display LEXUS RX330 2006 Repair Manual

AUDIO
307
Display
To use the display, push the lock release button and lower
the display until you hear a click.
You can adjust the display to your desired angle.
To close, push up the display until you hear a click.

AUDIO
308The illumination of the screen is automatically turned off when
the display is closed. However, the rear seat entertainment
system is not turned off.
CAUTION
To reduce the chance of injury in case of an accident or
sudden stop while driving, close the display when it is
not in use.
NOTICE

The screen should be cleaned with a dry soft cloth.
If the screen is pushed by hand or wiped with a hard
cloth, the surface of the screen may be scratched.
 Benzene or alkaline solutions may damage the
coated surface of the screen.
 To prevent the battery from being discharged, do not
turn on the rear seat entertainment system longer
than necessary when the engine is not running.
Rear seat entertainment system remote
control
The rear seat entertainment system can be operated with
the rear seat entertainment system remote control and the
switches on the DVD player. The system cannot be
operated by touching the switches on the screen directly.
CAUTION
Do not disassemble or modify the remote control. It
may cause an accident, fire or electric shock.
NOTICE
Keep the remote control away from direct sunlight, high
heat and high humidity. These conditions could cause
the case to deform or the battery to explode or leak.

AUDIO
310(b) Using the remote control
To use the rear seat entertainment system remote control,
direct
the signal output portion of the remote control to the
signal reception portion of the rear seat entertainment
system display.
The remote control does not operate properly when the signal
reception portion of the display is exposed to direct sunlight.
Block the display from direct sunlight.
CAUTION
To reduce the chance of injury in case of an accident or
a sudden stop while driving, stow the remote control in
the console box or front seatback pocket when it is not
in use.

AUDIO
314
1“DVD” button: Turn on the DVD mode.
2“SOURCE” button: Turn on the rear seat
entertainment system and selects the mode.
3“INFO” button: Indicate the “Information Menu”
screen. (See the separate “Navigation System
Owner’s Manual”.)
4“MENU” button: Indicate the “Menu” screen when the
navigation system is operated. (See the separate
“Navigation System Owner’s Manual”.)
5“OFF” button: Turn off the rear seat entertainment
system.
6Joy stick: Select a control switch, mode switch on the
screen or the menu for the disc.
7“ENT” button: Input the selected switch or the
selected menu for the disc.
8“DISC/CH/PROG” button: Skip directly to a desired
preset station, disc, track or chapter.
9“  ” button: Fast forwards a screen when the DVD
player is operated.
10“RETURN” button: Skip to the predetermined scene
for the disc.
11“MENU” button: Indicate the menu screen for DVD
video when the DVD player is operated.
12“AUDIO” button: Indicate the changing audio screen
when the DVD player is operated.
13“SUB TITLE” button: Indicate the changing subtitle
screen when the DVD player is operated.
14“DISPLAY” button: Adjust the color, tone, contrast
and brightness of the screen.
15“SET UP” button: Indicate the initial set up screen
when the DVD player is operated.
16“ANGLE” button: Select the angle of the screen when
the DVD player is operated.
17“SEARCH” button: Indicate the title search screen
when the DVD player is operated.
18“TOP MENU” button: Indicate the title selection
screen for DVD video when the DVD player is operated.
19“” button: Pause a screen when the DVD player is
operated.
20“  ” button: Reverse a screen when the DVD player
is operated.
21“  ” button: Play a screen when the DVD player is
operated.
22“TUNE/TRACK” button: Operate the front audio
system or select the track/chapter when the DVD
player is operated.
23“CURSOR” button: Indicates the control switches on
the screen when the DVD player is operated.
24“MAP” button: Indicate the map screen when the
navigation system is operated. (See the separate
“Navigation System Owner’s Manual”.)
25“DEST” button: Indicate the “Destination” screen
when the navigation system is operated. (See the
separate “Navigation System Owner’s Manual”.)
26“VIDEO” button: Turn on the video mode when your
personal audio device is connected.

AUDIO
315
Buttons on the DVD player unit
The rear seat entertainment system can be operate with the
switches on the DVD player.
1“” (eject) switch: Use this switch to eject the disc
from the DVD player.
2“SOURCE” switch: Push this switch to turn on the rear
seat entertainment system.
To change the audio mode, turn on the system and push the
source switch until the mode you desire is displayed. If a tape
or disc is not inserted, the “TAPE”, “CD” and “DVD” modes are
skipped.
3“TUNE/TRACK” switch: Use this switch to tune or seek
(radio mode), fast forward or rewind (“TAPE” mode),
select a desired track (“CD” mode) or select a desired
chapter/track (“DVD” mode).
Radio mode: Use this switch to tune or seek.
 To tune, repeatedly push this switch briefly until your desired
station is found.
 To seek, push and hold this switch until you hear a beep.
The radio will begin seeking up or down the band for a
station, and will stop on reception.
TAPE mode: Use this switch to fast forward or rewind a tape,
or for automatic program selection.
 To skip forward or rewind using automatic program
selection, push this switch briefly. By using automatic
program selection, you can skip up to 9 programs at a time.
For details, see page 276 or 296.
 To fast forward or rewind the tape, push and hold this switch
until you hear a beep. To stop fast forwarding or rewinding,
push and hold the same side of the switch until you hear a
beep.

AUDIO
316CD or DVD
mode: Use this switch to fast forward/rewind a disc
or select a desired track (“CD” mode)/chapter·track (“DVD\
”
mode).
 To select a desired track (“CD” mode) or chapter/track
(“DVD” mode), push this switch briefly.
 To fast forward or rewind a disc, push and hold this switch
until you hear a beep. To stop fast forwarding or rewinding,
push and hold the same side of the switch until you hear a
beep.
4“DISC/CH/PROG” switch: Use this switch to select a
preset station (radio mode), reverse side of a tape
(“TAPE” mode) or a desired CD (“CD” mode).
Radio mode: Push this switch to select a preset station. The
station you assigned to that particular switch on the audio
system will be selected.
“TAPE” mode: Push this switch to select the reverse side of
a cassette tape.
“CD” mode: Push this switch to select a desired CD (for a CD
changer only). Push until the desired CD number appears.
5“CURSOR (REMOTE)” switch: Use this switch to
display the DVD control switches or to locate the remote
control when you lose sight of the remote control.
6Joy stick and “ENT” switch: Use this joy stick to select
a control switch, mode switch on the screen or the menu
for a disc. Push the “ENT” switch to input the selected
switch or menu.
7“DISC” indicator light: This light indicates that the disc
is loaded.

AUDIO
321

1Screen switch2Remote control button
3DVD player unit
Use the joy stick to select the mode. Push the “ENT”
button to enter the mode.
The mode display which is selected by the joy stick is
colored blue. When the “ENT” button is pushed, the mode
display changes to green. If the mode display is gray, it
cannot be selected.
The “Speaker sound” on the mode display is selected on the
front audio system.
When you select a mode, the screen indicates which is
selected.Radio operation
(a) Listening to the radio
 AM mode
FM mode

AUDIO
323
Manual tuning: Quickly push and release the “
” or “”
(TUNE/TRACK) button. Each time you push the button, the
radio will step up or down to another frequency. If you push and
hold the button, and the radio will go into the seek mode.
1Remote control button
2DVD player unit
To scan the preset stations: You can scan only the preset
stations for the band of the front audio system. Push the “
”
or “” (DISC/CH/PROG) button. The radio will tune in the next
preset station up or down the band. The station frequency will
appear on the screen.
Cassette tape player operation
(a) Playing a cassette tape
Using joy stick and the “ENT” button to select the cassette tape
mode.
“TAPE” appears on the display.
Autoreverse feature: After the cassette player reaches the
end of a tape, it automatically reverses and begins to play the
other side, regardless of whether the cassette was playing or
fast forwarding.

AUDIO
324(b) Manual program selection
1Remote control button
2DVD player unit
“Program” button: Push the “
” or “” (DISC/CH/PROG)
button to select the other side of a cassette tape. The screen
indicates which side is currently selected. (“
” indicates the
top side, “” indicates the bottom side.)
1Remote control button
2DVD player unit
“Rewind” button: Push the “
” (TUNE/TRACK) button to
rewind a tape. “REW” appears on the display.
To stop rewinding, push the same button.
“Fast forward” button: Push the “
” (TUNE/TRACK) button
to fast forward a cassette tape. “FF” appears on the display.
To stop fast forwarding, push the same button.

AUDIO
325
(c) Automatic program selection
1Remote control button
2DVD player unit
“Automatic program selection” button: The automatic
program selection feature allows you to program your cassette
player to skip forward or backward to locate the song you want
to hear. You can skip up to 9 programs at a time.
Push the “
” (TUNE/TRACK) button to skip forward. “FF” and
the number will appear on the display. Push the button until the
number you want to skip appears on the display. After that, the
player will automatically skip forward.
When the end of the tape is reached, the player automatically
reverses sides and resumes normal play. Push
the “
” (TUNE/TRACK) button to skip backward. Push
the button until “REW” and the number you want to skip appear
on the display.
 If you set “REW 1”, the player will rewind to the beginning
of the current program.
 When counting the number of programs you want to rewind,
remember to count the current program as well. For
example, if you want to rewind to a song that is two before
the song you are listening to, push this button until “REW
3” appears on the display.
When the beginning of the tape is reached, the player
automatically resumes normal play.
There must be at least 3 seconds of blank space between
programs for this feature to work correctly.
This feature may not work well with some spoken word, live or
classical recordings.