headlamp Peugeot 307 SW Dag 2007.5 Owner's Manual

76
VISIBILITY For vehicles i tted with halogen
bulbs, depending on the load in your
vehicle, adjusting the beam of your
headlamps is recommended.

0. 1 or 2 people in the front seats.

-. 3 people.

1. 5 or 7 people.

-. Intermediate setting.

2. 5 or 7 people + maximum
authorised load.

-. Intermediate setting.

3. Driver + maximum authorised
load.

Initial setting is position 0. On vehicles with xenon bulbs:

when stationary , the system auto-
matically corrects the height of the
beam, whatever the load of the vehi-
cle. The driver is then assured of hav-
ing optimum lighting and not causing
a nuisance to other road users.

In cases of malfunction ,
the service warning light
comes on on the instrument
panel, accompanied by an
audible signal and a mes-
sage on the multifunction display.
The system places your headlamps
to the low position.
Do not touch the xenon bulbs. Con-
tact a PEUGEOT dealer.
Daytime lights *
On vehicles which are equipped with
daytime lights, the dipped headlamps
come on when the vehicle is started.
* According to country.
The instruments and controls
(instrument panel, multifunc-
tion display, air conditioning
control panel, ...) are only lit
on switching to the automatic switch-
ing on of the lights mode or when the
lights are switched on manually. This warning light comes
on on the instrument panel.
MANUAL ADJUSTMENT OF
THE HEADLAMPS
AUTOMATIC HEADLAMP
ADJUSTMENT

76
VISIBILITY For vehicles i tted with halogen
bulbs, depending on the load in your
vehicle, adjusting the beam of your
headlamps is recommended.

0. 1 or 2 people in the front seats.

-. 3 people.

1. 5 or 7 people.

-. Intermediate setting.

2. 5 or 7 people + maximum
authorised load.

-. Intermediate setting.

3. Driver + maximum authorised
load.

Initial setting is position 0. On vehicles with xenon bulbs:

when stationary , the system auto-
matically corrects the height of the
beam, whatever the load of the vehi-
cle. The driver is then assured of hav-
ing optimum lighting and not causing
a nuisance to other road users.

In cases of malfunction ,
the service warning light
comes on on the instrument
panel, accompanied by an
audible signal and a mes-
sage on the multifunction display.
The system places your headlamps
to the low position.
Do not touch the xenon bulbs. Con-
tact a PEUGEOT dealer.
Daytime lights *
On vehicles which are equipped with
daytime lights, the dipped headlamps
come on when the vehicle is started.
* According to country.
The instruments and controls
(instrument panel, multifunc-
tion display, air conditioning
control panel, ...) are only lit
on switching to the automatic switch-
ing on of the lights mode or when the
lights are switched on manually. This warning light comes
on on the instrument panel.
MANUAL ADJUSTMENT OF
THE HEADLAMPS
AUTOMATIC HEADLAMP
ADJUSTMENT

77
VISIBILITY
Special position of the front
windscreen wiper
In the minute following switching off
of the ignition, any action on the stalk
positions the wipers in the centre of
the windscreen.
This action enables you to position
the wiper blades for winter parking,
cleaning or replacement (See sec-
tion "Practical information - Chang-
ing a wiper blade").
To park the wipers after this has been
done, switch on the ignition and op-
erate the stalk.
Windscreen and headlamp wash
Pull the windscreen wiper stalk to-
wards you. The windscreen wash
then the windscreen wipers operate
for a i xed period.
The headlamp wash is also activat-
ed, if the headlamps are on.
Automatic windscreen
wipers
In AUTO mode, the windscreen wip-
ers operate automatically and adapt
their speed to the intensity of the
rainfall .
Front windscreen wiper with
automatic wipe

2 Fast wipe (heavy rain).

1 Normal wipe (moderate rain).

I Intermittent wipe.

0 Off.

AUTO
 Automatic or single wipe
(press downwards).
In the I ntermittent position, the wiping
speed is in proportion to the speed of
the vehicle.
In AUTO mode, the wiping speed is
in proportion to the intensity of the
rainfall. The i rst press of the stalk
downwards activates the automatic
wipe.
Subsequent presses trigger a single
wipe.
WINDSCREEN WIPER
STALK
Front windscreen wiper with
intermittent wipe

2 Fast wipe (heavy rain).

1 Normal wipe (moderate rain).

I Intermittent wipe.

0 Off.

 Single wipe (press downwards).
In the I ntermittent position, the wip-
ing speed is in proportion to the ve-
hicle speed.

110
CHECKS

1. Power steering reservoir.

2. Windscreen/headlamp wash
reservoir.

3. Coolant reservoir.
4. Brake l uid reservoir.

5. Battery.

6. Fuse box.
7. Air i lter.

8. Dipstick.

9. Engine oil reservoir.
2 LITRE 16V PETROL ENGINE

111
CHECKS

1. Power steering reservoir.

2. Windscreen
/headlamp wash
reservoir.

3. Coolant
reservoir
.
4. Brake l uid
reservoir.

5. Battery
.

6. Fuse box.
7. Dipstick
.

8. Engine oil
reservoir.

9. Priming pump.
1.6 LITRE 16V TURBO DIESEL HDI ENGINE (90 BHP / 110 BHP)

112
CHECKS

1. Power steering reservoir.

2. Windscreen/headlamp wash
reservoir.

3. Coolant reservoir.
4. Brake l uid reservoir.

5. Battery.

6. Fuse box.

7. Air i lter.
8. Engine oil reservoir.

9. Dipstick.

10. Priming pump.

11. Degas screw.
2 LITRE 16V TURBO DIESEL HDI ENGINE (136 BHP)

113
CHECKS
CHECKING THE LEVELS
There are two marks on
the dipstick:

A = maximum
Never i ll past this mark.

B = minimum
To maintain the reliability of
engines and emission control
systems, the use of additives
in engine oil is prohibited.
Viscosity selection
In all cases, the oil selected must
meet the manufacturer's require-
ments.
Note: the coolant does not need to
be changed.
Dipstick Cooling system
Use the l uid recommended by the
manufacturer.
When the engine is warm, the tem-
perature of the coolant is controlled
by the engine fan. This fan can ope-
rate with the ignition off.

In the case of vehicles i tted with
a particle emission i lter, the fan
can operate after the vehicle has
stopped, even when the engine is
cold.
In addition, as the cooling system is
pressurised, wait for at least one hour
after the engine has stopped before
carrying out any work.
Slacken the cap by two turns to re-
lease the pressure to prevent any
risk of scalding. When the pressure
has dropped, remove the cap and
top up the level. Windscreen and headlamp
wash level
Diesel additive level (Diesel
with particle emission filter)
If the service warning light comes on,
accompanied by a message and an
audible signal, this indicates a low
diesel additive level.
This additive must be topped up.
Contact a PEUGEOT dealer as soon
as possible.
Brake fluid level
Oil level
Oil change
According to the information given in
the servicing booklet. The level should always be
above the MIN mark and clo-
se to the MAX mark. Power steering reservoir
Remove the style trim * (see § "Chan-
ging a bulb - Front lights").
Open the reservoir, with the engine
at ambient temperature. The level
should always be above the MIN.
mark and close to the MAX. mark.
For best quality cleaning
and for your safety, we
would advise that you use
products recommended by
PEUGEOT.
Replacement must be car-
ried out according to the
manufacturerw's servicing
schedule.
Use l uids recommended by
the manufacturer, which fuli l DOT4
standards.
Check the level regularly and
top up between changes.
The maximum consump-
tion is 0.5 l per 600 miles
(1 000 km).
Check the level with the vehicle level,
engine cold, using the oil level gauge
on the instrument panel or the dipstick.
* According to engine.

10
119
PRACTICAL INFORMATION
1. Dipped beam headlamps (H1-55 W or xenon bulb).

WARNING: RISK OF ELECTROCU-
TION
Xenon bulbs must be changed by a
PEUGEOT dealer.
2. Main beam headlamps (H7-55 W).

 Remove the protective cover cor-
responding to the faulty bulb.

 Disconnect the connector.

 Press the end of each securing
clip. Change the bulb.
When i tting the new bulb, ensure
that the direction notches are po-
sitioned correctly and the securing
clips are i xed properly.
 Reconnect the connector.

 Rei t the protective cover.
Front lights
In the engine compartment, on the
right-hand side, remove the style
trim * :
- press the centre of each plastic stud A ,
- remove each plastic stud,
- remove the style trim.
When you have i nished, do not for-
get to put everything back in place
correctly:
- position the style trim * ,
- rei t each plastic stud A by press-
ing on it. Handle the bulbs with a dry
cloth.
The headlamps are i tted
with polycarbonate glass
with a protective coating. Do not
clean them with a dry or abrasive
cloth, nor with a detergent or sol-
vent product.
Use a sponge and soapy water.
CHANGING A BULB
* According to engine.

10
120
PRACTICAL INFORMATION
3. Side lights (W 5 W).

 Remove the protective cover cor-
responding to the faulty bulb.

 Disconnect the connector.

 Remove the bulb and change it.
4. Direction indicators (PY 21 W amber).

 Turn the bulb holder a quarter of
a turn and remove it.

 Change the bulb.

Note : in certain climatic conditions
(low temperature, humidity), con-
densation inside the headlamp
glass is normal ; it disappears a few
minutes after the lights are switched
on. 5. Fog lamps (H11-55 W).
Contact a PEUGEOT dealer to have
these bulbs changed.

 Push the repeater forwards and
release it.

 Remove the repeater and change
it.
These can be obtained from a
PEUGEOT dealer.
Amber coloured bulbs, such
as the direction indicators,
must be replaced with bulbs
of identical specii cation and
colour.
Integrated direction indicator side
repeaters.