JEEP RENEGADE TRAILHAWK 2016 Owners Manual
Page 501 of 688
Tire Service Kit Expiration Date Location
IN CASE OF EMERGENCY 499
Page 502 of 688
Page 503 of 688
IN CASE OF EMERGENCY 501
Page 504 of 688
CAUTION!
Failure to follow these procedures could result in
damage to the charging system of the booster vehicle
or the discharged vehicle.
Connecting The Jumper Cables
1. Connect the positive(+)end of the jumper cable to the
positive(+)post of the discharged vehicle.
2. Connect the opposite end of the positive(+)jumper
cable to the positive(+)post of the booster battery.3. Connect the negative(-)end of the jumper cable to the
negative(-)post of the booster battery.
4. Connect the opposite end of the negative(-)jumper
cable to a good engine ground (exposed metal part of
the discharged vehicle’s engine) away from the battery
and the fuel injection system.
Page 505 of 688
IN CASE OF EMERGENCY 503
Page 506 of 688
Page 507 of 688
6. Turn Left Turn Signal
Switch ON.Left Turn Light is ON
SOLID. Right Turn Light
is ON SOLID.
7. Turn Left Turn Signal
Switch OFF. (Turn Signal
Switch Must be placed in
Neutral State).Left Turn Light is OFF.
Right Turn Light is OFF.
8. Turn ignition OFF.
9. Turn Hazard Flashers
OFF (Manually).System is now reset and
the engine may be
started.
If a reset procedure step is not completed within 60
seconds, then the turn signal lights will turn off and the
reset procedure must be performed again in order to be
successful.
IN CASE OF EMERGENCY 505
Page 508 of 688
Page 509 of 688
IN CASE OF EMERGENCY 507
Page 510 of 688
Removing Shift Lever Bezel
508 IN CASE OF EMERGENCY