change language INFINITI QX50 2019 Navigation Manual

2. Getting Started
LANGUAGE AND UNIT SETTINGS
This changes the upper and lower display
language and measurement unit used in the
system.
Step 1Step 2Setting item Action
1. Push <MENU> [Language & Units] [System Language] Select the language of the upper and lower display.
2. Touch [Settings] [Fuel Economy Unit Settings] Select the preferred unit.
3. Touch [Other] [Temperature Units]Select the preferred temperature unit.
INFO:
Do not push the ignition switch while changing the language.
If the selected language is also supported in the combination meter, a confirmation message asking if you would like to also change the meter
language is displayed. Select [Yes] to change the language in the meter.
2-20

9. Navigation (if so equipped)
regulations, etc.
— If the only route to reach the destina- tion or waypoints is extremely com-
plicated.
. The following may occur when the route
is displayed.
— If you calculate a route on a main road, the starting point of the route may
not exactly match the current vehicle
location.
— The endpoint of the route may not exactly match the destination.
— If you calculate a route on a main road, the system may display a route from
another main road. This may be
because the position of the vehicle
icon is not accurate. In this case, park
the vehicle in a safe location and reset
the vehicle icon, or continue driving to
see if the position of the vehicle icon
is automatically adjusted before re-
calculating the route.
— There are cases in which the system shows an indirect route to reach the
destination or waypoints, if you set
them from stored or facility informa-
tion. In order to correct this, you must be careful about the traffic direction,
especially when lanes with different
travel directions are shown sepa-
rately, such as interchanges and ser-
vice areas.
— This system makes no distinction be- tween limited traffic control and total
control (blockage). It may show an
indirect route even if the road is
usable.
— Even if the freeway preference is set to OFF, a route that uses the freeway
may be suggested.
— Even if the ferry preference is set to OFF, a route that uses a ferry line
may be suggested.
ROUTE GUIDANCE
INFO:
The system will only announce street names
when the system language is set to English.
Street names are not announced when the
system is set to French/Spanish.
Repeating voice guidance
This function is available throughout route
guidance, from the time after the route
calculation is completed until the vehicle
arrives at the destination. Push and hold
the <MAP/VOICE>. Voice guidance will be
repeated.
INFO:
. If the <MAP/VOICE> is pushed and held
when the vehicle is deviating from the
suggested route and when the automatic
reroute function is off, voice guidance
will announce, “Proceed to the high-
lighted route.”
. If the <MAP/VOICE> is pushed and held
when the vehicle is going in the wrong
direction, voice guidance will announce:
“Please make a legal U-turn if possible.”
Notes on voice guidance
. Voice guidance in this system should be
regarded as a supplementary function.
When driving the vehicle, check the route
on the map and follow the actual roads
and traffic regulations.
9-64