check engine KIA STONIC 2018 Workshop Manual

Page 399 of 523

AUTOMATIC TRANSAXLE FLUID (IF EQUIPPED)
Checking the automatic
transaxle fluid level
The automatic transaxle fluid level
should be checked regularly.
Keep the vehicle on level ground with the parking brake applied and check the
fluid level according to the following
procedure. 1. Place the shift lever in N (Neutral) position and confirm if the engine is
running at normal idle speed.
NOTICE
Insert the level gauge, after checking
the automatic transaxle fluid level. In
the direction referred in the picture.
CAUTION
If you insert the level gauge in thewrong direction, it can cause defor‐mation (or damage) to level gauge.
2. After the transaxle is warmed up sufficiently [fluid temperature
70~80°C (158~176°F)], for example
by 10 minutes usual driving, move
the shift lever through all positions
then place the shift lever in N(Neu‐
tral) or P(Park) position.
)05
$0-%
3. Confirm if the fluid level is in the "HOT" range on the level gauge. If
the fluid level is lower, add the
specified fluid from the fill hole. If
the fluid level is higher, drain the
fluid from the drain hole.
4. If the fluid level is checked in cold condition [fluid temperature
20~30°C (68~86°F)], add the fluid to
the "COLD" line and then recheck the fluid level according to the
above step 2.

8-53
8
Maintenance

Page 400 of 523

WARNING
nTransaxle fluid
The transaxle fluid level should bechecked when the engine is at nor‐mal operating temperature. Thismeans that the engine, radiator, ra‐diator hose and exhaust system etc.,are very hot. Exercise great care notto burn yourself during this proce‐dure.
CAUTION
•Low fluid level causes transaxleshift slippage. Overfilling can causefoaming, loss of fluid and trans‐axle malfunction.
•The use of a non-specified fluidcould cause transaxle malfunctionand failure.
WARNING
nParking brake
(Continued)
(Continued)
To avoid sudden movement of thevehicle, apply the parking brake anddepress the brake pedal before mov‐ing the shift lever.
NOTICE
The L

Page 403 of 523

FUEL FILTER (FOR DIESEL)
Draining water from the fuel
filter
The fuel filter for diesel engine plays an
important role of separating water
from fuel and accumulating the water in its bottom.
If water accumulates in the fuel filter,
the warning light comes on when the
ignition switch is in the ON position.
If this warning light illumi‐ nates, take your car to a pro‐
fessional workshop and havedrain the water and check the
system. Kia recommends tovisit an authorized Kia dealer/
service partner.
CAUTION
If the water accumulated in the fuelfilter is not drained at proper times,damages to the major parts such asthe fuel system can be caused bywater permeation in the fuel filter.
Fuel filter cartridge replacement
NOTICE
When replacing the fuel filter car‐
tridge, use parts for replacement
from a professional workshop. Kia
recommends to visit an authorized
Kia dealer/service partner.

8-57
8
Maintenance

Page 411 of 523

❈The actual battery label in the vehi‐
cle may differ from the illustration.
1. AGM90L-DIN : The Kia model name
of battery
2. 90Ah(20HR) : The nominal capacity (in Ampere hours)
3. 170RC : The nominal reserve ca‐ pacity (in min.)
4. 12V : The nominal voltage
5. 850CCA (SAE) : The cold-test cur‐ rent in amperes by SAE
6. 680A : The cold-test current in am‐ peres by EN
Battery recharging
Your vehicle has a maintenance-free,
calcium-based battery. • If the battery becomes discharged in a short time (because, for example,the headlights or interior lights were
left on while the vehicle was not in
use), recharge it by slow charging
(trickle) for 10 hours.
• If the battery gradually discharges because of high electric load while
the vehicle is being used, recharge it
at 20-30A for two hours.
WARNING
nRecharging battery
When recharging the battery, ob‐serve the following precautions:•The battery must be removedfrom the vehicle and placed in anarea with good ventilation.
•Do not allow cigarettes, sparks, orflame near the battery.
•Watch the battery during charg‐ing, and stop or reduce the charg‐ing rate if the battery cells begingassing (boiling) violently or if thetemperature of the electrolyte ofany cell exceeds 49°C (120°F).
•Wear eye protection when check‐ing the battery during charging.
•Disconnect the battery charger inthe following order.1.Turn off the battery chargermain switch.
2.Unhook the negative clampfrom the negative battery ter‐minal.
3.Unhook the positive clamp fromthe positive battery terminal.
WARNING
•Before performing maintenance orrecharging the battery, turn off allaccessories and stop the engine.
•The negative battery cable mustbe removed first and installed lastwhen the battery is disconnected.
•Operation related to the battery isrecommended to be done by aprofessional workshop. Kia recom‐mends to visit an authorized Kiadealer/service partner.
CAUTION
•Keep the battery away from wa‐ter or any liquid.
•For your safety, use parts for re‐placement from a professionalworkshop. Kia recommends to visitan authorized Kia dealer/servicepartner.
Reset items
Items should be reset after the battery
has been discharged or the battery has been disconnected. • Auto up/down window

8-65
8
Maintenance

Page 423 of 523

FUSES
¥#MBEFUZQF
¥$BSUSJEHFUZQF
¥.VMUJ
 GVTF ¥#'5
❈Left side : Normal Right side : Blown
A vehicle’s electrical system is protec‐
ted from electrical overload damage by fuses.
This vehicle has 2 (or 3) fuse panels,
one located in the driver’s side panel
bolster, the others in the engine com‐ partment near the battery.
If any of your vehicle’s lights, accesso‐
ries, or controls do not work, check the
appropriate circuit fuse. If a fuse has blown, the element inside the fuse will
melt.
If the electrical system does not work,
first check the driver’s side fuse panel.
Before replacing a blown fuse, discon‐ nect the negative battery cable.
Always replace a blown fuse with one
of the same rating.
If the replacement fuse blows, this indi‐
cates an electrical problem. Avoid using the system involved and immediately
consult a professional workshop. Kia
recommends to consult an authorized Kia dealer/service partner.
Three kinds of fuses are used: blade
type for lower amperage rating, car‐
tridge type, and multi fuse for higher amperage ratings.
WARNING
nFuse replacement
•Never replace a fuse with anythingbut another fuse of the same rat‐ing.
•A higher capacity fuse could causedamage and possibly a fire.
•Never install a wire or aluminumfoil instead of the proper fuseeven as a temporary repair. It maycause extensive wiring damageand a possible fire.
•Do not arbitrarily modify or add-on electric wiring of the vehicle.
CAUTION
Do not use a screwdriver or any oth‐er metal object to remove fuses be‐cause it may cause a short circuitand damage the system.

8-77
8
Maintenance

Page 425 of 523

(Continued)
Do not try remodeling the vehicle in
any way. It is illegal, and may affect
the vehicle’s performance, durability,
and safety. Warranty is also not
provided for problems caused by re‐
modeling.
Be aware of safety problems caused
by remodeling the vehicle with unau‐
thorized electrical devices (lamp,
black box, electrical equipment, diag‐
nostic device, communication device,
etc.). It might cause malfunction of
the vehicle, wiring damage, battery
discharge, connector damage, or
fire. the vehicle or cause fire.
NOTICE
nWindow tinting precaution
Window tint (especially metallic film)
might cause communication disorder
or poor radio reception, and mal‐
function of the automatic lighting
system due to excessive change of
(Continued)
(Continued)
illumination inside the vehicle. The
solution used might also flow into
electric, electronic devices causing
disorder and failure.
Inner panel fuse replacement
0:#
1. Turn the ignition switch and all oth‐er switches off.
2. Open the fuse panel cover.
3. Pull the suspected fuse straight out. Use the removal tool provided
in the main fuse box in the engine
compartment.
4. Check the removed fuse; replace it if it is blown.
Spare fuses are provided in the in‐
strument panel fuse panel (or in
the engine compartment fuse pan‐
el).
5. Push in a new fuse of the same rating, and make sure it fits tightly
in the clips.
If it fits loosely, consult a professional
workshop. Kia recommends to consult an authorized Kia dealer/service part‐
ner.

8-79
8
Maintenance

Page 426 of 523

If you do not have a spare, use a fuse
of the same rating from a circuit you may not need for operating the vehicle,
such as the cigarette lighter fuse.
If the headlights or taillights, stoplights,
courtesy lamp, day time running lights (D.R.L) do not work and the fuses are
OK, check the fuse panel in the engine
compartment. If a fuse is blown, it must be replaced.
Memory fuse
0:#
Your vehicle is equipped with a memory
fuse to prevent battery discharge if your vehicle is parked without being op‐
erated for prolonged periods. Use the
following procedures before parking the
vehicle for prolonged periods. 1. Turn off the engine.
2. Turn off the headlights and tail
lights.
3. Open the driver’s side panel cover and pull up the memory fuse.
NOTICE
•If the memory fuse is pulled up
from the fuse panel, the warning
chime, audio, clock and interior
lamps, etc., will not operate. Some
items must be reset after replace‐
ment. Refer to L

Page 427 of 523

4. Push in a new fuse of the samerating, and make sure it fits tightly
in the clips. If it fits loosely, consult
a professional workshop. Kia rec‐
ommends to consult an authorized
Kia dealer/service partner.
CAUTION
After checking the fuse panel in theengine compartment, securely installthe fuse panel cover through the au‐dible clicking sound.If not, electrical failures may occurfrom water contact.
Multi fuse
If the multi fuse is blown, it must be re‐
moved as follows: 1. Disconnect the negative battery cable.
2. Remove the nuts shown in the pic‐ ture above.
3. Replace the fuse with a new one of the same rating.
4. Reinstall in the reverse order of re‐ moval.
NOTICE
If the multi fuse is blown, consult a
professional workshop. Kia recom‐
mends to consult an authorized Kia
dealer/service partner.

8-81
8
Maintenance

Page 431 of 523

SymbolFuse rat‐ingCircuit Protected
10ABCM (Body Control Module), Crash Pad Switch, FCA Unit, Lane Departure Warning System, BLIND-
SPOT DETECTION WARNING Radar LH/RH
15AEngine Room Junction Block(Back-Up Lamp Switch), Sport Mode Switch, Speed Sensor, Stop Lamp
Switch, Speed Sensor (In/Out), Transaxle Range Switch
LH25A Power Window Main Switch, Passenger Power Window Switch(RHD)
SPARE25A Spare
10A Rear Fog Lamp Relay
15A Clock Spring
LH7.5A Head Lamp LH, License Lamp LH(Sedan), Rear Combination Lamp (IN) LH(Wagon)
7.5A Front Console Switch, Front Seat Warmer Control Module, Audio, Audio / Video & Navigation Head
Unit, Head Lamp Leveling Device Actuator LH/RH, Air Conditioner Control Module, Electro Chromic
Mirror, Crash Pad Switch, DC-DC Converter, Clock Spring, A/T Shift Lever Indicator
7.5A
Engine Room Junction Block(Multipurpose Check Connector), ABS/ESC (Electronic Stability Control)
Control Module
10A Smart Key Control Module, Stop Lamp Switch
SPARE15A Spare
15A Front Fog Lamp Relay
7.5AEngine Room Junction Block(Air Conditioner Blower Relay), GSL Junction Block(PTC Heater Relay),
DSL Junction Block(Start Relay, Air Conditioner Blower Relay), Air Conditioner Control Module
MODULE510AEngine Room Junction Block(Head Lamp High Relay, Head Lamp Relay), Front Seat Warmer Control
Module, BCM (Body Control Module)


8-85
8
Maintenance

Page 437 of 523

Engine room compartment fuse panel (Kappa 1.0L T-GDI Engine (Gasoline))
SymbolFuse ratingCircuit Protected
80A MDPS Unit
ALT150A Fuse - RR DEFOG, ABS1, ABS2, BLOWER
40A Rear Defogger Relay
140A ABS/ESC (Electronic Stability Control) Control
40A ABS/ESC (Electronic Stability Control) Control, Multipurpose Check Connector
40A Air Conditioner Blower Relay
10A Wiper Motor, Multifunction Switch, Wiper LO Relay
10A Cooling Fan Relay
10A Oxygen Sensor (Up), Oxygen Sensor (Down), RCV Control Solenoid Valve
15AECM (Engine Control Module), Oil Control Valve #1, #2, Purge Control Solenoid Valve, Air Condi‐
tioner Clutch Type ECV Relay
10A Head Lamp RH
10A Head Lamp LH
E315A ECM (Engine Control Module)
E415A ECM (Engine Control Module)


8-91
8
Maintenance

Page:   < prev 1-10 ... 11-20 21-30 31-40 41-50 51-60 61-70 next >