Capacity lexus LS400 1998 Engine / LEXUS 1998 LS400 OWNER'S MANUAL (OM50498U)

Page 49 of 304

GAUGES, METERS AND SERVICE REMINDER INDICATORS
34
FUEL GAUGE
13L0011
Low fuel level warning light
The gauge is displayed when the ignition switch is on and
indicates the approximate quantity of fuel remaining in the tank.
It is a good idea to keep the tank over 1/4 full.
If the fuel level approaches ”E” or the low fuel level warning light
comes on, fill the fuel tank as soon as possible.
On inclines or curves, due to the movement of fuel in the tank, the
fuel gauge needle may fluctuate or the low fuel level warning light
may come on earlier than usual.
If the fuel tank is completely empty, the malfunction indicator lamp
comes on. Fill the fuel tank immediately.
The indicator lamp goes off after driving several times. If the
indicator lamp does not go off, contact your Lexus dealer as soon as
possible.
See the inner back cover for fuel capacity and recommended fuelselection.
ENGINE COOLANT
TEMPERATURE GAUGE
13L0022
Normal range
The gauge indicates the engine coolant temperature when the
ignition switch is on. The engine operating temperature will
vary with changes in weather and engine load.
If the needle points to the red zone or higher, stop your vehicle and
allow the engine to cool.
Your vehicle may overheat during severe operating conditions, such
as:
Driving up a long hill on a hot day.
Reducing speed or stopping after high speed driving.

Page 68 of 304

INTERIOR EQUIPMENT
53
POWER OUTLET
14L0381
The power outlet is designed for power supply for car
accessories.
The ignition key must be in the ”ACC” or ”ON” position for the
power outlet to be used.
NOTICE
To prevent the fuse from being blown, do not use the
electricity over the total vehicle capacity of 3.5A/12V.
To prevent the battery from being discharged, do not use the
power outlet longer than necessary when the engine is not
running.
Close the power outlet lid when the power outlet is not in use.
Inserting a foreign object other than the appropriate plug
that fits the outlet, or allowing any liquid into the outlet may
cause electrical failure or short circuits.

Page 75 of 304

INTERIOR EQUIPMENT
60
NOTICE
Do not load the vehicle beyond the vehicle capacity weight
specified on the tire pressure label inside the glovebox lid.

Page 197 of 304

DRIVING TIPS
182Do not rest your foot on the brake pedal while driving. It
can cause dangerous overheating, needless wear, and poor
fuel economy.
To drive down a long or steep hill, reduce your speed and
downshift. Remember, if you ride the brakes excessively,
they may overheat and not work properly. See page 163.
Be careful when accelerating, upshifting, downshifting or
braking on a slippery surface. The abrupt change in engine
speed, such as sudden acceleration or engine braking, could
cause the vehicle to spin or skid.
Do not drive in excess of the speed limit. Even if the legal
speed limit permits it, do not drive over 140 km/h (85 mph)
unless your vehicle has highspeed capability tires.
Driving over 140 km/h (85 mph) may result in tire failure,
loss of control and possible injury. Be sure to consult a tire
dealer to determine whether the tires on your vehicle are
highspeed capability tires or not before driving at such
speeds.
Do not continue normal driving when the brakes are wet.
If they are wet, your vehicle will require a longer stopping
distance, and it may pull to one side when the brakes are
applied. Also, the parking brake will not hold the vehicle
securely.
WINTER DRIVING TIPS
Make sure you have ethyleneglycol antifreeze in the radiator.
NOTICE
Do not use alcohol type antifreeze.
Check the condition of the battery and cables.
Cold temperatures reduce the capacity of any battery, so it must be
in top shape to provide enough power for winter starting. Page 253
tells you how to visually inspect the battery. Your Lexus dealer and
most service stations will be pleased to check the battery charge
level.
Make sure the engine oil viscosity is suitable for the cold weather.
See page 232 for recommended viscosity. Leaving a heavy summer
oil in your vehicle during winter months may cause harder starting.
If you are not sure about which oil to use, call your Lexus dealer
they will be pleased to help.
Check the electronic ignition system for loose connections or
obvious damage.
Keep the door locks from freezing.
Squirt lock deicer or glycerine into the locks to keep them from
freezing.

Page 240 of 304

62L0051
Temperature range anticipated before next oil change
ENGINE
225
SPECIFICATIONS
GENERAL
Model
Type
Bore and stroke
Displacement
Valve clearance (engine cold)
Intake
Exhaust
Drive belt tension
1UZFE
8 cylinder V type, 4 cycle, gasoline
87.5 X 82.5 mm (3.44 X 3.25 in.)
3969 cm
3 (242.1 cu.in.)
0.15 0.25 mm (0.006 0.010 in.)
0.25 0.35 mm (0.010 0.014 in.)
Automatic adjustment
LUBRICATION SYSTEM
Oil capacity
Drain and refill
with filter
without filter
Oil grade

Recommended oil viscosity (SAE):
5.6 L (5.9 qt., 4.9 lmp.qt.)
5.3 L (5.6 qt., 4.7 lmp.qt.)
API SH, ”EnergyConserving II” or SJ, ”EnergyConserving”
multigrade engine oil or ILSAC multigrade engine oil

Page 241 of 304

ENGINE
226 COOLING SYSTEM
Capacity
Coolant type
10.8 L (11.4 qt., 10.4 lmp.qt.)
Ethylene glycol coolant (Do not use alcohol type.)
FUEL
Fuel type
Octane rating
Only UNLEADED
91 (Research octane number 96) or higher
IGNITION SYSTEM
Spark plug Make DENSO
NGK
Gap
SK20R11
IFR6A11
1.1 mm (0.043 in.)
ELECTRICAL SYSTEM
Battery Maintenance type battery
Specific gravity reading at 20C (68F):
Charging rates Quick charge
Slow charge
Nonmaintenance battery
Open voltage at 20C (68F):
Charging rates
1.260 Fully charged
1.160 Half charged
1.060 Discharged
15A max.
5A max.
12.7V Fully charged
12.3V Half charged
11.9V Discharged
[Voltage that is checked 20 minutes after the key is removed with
all the lights turned off]
5A max.

Page 243 of 304

ENGINE
228
Improved gasolines
The American Automobile Manufacturers Association (AAMA)
has developed a specification of improved gasolines. The AAMA
specification offers optimal fuel information for better vehicle
performance and better protection of your engine.
Lexus recommends the use of gasolines that meet the AAMA
specification, if available, for improved drivability and emission
control system.
Gasolines containing MTBE
Gasolines that contain MTBE (Methyl TertiaryButyl Ether)
are available in the market. If you use a gasoline mixed with
MTBE, make certain that it does not contain more than 15% of
MTBE.
If the use of gasolines containing MTBE causes poor drivability
and/or poor fuel economy, you should stop using them.
Gasolines containing MMT
Some gasolines contain an octaneenhancing additive called
MMT (methylcyclopentadienyl manganese tricarbonyl).
Lexus does not recommend the use of gasolines that contain MMT.
If fuels containing MMT are used, your emission control system may
be adversely affected. The Malfunction Indicator Lamp on the
instrument cluster may come on. If this happens, contact your Lexus
dealer for service.
Gasolines containing alcohol
Gasohol is a mixture of gasoline and ethanol. If you use gasohol
in your Lexus, be sure that it is unleaded, has an octane rating
no lower than 87 and does not contain more than 10% ethanol.
Lexus does not recommend the use of gasolines containing
methanol.
If you use gasoline containing methanol, use only gasoline meeting
the requirements above and also containing less than 5% methanol
with cosolvents and corrosion inhibitors for methanol.
NOTICE
Do not use gasohol other than stated above. It will cause fuel
system damage or vehicle performance problems.
If drivability problems are encountered (poor hot starting,
vaporizing, engine knock, etc.), discontinue its use.
Take care not to spill gasohol during refueling. Gasohol may
cause paint damage.
Fuel tank capacity
85 L (22.5 gal., 18.7 lmp.gal.)

Page 248 of 304

ENGINE
233
CHECKING THE ENGINE
COOLANT LEVEL
62L007-2
1
Reservoir cap 2
Upper line 3
Lower line
Park the vehicle at a level spot and look at the seethrough
coolant reservoir when the engine is cool. The coolant level is
satisfactory if it is between the upper and lower lines on the tank.
If the level is low, add ethyleneglycol type coolant.
The coolant level in the reservoir will vary with engine coolant
temperature. However, if the level is on or below the lower line, add
coolant to bring the level up to the upper line.
Use only ethyleneglycol type coolant. It will prevent freezing and
corrosion. Neither supplemental inhibitors nor additives are needed
nor recommended. (For information on ethyleneglycol coolant,
see also ”Engine coolant selection” described below.)If the coolant level drops within a short time after replenishing, there
may be a leak in the system. Visually check the radiator, hoses,
reservoir cap, drain cock and water pump.
If you can find no leak, have your Lexus dealer test the cap pressure
and check for leaks in the cooling system.
CAUTION
To prevent burning yourself, do not remove the reservoir cap
when the engine is hot.
Engine coolant selection
Your coolant must contain ethyleneglycol antifreeze. In addition
to preventing freezing and subsequent damage to the engine, this
will also prevent corrosion. Further supplemental inhibitors or
additives are neither needed nor recommended.
Read the antifreeze container for information on freeze protection.
Follow the manufacturer’s directions for how much to mix with
water. The total capacity of the cooling system is given on page 226.
We recommend 50% solution be used for your Lexus, or a sufficient
quantity to provide protection to about 35C (31F).
NOTICE
Do not use alcohol type antifreeze or plain water alone.

Page 252 of 304

CHASSIS
237
SPECIFICATIONS
AUTOMATIC TRANSMISSION
Fluid capacity
Drain and refill
Fluid type
1.9 L (2.0 qt., 1.7 lmp.qt.)
Automatic transmission fluid Type T IV or equivalent
DIFFERENTIAL
Oil capacity
Oil type
Oil viscosity
1.3 L (1.4 qt., 1.1 lmp.qt.)
Hypoid gear oil API GL5
Above 18C (0F): SAE 90
Below 18C (0F): SAE 80W or SAE 80W90
BRAKES
Pedal clearance
Pedal freeplay
Brake pad wear limit
Parking brake lining wear limit
Parking brake adjustment
Fluid type
70 mm (2.8 in.) Min. *1
1 6 mm (0.04 0.24 in.)
1.0 mm (0.04 in.)
1.0 mm (0.04 in.)
5 7 clicks *
2
SAE J1703 or FMVSS No. 116 DOT 3
*1: Minimum pedal clearance when depressed with the pressure of 490 N (50 kgf, 110 lbf.) with the engine running
*
2: Parking brake adjustment when depressed with the pressure of 294 N (30 kgf, 66.1 lbf.)

Page 253 of 304

CHASSIS
238 STEERING
Freeplay
Power steering fluid
Less than 30 mm (1.2 in.)
Automatic transmission fluid DEXRONII or III
TIRES AND WHEELS
Tire size
Tire inflation pressure
Recommended cold tire inflation pressure
Vehicle load up to four occupants
Vehicle loaded up to vehicle capacity weight
Wheel size
Wheel nut torque
P225/60R16 97V
Front 200 kPa (2.0 kgf/cm
2
or bar, 29 psi)
Rear 200 kPa (2.0 kgf/cm2 or bar, 29 psi)
Front 220 kPa (2.2 kgf/cm
2 or bar, 32 psi)
Rear 220 kPa (2.2 kgf/cm2 or bar, 32 psi)
For sustained high speeds above 160 km/h (100 mph), in
countries where such speeds are permitted by law, add 80 kPa (0.9
kgf/cm
2, 0.8 bar, 12 psi) to the front tires and rear tires, but never
exceed the maximum cold tire pressure molded on the tire
sidewall.
16 x 7 JJ
103 N·m (10.5 kgf·m, 76 ft·lbf.)

Page:   1-10 11-20 next >