clock JEEP GRAND CHEROKEE 2023 User Guide

IN CASE OF EMERGENCY319
Third Row Seating — If Equipped

1. Position the wheel behind the rear fascia/
bumper facing outward. Push the end of the
winch’s cable, spring and steel sleeve
through the back of the road wheel. Making
sure the valve stem is facing the ground when
the wheel is stowed.

Installing Winch

2. Slide the road wheel on the ground until it is directly under the winch and between the rear
fascia/bumper and exhaust system heat
shields. Raise the tire by turning the lug
wrench on the winch extension clockwise until
it clicks/ratchets three times to make sure the
cable is tight.
Winch Wrench Rotation
Road Wheel Installed In Spare Location
JUMP STARTING
If your vehicle has a discharged battery, it can be
jump started using a set of jumper cables and a
battery in another vehicle, or by using a portable
battery booster pack. Jump starting can be
dangerous if done improperly, so please follow the
procedures in this section carefully.
NOTE:When using a portable battery booster pack, follow
the manufacturer's operating instructions and
precautions.
CAUTION!
The winch mechanism is designed for use with
the jack wrench extension tool only. Use of air
wrench or power tool may damage the winch.
WARNING!
Do not attempt jump starting if the battery is
frozen. It could rupture or explode and cause
personal injury.
CAUTION!
Do not use a portable battery booster pack or
any other booster source with a system voltage
greater than 12 Volts or damage to the battery,
starter motor, alternator or electrical system may
occur.
7

23_WL_OM_EN_USC_t.book Page 319

324IN CASE OF EMERGENCY
NOTE:Insert the flathead screwdriver or similar tool in the
lower notch of the access cover and gently rotate
clockwise to remove.

Manual Park Release Location

4. Unlock the orange lock plug by turning it a quarter turn counterclockwise.
Locked — Unlocked Position

5. Pull the lock plug out as far as it will go, then release it. The transmission should now be in
NEUTRAL (N), allowing the vehicle to be
moved.
NOTE:When the lever is locked in the released position,
the lock plug and tether will remain outside of the
trim panel and the access cover cannot be rein -
stalled.
6. Release the EPB only when the vehicle is securely connected to a tow vehicle. To Reset The Manual Park Release:

1. Apply firm pressure to the brake pedal while
seated in the driver’s seat.

2. Pull the lock plug out again, then release it.
3. Allow the tether to retract with the lever back to its original position.
4. Verify that the transmission is in PARK (P).

5. Confirm that the tether has retracted fully, then firmly push the orange lock plug back to
the locking position within the housing.
Reinstall the access cover. If the access cover
cannot be reinstalled, repeat steps 1
through 4.
23_WL_OM_EN_USC_t.book Page 324