tow MERCEDES-BENZ C-CLASS SALOON 2018 Owners Manual

0007
Pull plug 5and thefiller hose out of the
tyre inflation compressor housing. 0007
Unscr ew the cap from theva lve on the col‐
lapsible emer gency spa rewheel. 0007
Screw union nut 1ofthefiller hose onto
th eva lve.
If necessar y,unscr ewthe plug-type connec‐
tion from the union nut beforehand. 0007
Make sure on and off switch 2ofthe tyre
inflation compressor is set to0. 0007
Insert plug 5in a soc ket in your vehicle.
R Cigar ette lighter soc ket: ( 0013 page130)
R 12V soc ket:
R Obser vethe no tes on the cigar ette lighter:
(0013 page130)
R Obse rveth e no tes on soc kets: 0007
Turn theke yto position 0047inthe ignition
loc k. 0007
Press on and off switch 2onthe tyre infla‐
tion compressor toI.
The tyre inflation compressor is switched on.
The tyre is inflated. The tyre pressure is
shown on manome ter3. 0007
Pump the tyre tothe specified tyre pressure.
The specified tyre pressure is printed on the
ye llow label of the emer gency spa rewheel. 0007
When the specified tyre pressure has been
re ached, press on and off swit ch2 onthe
tyre inflation compressor to0.
The tyre inflation compressor is switched off. 0007
Turn theke yto position 005Ainthe ignition
loc k. 0007
Ifth e tyre pressure is higher than the speci‐
fi ed pressure, press pressure release valve
bu tton 4until the cor rect tyre pressure has
been reached. 0007
Unscr ew union nut 1ofthefiller hose from
th eva lve.
If necessar y,scr ew the plug-type connection
back onto the union nut. 0007
Screw theva lve cap onto the collapsible
emer gency spa rewheel valve again. 0007
Stow plug 5and thefiller hose in the lo wer
section of the compressor housing. 0007
Stow th e tyre inflation compressor in the
ve hicle. 47 0
Wheels and tyres

Note
s ontech nical data
Mercedes-AMG vehicles: be sure toobser ve
th e no tes in the Supplement. Otherwise, you
may failto recognise dangers.
Plug-in hybrid: be sure toobser vethe no tes in
th e Supplement. Otherwise, you may failto rec‐
ognise dangers.
The tech nical da tawa s de term ined in accord‐
ance with EU Directives. The data stated on ly
applies tovehicles with standard equipment. Yo u
can obtain fur ther information from a Mercedes-
Benz Service Centre.
Only for ce rtain countries: you can find vehi‐
cle-specific vehicle data in the EC-Certificate of
Conformity (CERTIFIC ATE OF CONFORMITY).
These documents are deli vered with your vehi‐
cle. On-board electronics
Note
s on tampering with the engine elec‐
tronics 000E
NO
TEPremature wearthro ugh improper
main tenance Improper maintenance may cause
vehicle
components towe ar more quickly and the
ve hicle's operating permit may be in valida‐
te d. 0007
Alw ays ha vewo rkon the engine elec‐
tronics and related components car ried
out at a qualified specialist workshop. Tw
o-w ayradios Note
s onfitting two-w ayradios 000A
WARNING Risk of accident due to
improper workon two-w ayradios
The elect romagnetic radiation from two-w ay
ra dios can inter fere with the on-board elec‐ tronics if RF transmit
ters are manipulated or
re trofitted inco rrectly.
This could jeopardise the operating saf ety of
th eve hicle. 0007
You should ha veall workon electrical
and electronic components car ried out
at a qualified specialist workshop. 000A
WARNING Risk of accident from incor‐
re ct ope ration of two-w ayradios
If yo u operate two- wayra dios inco rrectly in
th eve hicle, the electromagnetic radiation
could inter fere with the on-board electronics,
e.g.:
R ifth e two-w ayradio is not connec tedto
an exterior aerial
R ifth eex terior aerial is not cor rectly
mounted or is not of low reflection
This could jeopardise the operating saf ety of
th eve hicle. 0007
Have the lo w-reflection exterior aerial
fi tted at a qualified specialist workshop. Te
ch nical da ta471

Model
Vehicle
height
C 300 1447 mm
C 200 4MATIC (205.079) 1449 mm
All other models 1452 mm We
ights and loads Please no
tethat forth e specified vehicle data:
R items of optional equipment increase the
unladen weight and reduce the pa yload.
R vehicle-specific weight information can be
fo und on theve hicle identification plate .
Ro of load All models
Maximum
roof load 75kg Tr
ailer hitch Gene
ral no tes on the trailer hit ch Not all models can be used
for trailer operation
(0013 page 262).
Modi fications tothe engine cooling sy stem may
be necessar y,depending on theve hicle model.
The retrofitting of a trailer hitch is only pe rmissi‐
ble if a towing capacity is specified in your vehi‐
cle documents.
Fu rther information can be obtained at a quali‐
fi ed specialist workshop. Mounting dimensions
1
Fastening points
2 Overhang dimension
3 Rear axle centre line 486
Tech nical da ta

The
overhang dimension and fastening points
are valid for a trailer hitch ins talled at thefa c‐
to ry. Model
2 2Over‐
hang dimen‐ sion
All model s1 158 mm Pe
rm issible towing capacity The
tongue weight is not included in theto wing
capacity. Pe
rm issible towing capacit y,braked (at a
minimum start-off gradeability of 8% from a
st andstill) Model
Manual
trans‐
mission Au
to‐
matic
trans‐
mission
C 16 0
C 180 14
00 kg 1800 kg
C 18 0 d
C 200 d 18
00 kg 1800 kg
All other models —1800kg Pe
rm issible towing capacit y,braked (at a
minimum start-off gradeability of 12% from a
st andstill) Model
Manual
trans‐
mission Au
to‐
matic
trans‐
mission
C 16 0
C 180 14
00 kg 1800 kg
C 18 0 d
C 200 d 18
00 kg 1800 kg
All other models —1800kg Te
ch nical da ta487

Pe
rm issible towing capacit y,unbraked Model
Manual
trans‐
mission Au
to‐
matic
trans‐
mission
C 16 0
C 180 72
0kg 730kg
C 18 0 d
C 200 d 71
0kg 750kg
C 200 (205. 077) —710kg
All other models —750kg Maximum
tongue weight 000E
NO
TEDama gecaused bythe trailer
coming loose If
th eto ngue weight used is too lo w,the
trailer may come loose. 0007
The tongue weight must not be below
50 kg. 0007
Use a tongue weight that is as close as
possible tothe maximum permissible
to ngue weight. To
ngue weight Model
Maximumtongue
we ight
All models 75kg Pe
rm issible rear axle load during trailer
operation Axle load
Model
Axle load
C 16 0, manual trans‐
mission
C 18 0, manual trans‐
mission 11
85 kg
C 16 0, auto matic
transmission
C 18 0, auto matic
transmission 11
95 kg
C 200 (205. 077)
C 200 d (205.0 11 )
C 220 d 12
45 kg
C 200 4MATIC 1260 kg
C 220 d 4MATIC 1255 kg
C 300 d1 280kg 488
Tech nical da ta

Display messages
Possible causes/consequences and 0050
0050Solutions
To appl y: 0007
Switch off the ignition.
The electric parking brake is applied automaticall y.
If th e electric parking brake should not be applied, e.g. when washing theve hicle in an automatic car wash or when
having theve hicle towe d, lea vethe ignition switched on. This does not include having theve hicle towe d with the
re ar axle raised.
If th e electric parking brake is not applied automatically: 0007
Switch off the ignition and switch it back on. 0007
Release and then apply the electric parking brake manually (0013 page 200).
If it is still not possible toapply the electric parking brake: 0007
Consult a qualified specialist workshop. 0007
Where necessar y,also safeguard the par kedve hicle against rolling away.
To release: 0007
Ifth e conditions for auto matic release are fulfilled and the electric parking brake is not released automaticall y,
re lease the electric parking brake manually (0013 page 200).
If it is still not possible torelease the electric parking brake: 0007
Do not continue driving under any circums tances. Consult a qualified specialist workshop. 494
Display messages and warning/indicator lamps

Display messages
Possible causes/consequences and 0050
0050Solutions 0007
Consult a qualified specialist workshop immediatel y.
Check brake pads See
Owner's Manual *T
he brake pads ha vereached thewe ar limit. 000A
WARNING Risk of accident due torestricted braking po wer
When the brake pads ha vereached their wear limit, the braking po wer may be restricted. 0007
Drive on carefully. 0007
Have the brake sy stem checked immediately at a qualified specialist workshop. 0007
Consult a qualified specialist workshop. Driving sy
stems Display messages
Possible causes/consequences and 0050 0050Solutions
Active Blind Spot Assist
not available when towing
a trailer See Owner's Man-
ual *W
hen you es tablish the electrical connection tothe trailer, Active Blind Spot Assi stis una vailable. 0007
Press the left-hand Touch Control and ackn owledge the display message.
Please reduce speed *Y
ou are driving toofast forth e selected vehicle le vel. 0007
In order toadjust theve hicle le vel,yo u must not drive at speeds greater than 60 km/h. 504
Display messages and warning/indicator lamps

Display messages
Possible causes/consequences and 0050
0050Solutions
Active Lane Keeping Assist
inoperative 0007
Consult a qualified specialist workshop. Fault Drive at max. 80
km/h
*A
IRMATIC is functioning only toa limited extent. The vehicle's handling characteristics may be af fected.
000E NO
TEThe tyres of the front axle or the front wings could be damaged bylarge steering mo vements 0007
Avoid large steering mo vements while driving and lis tenfo r scraping sounds. 0007
Ifyo u hear sc raping sounds, pull over and stop theve hicle safely, paying attention toroad and traf fic con‐
ditions, and set a higher vehicle le vel if possible. 0007
Drive in a manner appropriate forth e cur rent le vel, but do not exceed 80 km/h. 0007
Consult a qualified specialist workshop.
DY NA MIC BODY CONT ROL is malfunctioning. The vehicle's handling characteristics may be af fected. 0007
Do not drive at speeds grea terth an 80 km/h. 0007
Consult a qualified specialist workshop.
Blind Spot Assist not availa-
ble when towing a trailer
See Owner's Manual *W
hen you es tablish the electrical connection tothe trailer, Blind Spot Assist is una vailable. 0007
Press the left-hand Touch Control and ackn owledge the display message.
00CC *Y
ou ha vepulled away despite theve hicle le vel being too lo w. Displ
aymessa ges and warning/indicator lamps 509

Display messages
Possible causes/consequences and 0050
0050Solutions
Operation only possible in
transmission position P
00CA
Operation only possible in
transmission position N *
Ve hicles with manual transmission: you attem ptedto swivel the ball neck and the transmission is not in neutral
005C. 0007
Shift the transmission toneutral 005C.
00CA Check trailer hitch lock
(whi tedisplay message) *T
he trailer tow hit chis not operational when you are driving with a trailer. 0007
Stop theve hicle immediately, paying attention toroad and traf fic conditions, and switch off the engine. 0007
Uncouple the trailer and secure it against rolling away. 0007
Initiate a new swivelling procedure (0013 page 262). 0007
Ifth e ball neck is extended, press and hold the button on the boot lid until the ball neck engages beneath the
bumper. 0007
When the display message disappears, couple up the trailer and drive on. 000A
WARNING Risk of an accident if the ball neck is not loc ked
If th e ball neck is not in the loc ked position, the trailer may come loose. 0007
Pull over and stop theve hicle safely as soon as possible, paying attention toroad and traf fic conditions.
Do not continue driving under any circums tances. 536
Display messa ges and warning/indicator lamps

Display messages
Possible causes/consequences and 0050
0050Solutions 0007
Uncouple the trailer and secure it against rolling away. 0007
Initiate a new swivelling procedure and do not re-couple the trailer until the display message disappears. If
th e display message does not disappear, the trailer tow hit chis defective and the ball neck is not loc ked. 0007
Do not couple up the trailer. Drive on without the trailer. No tethere duced ground clearance due tothe
unlo cked ball nec k. 0007
Consult a qualified specialist workshop.
The trailer tow hit chis not operational when theve hicle is at a standstill. 0007
Uncouple the coupled trailer and secure it against rolling away. 0007
Initiate a new swivelling procedure (0013 page 262). 0007
Ifth e ball neck is retracted: press and hold the button on the boot lid until the ball neck engages vertically in
th e loc ked position and then engages beneath the bumper. 0007
Ifth e ball neck is extended: press and hold the button on the boot lid until the ball neck engages beneath the
bumper.
If th e display message does not disappear, the trailer tow hit chis defective and the ball coupling is not loc ked. 0007
Do not couple up the trailer. Drive on without the trailer. No tethere duced ground clearance due tothe
unlo cked ball nec k. 0007
Consult a qualified specialist workshop. Display messages and
warning/indicator lamps 537