MINI Clubman 2016 Owner's Manual

'

7.Turn the bulb holder counter-clockwise and
remove nonworking bulb.8.To insert the new bulb and install the tail
lamp, proceed in reverse order of removal.
Make sure that the bulb holder sits tight in
the tail lamp.
Central
brake
lamp
and
license
plate
lamp
Follow the general instructions on lights andbulbs, refer to page 215.
The lights feature LED technology. In the case
of a malfunction, contact a dealer

Vehicle
batteryMaintenance
The battery is maintenance-free.
The added amount of acid is sufficient for the
service life of the battery.
More information about the battery can be re~
quested from a dealer

Fuses
Safety
information WARNING
Incorrect and repaired fuses can overload
electrical lines and components. There is a risk of fire. Never attempt to repair a blown fuse.Do not replace a nonworking fuse with a sub~stitute of another color or amperage rating. '

Breakdown
assistanceVehicle
features
and
op

PreparationNOTE
In the case of body contact between the
two vehicles, a short circuit can occur during
jump-starting. There is a risk of property dam~ age. Make sure that no body contact occurs. '

3.Let both engines run for several minutes.4.Disconnect the jumper cables in the reverseorder.
Check the battery and recharge if needed.
Tow-starting
and
towing
Safety
information WARNING
Due to system limits, individual functions
can malfunction during tow-starting/towing
with the Intelligent Safety systems activated,
e.g., approach control warning with light brak~
ing function. There is a risk of an accident. Switch all Intelligent Safety systems off prior to
tow-starting/towing. '

Tow
truck
The vehicle should only be transported on a
loading platform.
NOTE
When lifting the vehicle by the tow fitting
or body and chassis parts; damage can occur on vehicle parts. There is a risk of property
damage. Lift vehicle using suitable means. '

NOTE
When lifting the vehicle by the tow fitting
or body and chassis parts; damage can occur on vehicle parts. There is a risk of property
damage. Lift vehicle using suitable means. '

Tow
fitting
General
information
The screw-in tow fitting should always be car~ ried in the vehicle.
The tow fitting can be screwed in at the front or rear of the vehicle.
The tow fitting and the onboard vehicle tool kit,
refer to page 214, are together in the cargo
area.
Use of the tow fitting:
'