drain bolt LAMBORGHINI GALLARDO 2009 Workshop Manual
Page 590 of 1659
3
L714 02 65 03
'
A
C
) L J
A
%
'
) L J
® Automobili Lamborghini S.p.A. 7 K H L Q I R U P D W L R Q D Q G S U R F H G X U H V S X E O L V K H G E H O R Z D U H V W U L F W O \ F R Q ¿ G H Q W L D O D Q G H [ F O X V L Y H O \ I R U W K H / D P E R U J K L Q L ' H D O H U 1 H W Z R U N D Q G $ X W K R U L ] H G 6 H U Y L F H 3 R L Q W V $ O O F R S \ U L J K W V D U H S U R S H U W \ R I $ X W R P R E L O L
/ D P E R U J K L Q L 6 S $ E D V H G R Q F R S \ U L J K W O D Z $ O O R I W K H 3 ' ) F K D S W H U V L Q W K H : ( % Z R U N V K R S P D Q X D O V G H V F U L E H G E H O R Z D U H E D V H G R Q L Q I R U P D W L R Q D Y D L O D E O H D W W K H W L P H R I S X E O L F D W L R Q 7 K H F R P S D Q \ U H V H U Y H V
W K H U L J K W W R P D N H X S G D W H V D Q G P R G L ¿ F D W L R Q V 7 K H I R O O R Z L Q J D U H S U R K L E L W H G U H S U L Q W L Q J U H S U R G X F W L R Q I R U Z D U G L Q J W R X Q D X W K R U L ] H G S H R S O H D Q G R U W K L U G S D U W L H V D Q G W U D Q V O D W L R Q L Q F O X G L Q J S D U W L D O Z L W K R X W
Z U L W W H Q D X W K R U L ] D W L R Q I U R P $ X W R P R E L O L / D P E R U J K L Q L 6 S $
% + H D W L Q J Z D W H U S X P S G L V D V V H P E O \ 7 K H K H D W L Q J V \ V W H P O R Z À R Z S X P S $ ) L J ) is located under the car tunnel.
3 U H O L P L Q D U \ R S H U D W L R Q V • Turn the air conditioner to “ON” at the minimum temperature (LO) to close the two solenoid valves that shut off
engine coolant to the air conditioner radiators (left and right).
• Raise the car on the car lift (000000).
• Remove the central and rear F D U À R R U V(082503).
• Remove the propeller shaft (030703).
• Drain W K H Z D W H U F R R O L Q J À X L G V (012107).
' L V D V V H P E O L Q J W K H S X P S
1 R W H Prepare a suitable container for collecting the liquid that leaks when the pump’s pipes are disconnected.
1. Disconnect the connector ( $ ) L J ) L J ).
2. Disconnect the pump’s pipes ( % ) L J ) using the clamps ( & ) L J ) and plug the pipes.
3. Unscrew the 2 bolts of the 2 clamps that secures the pump to the bracket ( ' ) L J ) L J ).
4. Remove the heating system pump.