rear view mirror Lexus ES300 2000 s (in English) User Guide
Page 149 of 501
COMFORT ADJUSTMENT
129
Folding rear view mirrors
16E198
To fold the rear view mirror, push backward.
The rear view mirrors can be folded backward for
parking in restricted areas.
CAUTION
Do not drive with the mirrors folded backward. Both the
driver and passenger side rear view mirrors must be
extended and properly adjusted before driving.
Page 150 of 501
COMFORT ADJUSTMENT
130
INSIDE REAR VIEW MIRROR
16E178
Page 151 of 501
COMFORT ADJUSTMENT
131
Adjust the m
irror so that you can just see the rear of
your vehicle in the mirror.
Pushing the switch changes the mode between
ªAUTOº and ªDAYº.
The indicator comes on when the ªAUTOº mode is
selected.
ªDAYº mode: The mirror surface is normal.
ªAUTOº mode: If the mirror detects light from the
headlights of the vehicle behind you, the mirror
surface darkens slightly to reduce the reflected
light.
When the inside rear view mirror surface changes, the
driver's side outside rear view mirror surface will also
become darker.
When the ignition key is inserted and turned on, the
inside rear view mirror always turns on in the ªAUTOº
mode. When the outside air temperature is low, it may take a
little longer for the mirror to darken in response to the
detection of headlights.
CAUTION
Do not adjust the mirror while the vehicle is moving. It
may cause the driver to mishandle the vehicle and an
accident may occur resulting in personal injuries.
Page 219 of 501
COMFORT ADJUSTMENT
199
DRIVING POSITION MEMORYSYSTEM
The micro computer can memorize the positions of the
driver's seat and outside rear view mirrors. Two dif ferent
driving position profiles can be entered into the
computer's memory.
Recording a driving position in the computer's memory
can only be done when the ignition key is in the ªONº
position and the selector lever is in the ªPº position.
Setting a driving position
16E047
Page 220 of 501
COMFORT ADJUSTMENT
2001. Adjust the driver's seat and outside rear view
mirrors to the desired position.
2. While
pushing the ªSETº button, push button ª1º
or ª2º until the signal beeps.
The beep sound means that the positions are recorded
in the computer's memory. By repeating these two steps and pressing the
remaining button, the driving position for another driver
can be recorded.
To set a new memorized position, select the desired
position and perform step 2. The previous memory will
be erased and the new position will be set.
To make only slight changes to an already memorized
position, the easiest way is to first activate the
memorized position, then make the desired changes
and perform step 2 above.
Page 296 of 501
STARTING AND DRIVING
276
To allow proper operation of your vehicle's
ventilation system, keep the inlet grilles in front
of the windshield clear of snow, leaves, or other
obstructions.
If you smell exhaust fumes in the vehicle, drive
with the windows open and the trunk lid closed.
Have the cause immediately located and
corrected.BEFORE STARTING THE ENGINE
1. Check the area around the vehicle before entering it.
2. Adjust seat position, seatback angle, head restraint
height and steering wheel angle.
3. Adjust the inside and outside rear view mirrors.
4. Lock all doors.
5. Fasten seat belts.
Remember to check that the service reminder indicators
function when turning the key to ªONº, and check the fuel
gauge to see that you have sufficient fuel.
Page 347 of 501
DRIVING TIPS
327
Tires
Ensure that your vehicle's tires are properly inflated.
Adjust the tire pressure to the recommended cold tire
pressure indicated below:
Tire pressure, kPa (kgf/cm
2 or bar, psi)
Front 220 (2.2, 32)
Rear 220 (2.2, 32)
The trailer tires should be inflated to the pressure
recommended by the trailer manufacturer in respect
to the total trailer weight.
Trailer lights
Trailer lights must comply with federal,
state/provincial and local regulations. See your local
recreational vehicle dealer or rental agency for the
correct type of wiring and relays for your trailer.
Check for correct operation of the turn signals and
stop lights each time you hitch up. Direct splicing may
damage your vehicle's electrical system and cause a
malfunction of your lights.
Break±in schedule
Lexus recommends that you do not tow a trailer with
a new vehicle or a vehicle with any new power train
component (engine, transmission, differential, wheel
bearing, etc.) for the first 800 km (500 miles) of
driving.
Maintenance
If you tow a trailer, your vehicle will require more
frequent maintenance due to the additional load. For
this information, please refer to the scheduled
maintenance information in the ªOwner's Manual
Supplement/ Maintenance Scheduleº.
Retighten all fixing bolts of the towing ball and bracket
after approximately 1000 km (600 miles) of trailer
driving.
Pre±towing safety check
Check that your vehicle remains level when a loaded
or unloaded trailer is hitched. Do not drive if the
vehicle has an abnormal nose±up or nose±down
condition, and check for improper tongue load,
overload, worn suspension or other possible causes.
Make sure the trailer cargo is securely loaded so that
it cannot shift.
Check that your rear view mirrors conform to any
federal, state/provincial or local regulation. If they do
not, install required rear view mirrors appropriate for
towing purposes.
Page 462 of 501
ELECTRICAL COMPONENTS
442
No.FUSEAMPERECIRCUIT
28 WIPER25Windshield wipers and
washer
29 MIRROR
±HEATER10Outside rear view mirror
defogger
30 ECU±IG15
Cruise control system,
Anti±lock brake system,
Shift lock system, Theft
deterrent system,
Electronic modulated
suspension, Wireless
remote control
31 IGN5SRS, Multiport fuel
injection
32 STOP15
Stop lights, High mounted
stoplight, Cruise control
system, Electronic
modulated suspension,
Anti±lock brake system,
Shift lock system, Power
seat system, Multiport
fuel injection
33 TAIL10Tail light, Side marker
lights, License plate lights
34 POWER
±OUTLET15Power outlet
35 OBD7.5On±board diagnosis
system
36 FOG15Fog lights
No.FUSEAMPERECIRCUIT
37 STARTER5Starting system
38 DOOR25
Door courtesy light, Theft
deterrent system, Power
door lock system, Trunk
lid opener, Fuel filler door
opener
39 PANEL7.5Instrument panel lights,
Glove box light
40 TURN7.5Emergency flashers, Turn
signal lights
41 RAD± NO.27.5Audio system
42 CIG15Cigarette lighter, Clock,
SRS
43 DEF40Rear window defogger,
Outside rear view mirror
defogger
44 PWR30Power window, Electronic
moon roof, Power seat
system
45 AM140No circuit
SPARESpare fuse