checking oil Peugeot 307 SW Dag 2007.5 Owner's Manual

Page 128 of 199

113
CHECKS
CHECKING THE LEVELS
There are two marks on
the dipstick:

A = maximum
Never i ll past this mark.

B = minimum
To maintain the reliability of
engines and emission control
systems, the use of additives
in engine oil is prohibited.
Viscosity selection
In all cases, the oil selected must
meet the manufacturer's require-
ments.
Note: the coolant does not need to
be changed.
Dipstick Cooling system
Use the l uid recommended by the
manufacturer.
When the engine is warm, the tem-
perature of the coolant is controlled
by the engine fan. This fan can ope-
rate with the ignition off.

In the case of vehicles i tted with
a particle emission i lter, the fan
can operate after the vehicle has
stopped, even when the engine is
cold.
In addition, as the cooling system is
pressurised, wait for at least one hour
after the engine has stopped before
carrying out any work.
Slacken the cap by two turns to re-
lease the pressure to prevent any
risk of scalding. When the pressure
has dropped, remove the cap and
top up the level. Windscreen and headlamp
wash level
Diesel additive level (Diesel
with particle emission filter)
If the service warning light comes on,
accompanied by a message and an
audible signal, this indicates a low
diesel additive level.
This additive must be topped up.
Contact a PEUGEOT dealer as soon
as possible.
Brake fluid level
Oil level
Oil change
According to the information given in
the servicing booklet. The level should always be
above the MIN mark and clo-
se to the MAX mark. Power steering reservoir
Remove the style trim * (see § "Chan-
ging a bulb - Front lights").
Open the reservoir, with the engine
at ambient temperature. The level
should always be above the MIN.
mark and close to the MAX. mark.
For best quality cleaning
and for your safety, we
would advise that you use
products recommended by
PEUGEOT.
Replacement must be car-
ried out according to the
manufacturerw's servicing
schedule.
Use l uids recommended by
the manufacturer, which fuli l DOT4
standards.
Check the level regularly and
top up between changes.
The maximum consump-
tion is 0.5 l per 600 miles
(1 000 km).
Check the level with the vehicle level,
engine cold, using the oil level gauge
on the instrument panel or the dipstick.
* According to engine.