sat nav Peugeot 307 SW Dag 2007.5 Owner's Manual

36
MULTIFUNCTION DISPLAYS
Presentation
It displays the following information:
- the time,
- the date,
- the exterior temperature (this l ashes if there is a risk of ice),
- the accesses check (doors, boot, ...),
- the warning messages (e.g.: "Depollution system faulty") or
information messages (e.g.: "Au-
tomatic headlamp lighting acti-
vated"), displayed temporarily,
can be cleared by pressing the

"ESC" button,
- the trip computer (see corre- sponding section),
MONOCHROME DISPLAY C
(WITHOUT RD4 AUDIO EQUIPMENT)
There are three buttons and a navi-
gator to enable you to control the
screen:
- "MENU" to display the general
menu,
- "MODE" to change the perma-
nent application (trip computer,
date, ...),
- "ESC" to abandon the operation
in progress,
- Rotation of the navigator: move-
ment on the display or changing
of a setting,
- Press on the navigator: coni r-
mation of the selection. Press the
"MENU" button to access
the general menu:
- trip computer (see corresponding section),
- personalisation-coni guration.
Turn the navigator to select the menu
required, then coni rm by pressing
the navigator.
Once this menu has been selected,
you can access the following func-
tions:
- dei ne the vehicle parameters,
- display coni guration,
- selection of the language.
Parameter configuration General menu
"Personalisation-
Configuration" menu

10PRACTICAL INFORMATION
Special front windscreen
wiper position

 Within one minute of switching off
the ignition, operate the wipers
stalk to position the wiper blades
in the centre of the windscreen
(maintenance position).
Changing a wiper blade

 Lift the wiper arm, then unclip the
blade and remove it.

 Fit the new blade and push back
the arm.

Note: the shortest blade is i tted on
the vehicle's right-hand windscreen
wiper arm.

To return the windscreen wipers to
their normal position, switch on the
ignition and operate the wiper stalk.
BATTERY
To charge the battery using a
battery charger:
- Disconnect the battery starting
with the negative (-) terminal,
- Follow the instructions for use given by the battery charger man-
ufacturer,
- Check that the terminals and connectors are clean. If they are
covered with sulphate (white or
greenish deposit), disconnect
them and clean them,
- Reconnect starting with the nega- tive (-) terminal. Before disconnecting the
battery, you must wait for
2 minutes after switching off
the ignition.
Never disconnect a terminal when
the engine is running.
Never charge a battery without i rst
disconnecting the terminals.
Close the windows and the roof con-
cealing shutter before disconnecting
the battery. If the windows and the
shutter do not operate normally fol-
lowing reconnection of the battery,
they must be reinitialised (see sec-
tion "Reinitialisation of the electric
windows" and "Panoramic roof").
After every reconnection of the bat-
tery, switch on the ignition and wait
1 minute before starting to allow the
electronic systems to be initialised. If
slight difi culties are experienced af-
ter this, please contact a PEUGEOT
dealer.
Following disconnection of the bat-
tery, the remote control key and the
GPS satellite navigation system must
be reinitialised (see corresponding
section).

It is advisable to disconnect the
battery if the vehicle is not to be
used for a period of more than
one month.
To start the vehicle from
another battery:
- Connect the red cable to the posi-
tive (+) terminals of the two bat-
teries,
- Connect one end of the green or black cable to the negative (-) ter-
minal of the slave battery,
- Connect the other end of the green or black cable to an earth point on
the broken down vehicle as far as
possible from the battery,
- Operate the starter, let the engine run,
- Wait for the engine to return to idle, then disconnect the cables. The batteries contain harm-
ful substances such as sul-
phuric acid and lead. They
must be disposed of in ac-
cordance with regulations and must
never be discarded with household
waste.
Take used remote control and vehi-
cle batteries to an approved collec-
tion point.
CHANGING A WINDSCREEN
WIPER BLADE

142
S
O S
SOURCE
MODE BAND ESC
2
abc
5
jkl
8
tuv 3
def
6
mno
9
wxyz
1 4
ghi
7
pqrs
0 # MENU LIST
TA
PTY
DARK
2
1
5
3 4
89 10
15
11 17 18
12 16
14
7
6
13
01
1. Ejection of the CD.
2. Selection of the source: radio, Jukebox, CD, CD ch anger
and auxiliary (AUX, if activated on the Coniguratio n menu).
Long press: CD copy to hard disc.
3. Long press on the SOS button: emergency call.
4. Selection of the display on the screen from the mo des:
TRIP, TEL, NAV and AUDIO.
5. Modiication of the screen display.
Long press: reinitialisation of the RT4 GPS audio/ telephone.
6. On/Off and Volume adjustment.
7. Selection of the wavebands FM1, FM2, FMast, AM. 8.
TA (Trafic Announcement) function on/off.
Long press: access to the PTY (radio Programme TYp es)
mode.
9. Access to the "PEUGEOT" services menu.
10. Cancellation of the current operation.
Long press: return to the current application.
11. Automatic search for a lower/higher frequency.
Selection of the previous/next CD, MP3 or Jukebox track.
12. Displaying of the general menu.
13. Keypad for entering descriptions by successive pre sses.14.
Selection of the previous/next CD.
Selection of the previous/next MP3/Jukebox director y.
15. Audio option adjustments: front/rear, left/right b alance,
loudness, sound ambiences.
16. Selection and conirmation.
17. SIM card slot.
18. Displaying of the list of local radio stations, of the tracks on
the CD or of the MP3/Jukebox directories.
Long press: updating of the local radio stations.
FIRST STEPS