\ODEHO
OBC3090062
„ Example
❈ The actual battery label in the vehicle
may differ from the illustration.
1. AGM50L-DIN : The HYUNDAI model
name of battery
2. 12V : The nominal voltage
3. 50Ah (20HR) : The nominal capacity
(in Ampere hours)
4. RC 80 : The nominal reserve capacity
(in min.)
5. CCA 560A : Cold-test current in
amperes by SAE/EN
%DWWHU\UHFKDUJLQJ
Your vehicle has a maintenance-free,
calcium-based battery.

[ ,IWKHEDWWHU\EHFRPHVGLVFKDUJHG
over a short time (for example, the
headlights or interior lights were on
whilst the vehicle was not in use),
recharge it by slow charging (trickle)
for 10 hours.

[ ,IWKHEDWWHU\JUDGXDOO\GLVFKDUJHV
because of high electrical load whilst
the vehicle is being used, recharge it
at 20-30A for two hours.
WARNING
When recharging the battery, observe
the following precautions:

[ %HIRUHSHUIRUPLQJPDLQWHQDQFHRU
recharging the battery, turn off all
accessories and stop the engine.

[Do not allow cigarettes, sparks, or
flame near the battery.

[Wear eye protection when checking
the battery during charging.

[The battery must be removed from
the vehicle and placed in an area with
good ventilation.

[Watch the battery during charging,
and stop or reduce the charging
rate if the battery cells begin
gassing (boiling) violently or if the
temperature of the electrolyte of any
cell exceeds 49°C (120°F).

[The negative battery cable must be
removed first and installed last when
the battery is disconnected.

[Disconnect the battery charger in the
following order.
1. Turn off the main battery charger
switch.
2. Unhook the negative clamp from
the negative battery terminal.
3. Unhook the positive clamp from
the positive battery terminal.