MAZDA MODEL 2 2019 Owners Manual (in English)

Page 321 of 759

¾The front doors or the boot is not fully closed.
¾The vehicle is on a road incline.
¾The door mirrors are retracted.
¾Do not hit the front/rear camera, front bumper, and door mirrors forcefully. The camera
position or installation angle may shift.
¾The cameras are of a waterproof structure. Do not disassemble, modify, or remove a
camera.
¾The camera cover is made of hard plastic, therefore do not apply oil film remover, organic
solvents, wax, or coating agents. If any such agent gets on the camera cover, wipe it off
using a soft cloth immediately.
¾Do not rub the camera lens forcefully, or clean it with an abrasive or hard brush. Otherwise,
it could scratch the camera lens and negatively affect the images.
¾Consult an expert repairer (we recommend an Authorised Mazda Repairer) for repair,
painting, or replacement of the front/rear camera, front bumper and door mirrors.
¾Heed the following cautions to assure that the 360°View Monitor operates normally.
¾Do not modify the vehicle suspensions or lower/raise the vehicle body, or both.
¾Always use wheels of the specified type and size for the front and rear wheels. Consult an
expert repairer (we recommend an Authorised Mazda Repairer) for tyre replacement.
¾When the display is cold, images may leave trails or the screen might be darker than usual,
making it difficult to check the vehicle surroundings. Always confirm the safety at the front
and around the vehicle visually when driving.
¾The method for parking/stopping the vehicle using the 360°View Monitor differs depending
on the road circumstances/conditions and the vehicle conditions. When and how much you
turn the steering wheel will differ depending on the situation, , therefore always check the
vehicle surroundings directly with your eyes while using the system.
Also, before using the system, always make sure that the vehicle can be parked/stopped in
the parking/stopping space.
NOTE
xIf there are water droplets, snow, or mud on the camera lens, wipe it off using a soft cloth.
If the camera lens is especially dirty, wash it off with mild detergent.
xIf the area where the camera is installed, such as the boot (Saloon)/rear bumper
(Hatchback) or door mirrors, has been damaged in a vehicle accident, the camera
(position, installation angle) may have shifted. Always consult an expert repairer (we
recommend an Authorised Mazda Repairer) to have the vehicle inspected.
xIf the camera is subjected to excessive changes in temperature such as by pouring hot
water on the camera during cold weather, the 360°View Monitor may not operate
normally.
xIf the battery voltage is low, the screen might be temporarily difficult to view, however,
this does not indicate a problem.
:KHQ'ULYLQJ
L$&7,96(16(


Page 322 of 759

xThe 360°View Monitor has limitations. Objects under the bumper or near both ends of the
bumper cannot be displayed.
xObstructions above the upper image range of the camera are not displayed.
xUnder the following conditions, the screen might be difficult to view, however this does
not indicate a problem.
xThe temperature near the lens is high/low.
xRainy conditions, water droplets on the camera, or high humidity.
xMud or foreign matter near the camera.
xExtremely bright light such as sunlight or headlights hitting the camera lens directly.
xBecause the 360°View Monitor camera uses a special lens, the distance displayed on the
screen differs from the actual distance.
xObstructions displayed on the screen may appear differently than in actuality.
(Obstructions may appear fallen, larger, or longer than they actually are.)
xDo not apply stickers to a camera or the area around it. In addition, do not install
accessories or an illuminated number/character number plate to the area around a
camera. Otherwise, the camera may not correctly display the surrounding conditions.
:KHQ'ULYLQJ
L$&7,96(16(


Page 323 of 759

▼7\SHVRI,PDJHV'LVSOD\HGRQWKH6FUHHQ
7RSYLHZ)URQWYLHZ
'LVSOD\VWKHLPDJHRIWKHDUHDDURXQGWKHYHKLFOHDQGWKHYHKLFOHIURQW
Front view screenTop view screen

)URQWZLGHYLHZ
'LVSOD\VWKHLPDJHRIWKHIURQWRIWKHYHKLFOH ZLGHDUHD 

6LGHYLHZ
'LVSOD\VWKHLPDJHRIWKHOHIWDQGULJKWVLGHVRIWKHYHKLFOH

:KHQ'ULYLQJ
L$&7,96(16(


Page 324 of 759

7RSYLHZ5HDUYLHZ
'LVSOD\VWKHLPDJHRIWKHDUHDDURXQGWKHYHKLFOHDQGWKHUHDURIWKHYHKLFOH
Rear view screenTop view screen

5HDUZLGHYLHZ
'LVSOD\VWKHLPDJHRIWKHUHDURIWKHYHKLFOH ZLGHDUHD 
:KHQ'ULYLQJ
L$&7,96(16(


Page 325 of 759

▼+RZWR8VHWKH6\VWHP
7RSYLHZ)URQWYLHZ)URQWZLGHYLHZ6LGHYLHZ
,QGLFDWLRQ
,PDJHVDUHGLVSOD\HGRQWKHVFUHHQZKHQWKH

Page 326 of 759

'LVSOD\VZLWFKLQJ
<RXFDQFKDQJHWKHGLVSOD\HGVFUHHQE\SUHVVLQJWKHFRPPDQGHUNQRERUE\WRXFKLQJWKH
VZLWFKFDPHUDLFRQRQWKHVFUHHQZKLOHWKHWRSYLHZIURQWYLHZIURQWZLGHYLHZRUWKHVLGH
YLHZLVGLVSOD\HG
Top view/Front viewSwitch camera icon
Front wide view
Side view
:KHQ'ULYLQJ
L$&7,96(16(


Page 327 of 759

NOTE
xWhen the shift lever/selector lever is in R position, the displayed screen does not switch to
the top view/front view, front wide view, or the side view.
xDisplay of the top view/front view, front wide view, or the side view stops even with the
display conditions met if any of the following conditions occurs.
xWhen a switch around the commander knob is pressed.
x(Manual transaxle)
The parking brake is applied.
x(Automatic transaxle)
The selector lever is shifted to P position (displayed when the selector lever is in a
position other than P).
x(Displayed when vehicle speed is less than 15 km/h (9.3 mph))
x4 minutes and 30 seconds have passed.
xThe vehicle speed is about 15 km/h (9.3 mph) or faster.
x(Displayed when the vehicle speed is about 15 km/h (9.3 mph) or faster)
xThe vehicle speed is about 15 km/h (9.3 mph) or faster after 8 seconds have passed
since pressing the 360°View Monitor switch.
xFour minutes and 22 seconds have passed from the point when the vehicle speed was
less than 15 km/h (9.3 mph) after 8 seconds have passed since pressing the 360° View
Monitor switch.
xThe 360°View Monitor displays the previously displayed screen.
xThe 360° View Monitor settings can be changed as follows.
Refer to Personalisation Features on page 9-15.
xAutomatic display of the 360°View Monitor when the ultrasonic senor detects an
obstruction.
xAutomatic display of the 360°View Monitor when the ignition is switched ON.
7RSYLHZ5HDUYLHZ5HDUZLGHYLHZ
7KHWRSYLHZUHDUYLHZUHDUZLGHYLHZGLVSOD\VZKHQDOORIWKHIROORZLQJFRQGLWLRQVDUH
PHW
x7KHLJQLWLRQLVVZLWFKHG21
x6KLIWOHYHUVHOHFWRUOHYHULVLQ5SRVLWLRQ
:KHQ'ULYLQJ
L$&7,96(16(


Page 328 of 759

'LVSOD\VZLWFKLQJ
7KHGLVSOD\HGVFUHHQFDQEHVZLWFKHGE\SUHVVLQJWKHFRPPDQGHUNQRERUE\WRXFKLQJWKH
VZLWFKFDPHUDLFRQRQWKHVFUHHQZKLOHWKHWRSYLHZUHDUYLHZUHDUZLGHYLHZLVGLVSOD\HG
Top view/Rear view Rear wide view
Switch camera icon
NOTE
xThe top view/rear view and rear wide view automatically display whether or not the 360°
View Monitor switch is turned on or off when shifting the shift lever/selector lever to R
position.
xThe setting can be changed to display the top view/front view when shifting from reverse
to a forward gear without operating the 360°View Monitor switch to check the front of the
vehicle while parallel parking.
Refer to Personalisation Features on page 9-15.
:KHQ'ULYLQJ
L$&7,96(16(


Page 329 of 759

6FUHHQRSHUDWLRQLFRQ
:$ 5 1 , 1 *
Always stop the vehicle when adjusting the 360°View Monitor image quality.
Do not adjust the 360°View Monitor image quality while driving. If you adjust the 360° View
Monitor image quality (such as brightness, contrast, tone, and colour density) while driving, it
could lead to an unexpected accident.
(Display example)
'LVSOD\,FRQ &RQWHQW
9LHZVWDWXVLFRQ ,QGLFDWHVZKLFKLPDJHLVGLVSOD\HGDPRQJWKHIURQWYLHZIURQW
ZLGHYLHZVLGHYLHZUHDUYLHZUHDUZLGHYLHZ
3DUNLQJVHQVRUVWDWXVLFRQ,QGLFDWHVWKDWWKHSDUNLQJVHQVRUKDVDSUREOHPRULWLVVZLWFK(
HGRII
5HDU&URVV7UDIILF$OHUW 5&7$ VWDWXV
LFRQ,QGLFDWHVWKDWWKHUDGDUVHQVRU UHDU KDVDSUREOHPRULWLV
WXUQHGRII
6ZLWFKFDPHUDLFRQ (DFKWLPHWKHVFUHHQLVWRXFKHGWKHGLVSOD\VFUHHQVZLWFKHV
6HWWLQJLFRQ 7KHLPDJHTXDOLW\IRUWKH

Page 330 of 759

'LVSOD\UDQJH
(Actual condition) (Screen display)
Target object
NOTE
xIn the top view screen, the areas in black at the front and rear of the vehicle image and the
seams where each of the camera images merge are blind spots.
xBecause images displayed in the top view screen are processed from each camera, the top
view screen may display in the following ways.
xIf an image containing an object with a conspicuous colour is picked up by any of the
cameras, the whole screen may be affected and it may display in that colour.
xObstructions displayed in the front view may not display on the top view screen.
xIf the position or angle of each camera changes due to tilting of the vehicle, the image
may appear distorted.
xLines on the road may appear distorted at the seams where each of the camera images
merge.
xThe entire screen may appear bright/dark depending on the illumination level around
any of the cameras.
:KHQ'ULYLQJ
L$&7,96(16(


Page:   < prev 1-10 ... 281-290 291-300 301-310 311-320 321-330 331-340 341-350 351-360 361-370 ... 760 next >